LAISHA
Open Laisha

CUET-PG Environmental Chemistry: practice questions

CUET-PG — Environmental Sciences · India · National Testing Agency

Original practice questions written to the published syllabus · not past papers
10worked here, free
36written to this exam in this subject
13syllabus units

About CUET-PG

CUET-PG — Environmental Sciences is a postgraduate admission exam run by National Testing Agency, for candidates in India. Computer-based MCQ test for MSc admission to central and participating universities; pattern set in each year's bulletin.

Official site: exams.nta.ac.in.

We have not been able to confirm these details against the exam body's own specification, so fees, dates and pass marks are left out on purpose. Check the current format, eligibility, fees and dates on the official site.

Environmental Chemistry in CUET-PG

Carbonate chemistry and ocean acidification, atmospheric composition and ozone chemistry, and basic equilibrium and redox principles.

The chemistry of water, soil and air that pollution, treatment and climate subjects assume: equilibria, the carbonate system, redox, gas solubility, ozone and smog chemistry. GATE ES Section 2 in full.

Our 36 CUET-PG questions in this subject: 16 easy, 20 medium, 0 hard, across 13 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to CUET-PG and are not shown on any other exam's page.

Question 1 · easy

A water sample contains 40 mg/L of calcium (Ca²⁺, atomic mass 40). What is this expressed as mg/L as CaCO3?

  1. 40 mg/L as CaCO3
  2. 100 mg/L as CaCO3
  3. 200 mg/L as CaCO3
  4. 50 mg/L as CaCO3
Answer and working

B. 100 mg/L as CaCO3

Equivalent weight of Ca²⁺ = 40/2 = 20; mg/L as CaCO3 = 40 × 50/20 = 100. 40 forgets conversion; 50 uses the CaCO3 equivalent weight alone; 200 uses the molar mass of CaCO3 over 20.

Question 2 · medium

Why should the sum of cation milliequivalents be close to the sum of anion milliequivalents in a water analysis?

  1. Cations and anions always have the same molar mass in natural waters
  2. Solutions are electrically neutral, so a large imbalance flags error
  3. Milliequivalents are defined so that every sample sums to exactly 100
  4. Anions are always twice as concentrated as cations in fresh water
Answer and working

B. Solutions are electrically neutral, so a large imbalance flags error

Electroneutrality requires equal charge equivalents; an ion balance check detects errors or unmeasured species.

Question 3 · medium

What is the equivalent weight of sulphate (SO4²⁻, molar mass 96)?

  1. 32
  2. 192
  3. 48
  4. 96
Answer and working

C. 48

Equivalent weight = molar mass ÷ charge = 96/2 = 48.

Question 4 · medium

For a first-order reaction, how does the half-life depend on the initial concentration?

  1. It halves when the initial concentration doubles
  2. It doubles when the initial concentration doubles
  3. It is proportional to the square of the initial concentration
  4. It is independent of the initial concentration
Answer and working

D. It is independent of the initial concentration

For first order, t½ = 0.693/k. Zero-order half-lives increase with C0; second-order half-lives decrease with C0.

Question 5 · easy

A water is described as 'very hard' when its hardness exceeds about

  1. 30 mg/L as CaCO3
  2. 3 mg/L as CaCO3
  3. 300 mg/L as CaCO3
  4. 3000 mg/L as CaCO3
Answer and working

C. 300 mg/L as CaCO3

Common classes: soft < 75, moderately hard 75–150, hard 150–300, very hard > 300 mg/L as CaCO3.

Question 6 · medium

What happens to limestone when water rich in dissolved CO2 percolates through it?

  1. It precipitates more calcite, sealing the rock
  2. It dissolves as calcium bicarbonate, increasing hardness
  3. It is converted to gypsum by the CO2
  4. It releases sulphate that acidifies the water
Answer and working

B. It dissolves as calcium bicarbonate, increasing hardness

CaCO3 + CO2 + H2O → Ca²⁺ + 2HCO3⁻; this forms caves and hard groundwater.

Question 7 · medium

Adding sodium fluoride to a saturated solution of CaF2 reduces the solubility of CaF2. This is the

  1. chelate effect
  2. Tyndall effect
  3. salting-in effect
  4. common-ion effect
Answer and working

D. common-ion effect

Adding an ion already present shifts the equilibrium towards the solid, lowering solubility.

Question 8 · medium

On a pe–pH diagram for iron, which form is stable under oxidising, near-neutral conditions?

  1. Insoluble ferric oxyhydroxides
  2. Metallic iron
  3. Dissolved Fe³⁺ ions at high concentration
  4. Dissolved Fe²⁺ ions
Answer and working

A. Insoluble ferric oxyhydroxides

Oxidising, neutral conditions favour Fe(III) solids; reducing or acidic conditions favour soluble Fe²⁺.

Question 9 · medium

A BOD/COD ratio of 0.6 for an industrial effluent suggests that it is

  1. readily biodegradable
  2. free of organic matter
  3. dominated by heavy metals
  4. largely non-biodegradable
Answer and working

A. readily biodegradable

Ratios above about 0.5 indicate easily biodegradable organics; low ratios indicate recalcitrant or toxic wastes.

Question 10 · easy

The SI unit of radioactivity, equal to one disintegration per second, is the

  1. gray (Gy)
  2. curie (Ci)
  3. becquerel, Bq
  4. sievert (Sv)
Answer and working

C. becquerel, Bq

The becquerel measures activity; gray absorbed dose; sievert effective dose; the curie is an older unit of activity (3.7 × 10¹⁰ Bq).

A study plan for Environmental Chemistry in CUET-PG

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (50% of the 36 questions): Chemical bonding, concentration units, activity and ionic strength (5, 14%); Acid-base equilibria, buffers and alkalinity (4, 11%); Chemical equilibrium, thermodynamics and reaction kinetics (3, 8%); Complexation, precipitation and solubility product (3, 8%); Radioactivity and radionuclides in the environment (3, 8%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Redox reactions, pe-pH diagrams and redox zonation (3, 8%); Solubility of gases in water: Henry's law (3, 8%); The carbonate system and ocean acidification (3, 8%); Water quality parameters and their measurement (3, 8%); Composition and structure of the atmosphere (2, 6%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Speciation of inorganic and organic contaminants (2, 6%); Stratospheric ozone chemistry and ozone-depleting substances (1, 3%); Tropospheric ozone and photochemical smog (1, 3%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Bank the easy marks: Stratospheric ozone chemistry and ozone-depleting substances (1 easy of 1); Tropospheric ozone and photochemical smog (1 easy of 1).

    Do these early in revision so they are fast on the day.

  5. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — CUET-PG Environmental Chemistry

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.