JEE Advanced → IIT Kharagpur B.Tech Agricultural & Food Engineering · India · IITs (JoSAA counselling)
Original practice questions written to the published syllabus · not past papersJEE Advanced → IIT Kharagpur B.Tech Agricultural & Food Engineering is a university entrance exam run by IITs (JoSAA counselling), for candidates in India. JEE Main, then JEE Advanced, then JoSAA counselling.
Official site: krishijagran.com.
We have not been able to confirm these details against the exam body's own specification, so fees, dates and pass marks are left out on purpose. Check the current format, eligibility, fees and dates on the official site.
Circuits, power, transformers, electronic devices and safe wiring: what a farm engineer needs before motors and sensors.
Our 33 JEE Advanced → IIT Kharagpur B.Tech Agricultural & Food Engineering questions in this subject: 23 easy, 9 medium, 1 hard, across 10 units.
Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.
These 10 were written to JEE Advanced → IIT Kharagpur B.Tech Agricultural & Food Engineering and are not shown on any other exam's page.
Kirchhoff's current law, that the algebraic sum of currents at a node is zero, is a statement of which principle?
A. Conservation of electric charge
Charge cannot accumulate at a junction, so what flows in must flow out. Conservation of energy is the basis of Kirchhoff's voltage law, not the current law; Ohm's law relates V and I in one element only.
A simple timer charges a 47 µF capacitor through a 100 kΩ resistor from a DC supply. What is the time constant, and roughly what fraction of the supply voltage has the capacitor reached after one time constant?
A. 4.7 s, about 63 %
τ = RC = 100 × 10³ × 47 × 10⁻⁶ = 4.7 s. After one τ, V = V_s(1 − e⁻¹) = 63 % of V_s. 37 % is what remains to be charged (or the voltage left on a discharging capacitor). 0.0047 s comes from treating kΩ as Ω; 23.5 s is 5τ, when charging is practically complete.
A sinusoidal supply has a peak value of 325 V. What is its RMS value?
D. 230 V
V_rms = V_m/√2 = 325/1.414 = 230 V — the familiar 230 V supply. 207 V is the half-cycle average 2V_m/π; 460 V multiplies instead of dividing; 162 V halves the peak, which has no meaning for a sine wave.
What is the form factor (RMS value ÷ half-cycle average value) of a pure sine wave?
A. 1.111
Form factor = (V_m/√2)/(2V_m/π) = π/(2√2) = 1.11. 1.414 is the crest (peak) factor; 0.637 is average/peak; 0.707 is RMS/peak.
What is the reactance of a 100 µF capacitor at 50 Hz?
B. 31.8 Ω
X_C = 1/(2πfC) = 1/(2π × 50 × 100 × 10⁻⁶) = 31.8 Ω. 0.0314 Ω multiplies instead of dividing; 200 Ω omits 2π; 26.5 Ω is the value at 60 Hz.
Why must a transformer not be connected to a steady DC supply of its rated voltage?
D. Steady flux induces no back-EMF, so a large current overheats the primary
Transformer action needs changing flux. With steady DC there is no induced back-EMF, so the primary current is limited only by its small resistance and becomes very large, overheating the winding; the secondary sees no voltage once the current is steady. DC flows through copper easily, and it does not rotate the flux or alter the turns ratio.
Which impurity added to pure silicon produces n-type material?
C. Phosphorus, a pentavalent donor
Phosphorus has five valence electrons; four bond with silicon and the fifth is free, so electrons become the majority carriers (n-type). Boron and indium are trivalent acceptors that make p-type; germanium is a semiconductor in its own right and adds no carriers.
What happens to the depletion region of a p–n junction when it is reverse biased?
A. It widens and the barrier potential increases
Reverse bias pulls majority carriers away from the junction, widening the depletion region and raising the barrier so only a tiny leakage current flows until breakdown. Narrowing and heavy conduction describe forward bias.
An op-amp integrator is fed a constant positive DC input voltage. What does its output do?
D. It ramps linearly in the negative direction until it saturates
For the inverting integrator V_out = −(1/RC)∫V_in dt; a constant input gives a linear ramp, negative-going, until the output reaches the rail. A spike is the response of a differentiator to a step; an integrator does not oscillate on its own.
For which inputs is the output of a two-input XOR gate 1?
A. When the two inputs are different
XOR (exclusive OR) is 1 for inputs 01 and 10 only. 'At least one input is 1' describes OR, which also gives 1 for input 11.
This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.
Read the manual chapters for these first and do every worked question you can find on them.
Aim for one sitting per unit, then mixed questions across them.
Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.
Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.
Do these early in revision so they are fast on the day.
Last updated · How Laisha writes and checks its pages · Report a mistake
US$10 a month · one price worldwide · cancel any time
| Free | Smarter | |
|---|---|---|
| Grow guides, pest pages, articles | Read all | Read all |
| Ask Laisha | 5 a day | Up to 1,000 a month |
| Exam practice | The sample on each page | Every question, timed papers |
| Crop calendar and pest alerts | — | For your own fields |
| Calculators and tools | — | All |
| Uploads and reports | — | 100 a month, real files |
An AI operating system for agriculture: free guides, manuals and tools written for every country.