LAISHA
Open Laisha

Silage heating after you open it? Here is why

Short · · 48 s

Once a silo is opened, air lets yeasts and moulds heat and waste the face. Remove at least about 15 cm from the whole face daily (more in warm weather), keep it smooth, size the next clamp narrower if needed, and never feed mouldy silage.

Silage and hay making →

Subscribe on YouTube

What is happening at the face

While a clamp stays sealed, its acidity and lack of oxygen keep yeasts and moulds dormant. Once the sheet is pulled back, air can travel a metre or more into loosely packed silage. Yeasts wake first, feeding on lactic acid and leftover sugars; as the acid is used up the pH climbs and moulds and other bacteria follow. Their respiration releases heat, carbon dioxide and water, and burns the most digestible part of the feed. Nutritionists call this aerobic instability. Maize, whole-crop cereal and drier grass silages are most prone, being rich in sugar or starch and harder to compact.

Checking your own clamp

A probe thermometer is the simplest tool. Push it 20 to 50 centimetres into the face at several points, especially near the top and the shoulders, and compare with air temperature. Silage running more than about 2 to 3 °C above ambient is heating; a reading that rises from one day to the next means spoilage is advancing faster than you are feeding. Other signs are steam on cold mornings, a sharp smell of vinegar, alcohol or nail-varnish remover, dry crumbly patches and white or blue-green growth. Hot spots well behind the face often mark places where packing was poor or the sheet was torn.

Matching the face to the herd

Calculate daily removal from your own figures. Divide the fresh weight fed each day by the density of the silage, often roughly 600 to 800 kilograms of fresh matter per cubic metre in a well-made clamp, then divide by the face area. Suppose 40 cows each eat 35 kilograms of fresh silage: that is 1,400 kilograms, or about 2 cubic metres at 700 kilograms per cubic metre. Across a face 6 metres wide and 2.5 metres high, 15 square metres, the face moves back only about 13 centimetres a day, too slow in warm weather, when many advisers aim for 25 to 30. A clamp half as wide would double the advance.

Smallholders using bags, drums or pits in places such as Kenya or Bangladesh can apply the same logic by filling several small units and opening one at a time, finishing each within a few days.

Habits that keep the face stable

Cut the face cleanly with a block cutter, shear grab or sharp spade rather than tearing at it with a bucket, which loosens silage behind the face and lets air in. Take from the full width, not a narrow slot. Fold the sheet back only as far as one or two days' needs and keep it weighted at the edge. Clear loose material from the floor daily. If heating keeps recurring, plan changes at the next harvest: thinner filling layers, heavier rolling, a faster fill, double sheeting and, where allowed, an additive intended for aerobic stability.

Spoiled silage and animal health

Throw away silage that is visibly mouldy, slimy or very hot, with a margin around it; do not dilute it into the ration. Moulds can produce mycotoxins, and spoiled, soil-contaminated silage with a raised pH is linked with listeriosis, which can cause circling, facial paralysis and abortion in sheep, goats and cattle. Heated silage is also less palatable, so intake and milk yield may fall before any mould is visible. If animals go off feed, show nervous signs or abort, call a veterinarian and keep a sample of what they were eating.

Sources: Wilkinson JM, Davies DR, The aerobic stability of silage: key findings and recent developments, Grass and Forage Science 68 (2013) · Borreani G, Tabacco E, Schmidt RJ, Holmes BJ, Muck RE, Silage review: Factors affecting dry matter and quality losses in silages, Journal of Dairy Science 101 (2018) · 't Mannetje L (ed.), Silage making in the tropics with particular emphasis on smallholders, FAO Plant Production and Protection Paper 161 (2000)

Transcript

Your silage looked perfect, then started heating and going mouldy after you opened it? Here is why.

Once a silo is opened, air gets into the face, and yeasts and moulds start to grow. They heat the silage and waste it. The fix is to keep ahead of the air.

Remove at least about fifteen centimetres from the whole face every day in cool weather, and more in warm weather. Keep the face clean and smooth.

If your herd cannot use that much, make the next clamp narrower, so the face is smaller.

And never feed mouldy silage: it can carry mycotoxins and cause disease.

The full silage guide is in our long video and at laisha.ai.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Go further with Laisha Smarter

US$10 a month · one price worldwide · cancel any time

  • Ask Laisha about what you watched — up to 1,000 questions a month
  • Your own crop calendar and pest alerts
  • Every calculator and tool
10 days free for every new account, no card.