LAISHA
Open Laisha

Life Cycle Assessment Certified Professional Life Cycle Assessment: practice questions

Life Cycle Assessment Certified Professional (LCACP) · USA / international · American Center for Life Cycle Assessment

Original practice questions written to the published syllabus · not past papers
10worked here, free
101written to this exam in this subject
13syllabus units

About Life Cycle Assessment Certified Professional

Life Cycle Assessment Certified Professional (LCACP) is a specialist certification exam run by American Center for Life Cycle Assessment, for candidates in USA / international. Education and work-experience requirements plus an exam; recertification every three years. Exam length was not stated on the page read.

Source: aclca.org.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Life Cycle Assessment in Life Cycle Assessment Certified Professional

Practitioner depth across the whole manual: goal and scope requirements for comparative assertions, data quality and pedigree matrix, allocation and system expansion, attributional versus consequential modelling, LCIA method choice, uncertainty and Monte Carlo, critical review, EPDs and PCRs, and ethical reporting.

Quantifying the environmental impacts of a product from cradle to grave under ISO 14040 and 14044: goal and scope, inventory, impact assessment and interpretation, with the agricultural complications of multifunctionality, land use and biogenic carbon.

Our 101 Life Cycle Assessment Certified Professional questions in this subject: 15 easy, 67 medium, 19 hard, across 13 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to Life Cycle Assessment Certified Professional and are not shown on any other exam's page.

Question 1 · medium

ISO 14044 lists three bases for cut-off criteria for deciding which inputs to include. Which set is correct?

  1. Mass, energy and environmental significance
  2. Mass, cost and number of suppliers
  3. Energy, distance transported and shelf life
  4. Cost, data availability and reporting convenience
Answer and working

A. Mass, energy and environmental significance

The three named criteria are mass, energy and environmental significance. Using mass alone can wrongly drop inputs that are tiny in mass but large in impact, such as pesticide active ingredients or high-GWP refrigerants. Cost, distance, shelf life and convenience are not cut-off criteria in the standard.

Question 2 · medium

The pedigree matrix used to score LCI data quality assesses which set of indicators?

  1. Accuracy, precision, recall, specificity and statistical power of the measurement
  2. Reliability, completeness, temporal, geographical and further technological correlation
  3. Cost, timeliness, supplier reputation, audit status and certification of the data source
  4. Mass, energy, environmental significance, toxicity and price of the flow
Answer and working

B. Reliability, completeness, temporal, geographical and further technological correlation

The pedigree matrix (Weidema and Wesnæs) scores each datum from 1 (best) to 5 on reliability, completeness, temporal, geographical and further technological correlation; the scores are converted to additional uncertainty. The other sets mix statistical terms, procurement criteria and cut-off criteria.

Question 3 · hard

The three cultural perspectives of the ReCiPe method differ mainly in which respect?

  1. Time horizon and which uncertain effects are included in the models
  2. The country whose emissions inventory is used for normalisation only
  3. Whether characterisation is done at midpoint or endpoint level only
  4. The number of significant figures reported in the final results
Answer and working

A. Time horizon and which uncertain effects are included in the models

Individualist (short term, optimistic), hierarchist (consensus default) and egalitarian (long term, precautionary) perspectives use different time horizons and include or exclude uncertain effects. They are not about the normalisation country, the midpoint/endpoint split, or reporting precision.

Question 4 · medium

A farm emits 20 kg NH3 and 5 kg NOx (as NO2). Using acidification factors of 1.88 kg SO2-eq/kg for NH3 and 0.70 for NO2, what is the acidification result?

  1. 25.0 kg SO2-eq
  2. 41.1 kg SO2-eq
  3. 37.6 kg SO2-eq
  4. 17.8 kg SO2-eq
Answer and working

B. 41.1 kg SO2-eq

Result = 20 × 1.88 + 5 × 0.70 = 37.6 + 3.5 = 41.1 kg SO2-eq. Adding masses gives 25.0; NH3 alone gives 37.6; dividing by the factors gives 17.8.

Question 5 · medium

In water footprinting within LCA, impact assessment of water scarcity is based on which inventory quantity?

  1. Water withdrawal, the total volume taken from the source
  2. Water consumption, the water not returned to the same catchment
  3. Grey water, the volume needed to dilute pollutants to standards
  4. Green water, the rainfall stored in the soil and used by crops
Answer and working

B. Water consumption, the water not returned to the same catchment

Scarcity impact acts on consumption — water evaporated, incorporated or moved to another catchment — because returned water remains available. Withdrawal overstates the effect; grey and green water are volumetric concepts from water-resources footprinting rather than the basis of AWARE.

Question 6 · medium

A farmer applies 1000 kg of limestone (CaCO3). With the IPCC Tier 1 factor of 0.12 t C per t limestone, what CO2 is emitted?

  1. 120 kg CO2
  2. 477 kg CO2
  3. 440 kg CO2
  4. 33 kg CO2
Answer and working

C. 440 kg CO2

C = 1000 × 0.12 = 120 kg; CO2 = 120 × 44/12 = 440 kg. 120 is carbon only; 477 uses the dolomite factor (0.13); 33 inverts the ratio.

Question 7 · easy

In most LCAs of milk, which source usually makes the largest single contribution to the climate footprint at the farm gate?

  1. Electricity used for milking and milk cooling
  2. Enteric methane from the cows' rumen fermentation
  3. Diesel used to transport milk to the dairy
  4. Manufacture of plastic for silage wrap
Answer and working

B. Enteric methane from the cows' rumen fermentation

Enteric methane is the largest single source in most dairy footprints, followed by feed production and manure management; the exact shares vary by system. Electricity, milk transport and plastics are minor in most studies.

Question 8 · hard

Why is the 2006 IPCC Tier 1 direct N2O factor of 0.01 kg N2O-N per kg N a major source of uncertainty in crop LCAs?

  1. Tenfold uncertainty range; N2O dominates many footprints
  2. It is a measured value for one site, so it applies only to that site's soil
  3. It covers only manure and leaves synthetic fertiliser N without any factor
  4. It changes every year with the national inventory, so studies cannot repeat it
Answer and working

A. Tenfold uncertainty range; N2O dominates many footprints

The IPCC gives a wide range (0.003–0.03 in the 2006 Guidelines) around the default because emissions depend on soil, climate and management; since N2O is often the largest farm GHG for crops, this uncertainty propagates strongly. It is a global default, applies to synthetic and organic N, and does not change annually.

Question 9 · hard

Why does the PEF method use weighting to a single score although ISO 14044 bars weighting in public comparative assertions?

  1. PEF studies are never disclosed to the public, so the ISO rule does not apply
  2. ISO 14044 was amended to require weighting in every comparative study
  3. Weighting in PEF is applied only to climate change and so is not true weighting
  4. PEF is designed for comparability within product groups and fixes the weights in advance
Answer and working

D. PEF is designed for comparability within product groups and fixes the weights in advance

PEF deliberately standardises choices, including normalisation and weighting factors, to make products within a category comparable; this departs from ISO 14044's approach for public comparisons. PEF results can be published, ISO did not mandate weighting, and PEF weights span all 16 categories.

Question 10 · medium

Which LCA study does ISO 14044 require to undergo critical review by a panel of interested parties?

  1. A study supporting a comparative assertion disclosed to the public
  2. A screening study used only by the company's own design team
  3. A study of a single product communicated to one business customer
  4. A cradle-to-gate inventory used to update a background database
Answer and working

A. A study supporting a comparative assertion disclosed to the public

A public comparative assertion — a claim that a product is superior or equal to a competitor's — requires a panel review. Internal, single-product B2B and database studies may use lighter review or none.

A study plan for Life Cycle Assessment in Life Cycle Assessment Certified Professional

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (48% of the 101 questions): Agricultural LCA: field emissions models and databases (13, 13%); Social LCA and life cycle costing (10, 10%); Climate change, eutrophication, acidification, water and land-use categories (9, 9%); Allocation and system expansion for multifunctional processes (8, 8%); Attributional versus consequential LCA (8, 8%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Biogenic carbon and land-use change in LCA (8, 8%); Goal and scope: functional unit, system boundary, cut-off (8, 8%); Interpretation, sensitivity and uncertainty analysis (8, 8%); Life cycle impact assessment methods and midpoint and endpoint indicators (8, 8%); Carbon footprint of products (ISO 14067) and PEF (7, 7%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Life cycle inventory: foreground and background data (7, 7%); Environmental product declarations and critical review (6, 6%); Life cycle thinking and the ISO 14040/14044 framework (1, 1%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Leave time for the hard ones: Attributional versus consequential LCA (3 hard of 8), Environmental product declarations and critical review (2 hard of 6), Allocation and system expansion for multifunctional processes (2 hard of 8).

    Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.

  5. Bank the easy marks: Social LCA and life cycle costing (3 easy of 10); Attributional versus consequential LCA (2 easy of 8).

    Do these early in revision so they are fast on the day.

  6. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — Life Cycle Assessment Certified Professional Life Cycle Assessment

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.