LAISHA
Open Laisha

Engineers Canada Agricultural / Biosystems / Bioresource / Food Engineering examination syllabus Aquacultural & Forest Engineering (regional): practice questions

Engineers Canada Agricultural / Biosystems / Bioresource / Food Engineering examination syllabus · Canada · Provincial and territorial regulators (syllabus by Engineers Canada)

Original practice questions written to the published syllabus · not past papers
10worked here, free
60written to this exam in this subject
4syllabus units

About Engineers Canada Agricultural / Biosystems / Bioresource / Food Engineering examination syllabus

Engineers Canada Agricultural / Biosystems / Bioresource / Food Engineering examination syllabus is a licensing and registration exam run by Provincial and territorial regulators (syllabus by Engineers Canada), for candidates in Canada. Written confirmatory exams for graduates of non-CEAB programmes, assigned case by case.

Source: engineerscanada.ca.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Aquacultural & Forest Engineering (regional) in Engineers Canada Agricultural / Biosystems / Bioresource / Food Engineering examination syllabus

Fish-pond and recirculating-system design, and forest roads and logging machinery — examined where the law puts them in the profession's scope, as in the Philippines.

Our 60 Engineers Canada Agricultural / Biosystems / Bioresource / Food Engineering examination syllabus questions in this subject: 16 easy, 29 medium, 15 hard, across 4 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to Engineers Canada Agricultural / Biosystems / Bioresource / Food Engineering examination syllabus and are not shown on any other exam's page.

Question 1 · easy

On a pond farm, why is each pond normally given its own inlet from a supply canal and its own outlet to a separate drainage canal?

  1. So that water can flow through all ponds in series and be reused before discharge
  2. So that wind blowing along the supply canal aerates the water before it enters
  3. So that the total length of dikes on the farm is reduced to the smallest value
  4. So that each pond is filled and drained alone, with no pond-to-pond flow
Answer and working

D. So that each pond is filled and drained alone, with no pond-to-pond flow

Independent supply and drainage limit disease spread and let each pond be managed separately. Series flow does the opposite, and the arrangement adds rather than saves dike length.

Question 2 · medium

A pond receives a steady ammonia-nitrogen load of 5 kg/day that is removed only by flushing with ammonia-free water. What flushing flow keeps the pond at 1 mg/L at steady state?

  1. 50,000 m³/day
  2. 5,000 m³/day
  3. 500 m³/day
  4. 5 m³/day
Answer and working

B. 5,000 m³/day

At steady state C = Cin + P/Q, so Q = P/C = 5,000,000 mg/day ÷ 1 mg/L = 5,000,000 L/day = 5,000 m³/day. The others are factor-of-ten unit slips. 50,000 and 500 m³/day are factor-of-ten slips; 5 m³/day is a factor-of-1,000 slip (litres read as cubic metres).

Question 3 · medium

The hydraulic retention time of a 12,000 m³ pond receiving a continuous flow of 600 m³/day is

  1. 0.05 days
  2. 20 days
  3. 200 days
  4. 2 days
Answer and working

B. 20 days

Retention time = V/Q = 12,000/600 = 20 days. 0.05 is Q/V, the flushing rate per day; 2 and 200 are factor-of-ten slips.

Question 4 · easy

In a fertilised fish pond on a sunny day, when is dissolved oxygen lowest?

  1. In mid-afternoon, when water temperature reaches its daily peak
  2. At noon, when photosynthesis by phytoplankton is at its maximum
  3. At dusk, immediately after the phytoplankton stop photosynthesis
  4. Around dawn, after a night of respiration without photosynthesis
Answer and working

D. Around dawn, after a night of respiration without photosynthesis

Photosynthesis raises DO through the day; all organisms respire through the night, so DO bottoms out near dawn. Afternoon DO is often above saturation.

Question 5 · easy

Standard conditions for rating a pond aerator's oxygen transfer are

  1. clean fresh water at 20 °C, zero dissolved oxygen and standard pressure
  2. pond water at 30 °C, dissolved oxygen at 2 mg/L and local pressure
  3. clean fresh water at 0 °C, saturated dissolved oxygen and 2 atm pressure
  4. seawater at 25 °C, saturated dissolved oxygen and standard pressure
Answer and working

A. clean fresh water at 20 °C, zero dissolved oxygen and standard pressure

SOTR and SAE are defined for clean fresh water at 20 °C, zero DO and one standard atmosphere, so that aerators can be compared. Field conditions are corrected for afterwards.

Question 6 · medium

Which aerator both transfers oxygen efficiently and drives a strong horizontal circulating current, and is widely used in commercial ponds?

  1. The paddlewheel aerator
  2. The oxygen cone
  3. The gravity cascade aerator
  4. The diffused-air grid
Answer and working

A. The paddlewheel aerator

Paddlewheels splash water and push it around the pond. Diffusers in shallow ponds are inefficient; cascades need available head; oxygen cones serve tanks and raceways.

Question 7 · medium

Pond water has total ammonia nitrogen of 2.0 mg/L at pH 8.5. Taking pKa = 9.25 for the pond temperature, what is the un-ionised ammonia nitrogen concentration?

  1. 0.36 mg/L
  2. 1.00 mg/L
  3. 0.30 mg/L
  4. 1.70 mg/L
Answer and working

C. 0.30 mg/L

f = 1/(1 + 10^(9.25 − 8.5)) = 1/(1 + 5.62) = 0.151; NH3-N = 2.0 × 0.151 = 0.30 mg/L. 0.36 uses 10^(−0.75) as the fraction; 1.70 is the ionised part; 1.00 is the answer only at pH = pKa.

Question 8 · hard

A farm manager plans to run all aerators from 10 p.m. to 6 a.m. every night, whatever the DO. A more energy-efficient strategy is to

  1. run aerators only during the afternoon when the water is warmest and fish feed most
  2. start aerators when projected DO nears the critical level and stop after sunrise
  3. run aerators only at midday, when transfer efficiency is highest because of sunlight
  4. replace aeration with daily water exchange so that no electrical energy is needed
Answer and working

B. start aerators when projected DO nears the critical level and stop after sunrise

Aerators transfer most per kWh when DO is low, so starting them on a projected DO threshold saves energy. Afternoon and midday runs transfer little; exchange also uses energy and does not supply oxygen reliably at night.

Question 9 · medium

A RAS is fed 100 kg/day of feed with 40 percent protein. Using P_TAN = F × PC × 0.092, what is the daily TAN production?

  1. 6.40 kg
  2. 9.20 kg
  3. 3.68 kg
  4. 36.8 kg
Answer and working

C. 3.68 kg

P_TAN = 100 × 0.40 × 0.092 = 3.68 kg/day. 9.20 omits protein content; 6.40 is total nitrogen in the feed (protein × 0.16); 36.8 is a decimal slip.

Question 10 · easy

In a moving-bed bioreactor (MBBR), the nitrifying bacteria grow on

  1. the walls of the fish tank, cleaned once a week by brushing
  2. a fixed bed of gravel through which water is pumped upward
  3. plastic carriers kept in suspension and circulation in the reactor
  4. fine sand fluidised by an upflow of water in a column
Answer and working

C. plastic carriers kept in suspension and circulation in the reactor

MBBR carriers move freely in an aerated or mixed tank. Fixed gravel beds, tank walls and fluidised sand are other biofilm arrangements.

A study plan for Aquacultural & Forest Engineering (regional) in Engineers Canada Agricultural / Biosystems / Bioresource / Food Engineering examination syllabus

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (57% of the 60 questions): Aeration of ponds (18, 30%); Aquaculture pond design (16, 27%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Recirculating aquaculture systems (14, 23%); Water exchange in ponds (12, 20%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Leave time for the hard ones: Recirculating aquaculture systems (4 hard of 14), Aeration of ponds (5 hard of 18), Water exchange in ponds (3 hard of 12).

    Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.

  4. Bank the easy marks: Aquaculture pond design (5 easy of 16); Aeration of ponds (5 easy of 18).

    Do these early in revision so they are fast on the day.

  5. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — Engineers Canada Agricultural / Biosystems / Bioresource / Food Engineering examination sy

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.