LAISHA
Open Laisha

ICAR AIEEA Diagnostic Imaging: Radiology and Ultrasonography: practice questions

ICAR AIEEA (PG): Master's entrance, Veterinary Science and Animal Sciences · India · NTA for ICAR

Original practice questions written to the published syllabus · not past papers
10worked here, free
34written to this exam in this subject
9syllabus units

About ICAR AIEEA

ICAR AIEEA (PG): Master's entrance, Veterinary Science and Animal Sciences is a postgraduate admission exam run by NTA for ICAR, for candidates in India. Computer-based, 120 MCQs in 120 minutes, +4 for correct and -1 for wrong, maximum 480. English only.

Source: icar.org.in.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Diagnostic Imaging: Radiology and Ultrasonography in ICAR AIEEA

One-line recall: X-ray tube parts and target material, kVp versus mAs, heel effect, inverse square law, grids, film processing chemicals, radiographic opacities, dose units and limits, contrast media and their contraindications, ultrasound frequencies and artefacts, and pregnancy diagnosis timings in cattle and mares.

X-ray physics and radiation safety, positioning and interpretation, contrast studies, ultrasonography (including reproductive), endoscopy and the basics of CT and MRI.

Our 34 ICAR AIEEA questions in this subject: 18 easy, 14 medium, 2 hard, across 9 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to ICAR AIEEA and are not shown on any other exam's page.

Question 1 · easy

Which exposure factor mainly controls the penetrating power (quality) of the X-ray beam and therefore radiographic contrast?

  1. The milliampere-seconds (mAs) selected on the panel
  2. The focal spot size chosen, fine or broad focus
  3. The exposure time alone, independent of tube current
  4. The kilovoltage peak (kVp) applied across the tube
Answer and working

D. The kilovoltage peak (kVp) applied across the tube

kVp sets photon energy, so it controls penetration and contrast. mAs controls the number of photons (quantity, density); time is one component of mAs; focal spot size affects sharpness, not beam quality.

Question 2 · medium

The line focus principle in X-ray tube design achieves which of the following?

  1. A small effective focal spot while a larger actual area of target absorbs the heat
  2. A uniform beam intensity across the whole field by removing the heel effect entirely
  3. A higher proportion of characteristic radiation relative to bremsstrahlung
  4. A larger effective focal spot so that exposure times can be made shorter for moving patients
Answer and working

A. A small effective focal spot while a larger actual area of target absorbs the heat

Angling the target makes the area struck by electrons long and narrow (good for heat) but, viewed from the patient, the effective spot is small (good for sharpness). The angled target actually causes the heel effect rather than removing it, and it does not change the characteristic/bremsstrahlung ratio.

Question 3 · medium

A radiograph is made at 200 mA with an exposure time of 0.05 s. What is the mAs?

  1. 4 mAs
  2. 40 mAs
  3. 10 mAs
  4. 100 mAs
Answer and working

C. 10 mAs

mAs = mA × time in seconds = 200 × 0.05 = 10 mAs. 40 comes from dividing 200 by 5; 4 from 200 × 0.02; 100 from forgetting the decimal (200 × 0.5).

Question 4 · medium

Using the 15% rule, a thorax exposure of 70 kVp and 20 mAs is changed to about 80 kVp to shorten the exposure. What mAs gives approximately the same film density?

  1. 20 mAs
  2. 10 mAs
  3. 17 mAs
  4. 40 mAs
Answer and working

B. 10 mAs

70 × 1.15 ≈ 80.5 kVp, so a 15% increase in kVp is roughly equivalent to doubling mAs. To keep density the same, halve mAs: 20 / 2 = 10 mAs. 40 mAs doubles instead of halving and would over-expose badly; 17 mAs cuts mAs by only 15% (20 / 1.15).

Question 5 · hard

A focused grid has lead strips 2.4 mm high separated by radiolucent spaces 0.3 mm wide. What is its grid ratio?

  1. 0.125:1
  2. 12:1
  3. 8:1
  4. 2.7:1
Answer and working

C. 8:1

Grid ratio = height of strips / width of the interspace = 2.4 / 0.3 = 8, so 8:1. 0.125 inverts the fraction; 2.7 adds the two dimensions. Higher ratios clean up more scatter but need more exposure.

Question 6 · easy

What is the SI unit of absorbed radiation dose?

  1. The gray (Gy), equal to one joule per kilogram
  2. The sievert (Sv), equal to one joule per kilogram weighted
  3. The becquerel (Bq), equal to one decay per second
  4. The roentgen (R), equal to one joule per kilogram of air
Answer and working

A. The gray (Gy), equal to one joule per kilogram

Absorbed dose is measured in grays (1 Gy = 1 J/kg). The sievert is for equivalent and effective dose; the becquerel measures radioactivity; the roentgen is an old unit of exposure (ionisation in air), not absorbed dose.

Question 7 · easy

The three basic physical methods of reducing occupational radiation exposure are:

  1. Distance, speed and collimation
  2. Time, distance and shielding
  3. Time, voltage and filtration
  4. Shielding, film speed and processing
Answer and working

B. Time, distance and shielding

Minimise time (and repeat exposures), maximise distance (inverse square law) and use shielding. Collimation and filtration also help, but the classic triad is time, distance and shielding.

Question 8 · medium

Radiation-induced cancer is an example of which type of effect?

  1. A deterministic effect: it appears only after a single high acute whole-body dose
  2. A deterministic effect: its severity rises with dose above a known dose threshold
  3. A stochastic effect: probability rises with dose and no safe threshold is assumed
  4. A stochastic effect: severity rises with dose above a known threshold
Answer and working

C. A stochastic effect: probability rises with dose and no safe threshold is assumed

Cancer and heritable effects are stochastic: the chance of the effect rises with dose, not its severity, and no threshold is assumed. Deterministic effects such as erythema and cataract have thresholds and their severity increases with dose.

Question 9 · easy

Border effacement (the silhouette sign) occurs when:

  1. A gas-filled structure lies next to bone
  2. Two structures of the same opacity are in contact
  3. Two structures of different opacity overlap
  4. A metal implant lies within soft tissue
Answer and working

B. Two structures of the same opacity are in contact

A border is only visible where opacities differ. When two soft-tissue or fluid structures touch, their shared border disappears, as when pleural fluid effaces the heart.

Question 10 · medium

A double-contrast cystogram uses:

  1. Intravenous contrast followed by retrograde contrast into the urethra
  2. Barium sulphate in the bladder with iodinated contrast given orally
  3. A small volume of positive contrast plus gas distension of the bladder
  4. Both an ionic and a non-ionic iodinated agent given one after another
Answer and working

C. A small volume of positive contrast plus gas distension of the bladder

Double contrast combines a small amount of positive medium to coat the mucosa and gas to distend the lumen, showing mucosal lesions, filling defects and calculi well.

A study plan for Diagnostic Imaging: Radiology and Ultrasonography in ICAR AIEEA

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (50% of the 34 questions): X-ray physics (8, 24%); Radiation safety (5, 15%); Contrast studies (4, 12%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Radiographic interpretation by body system (4, 12%); Reproductive ultrasonography (4, 12%); Radiographic positioning (3, 9%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Ultrasonography (3, 9%); CT and MRI basics (2, 6%); Endoscopy (1, 3%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Leave time for the hard ones: Radiographic positioning (1 hard of 3), X-ray physics (1 hard of 8).

    Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.

  5. Bank the easy marks: CT and MRI basics (2 easy of 2); Endoscopy (1 easy of 1).

    Do these early in revision so they are fast on the day.

  6. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — ICAR AIEEA Diagnostic Imaging: Radiology and Ultrasonography

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.