Engineers Canada Agricultural / Biosystems / Bioresource / Food Engineering examination syllabus · Canada · Provincial and territorial regulators (syllabus by Engineers Canada)
Original practice questions written to the published syllabus · not past papersEngineers Canada Agricultural / Biosystems / Bioresource / Food Engineering examination syllabus is a licensing and registration exam run by Provincial and territorial regulators (syllabus by Engineers Canada), for candidates in Canada. Written confirmatory exams for graduates of non-CEAB programmes, assigned case by case.
Source: engineerscanada.ca.
Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.
Soil as an engineering material: its phases, flow of water through it, compaction, consolidation, shear strength and stability.
Our 26 Engineers Canada Agricultural / Biosystems / Bioresource / Food Engineering examination syllabus questions in this subject: 13 easy, 11 medium, 2 hard, across 9 units.
Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.
These 10 were written to Engineers Canada Agricultural / Biosystems / Bioresource / Food Engineering examination syllabus and are not shown on any other exam's page.
A sand with 3% fines has D10 = 0.12 mm, D30 = 0.35 mm and D60 = 0.90 mm. What is its group symbol under the USCS (or IS 1498)?
D. SW
Cu = D60/D10 = 0.90/0.12 = 7.5 (≥ 6) and Cc = D30²/(D10·D60) = 0.35²/(0.12 × 0.90) = 1.13 (between 1 and 3), so the sand is well graded. With fines under 5% no dual symbol is needed, so SW. A dual symbol such as SW-SM applies only for 5–12% fines.
A clay has a liquid limit of 52%, a plastic limit of 24% and a natural water content of 31%. What is its liquidity index?
C. 0.25
Ip = 52 − 24 = 28. IL = (w − wP)/Ip = (31 − 24)/28 = 0.25; the clay is stiff, near its plastic limit. 0.75 is the consistency index Ic = (wL − w)/Ip, which equals 1 − IL. 0.60 is w/wL (31/52) and 1.29 is w/wP (31/24).
A sand has 9% fines, Cu = 7 and Cc = 1.8. The fines plot above the A-line. What is its USCS group symbol?
A. SW-SC
Fines between 5 and 12% require a dual symbol. Cu ≥ 6 and 1 ≤ Cc ≤ 3 make it well graded (SW); clayey fines above the A-line add SC. SC alone needs more than 12% fines; SP would need the grading tests to fail.
A permeability test at 30 °C gives k = 3.0 × 10⁻⁵ m/s. The viscosity of water is 0.798 mPa·s at 30 °C and 1.002 mPa·s at 20 °C. Ignoring the small change in unit weight, what is k corrected to 20 °C?
C. 2.39e-05 m/s
k is proportional to γw/μ, so k20 = k30 × μ30/μ20 = 3.0 × 10⁻⁵ × 0.798/1.002 = 2.39e-05 m/s. Water is more viscous at 20 °C, so the corrected k must be lower; the inverted ratio gives the wrong direction (3.77e-05).
Which laboratory test is appropriate for measuring the permeability of a silty clay?
C. Falling-head test
In fine-grained soils so little water passes that a constant-head test cannot measure the flow accurately; the falling-head test measures the fall in a narrow standpipe instead. The constant-head test suits sands and gravels.
Taking the surface tension of water as 0.073 N/m, a contact angle of zero and γw = 9.81 kN/m³, what is the capillary rise in a clean glass tube of diameter 0.05 mm?
D. 0.60 m
hc = 4T cosα/(γw d) = 4 × 0.073/(9810 × 5 × 10⁻⁵) = 0.60 m (about 0.03/d with d in mm). Using 2T/(γw d), which is the formula with radius, but inserting the diameter, gives half the answer (0.30 m). 6.0 m and 0.060 m are decimal slips in converting 0.05 mm to metres (5 × 10⁻⁶ and 5 × 10⁻⁴ m).
The water table is 2 m below ground in a silty clay that is fully saturated by capillarity up to the surface, with γsat = 19 kN/m³. With γw = 9.81 kN/m³, what is the vertical effective stress at 1 m depth?
D. 28.81 kPa
σ = 19 × 1 = 19 kPa. The point is 1 m above the water table, so u = −9.81 × 1 = −9.81 kPa (suction). σ′ = σ − u = 19 + 9.81 = 28.81 kPa. Treating the pore pressure as positive gives 9.19 kPa; ignoring it gives 19 kPa. Capillary suction increases effective stress. −0.62 kPa takes u as a positive 9.81 × 2 = 19.62 kPa from the full depth to the water table.
According to Terzaghi's principle, which quantity controls the shear strength and volume change of a saturated soil?
A. Effective stress (σ − u)
Only the stress carried by the grain skeleton, σ′ = σ − u, changes volume or strength. A rise in total stress carried entirely by the pore water produces no immediate change in either.
For a soil with φ′ = 30°, at what angle to the major principal plane does the failure plane lie according to the Mohr-Coulomb criterion?
B. 60°
The failure plane is inclined at 45° + φ′/2 = 60° to the major principal plane. 45° is the plane of maximum shear stress, which is not the failure plane when φ′ > 0 because the normal stress on it is also higher. 30° is φ′ itself, and 75° adds φ′ instead of φ′/2 (45° + 30°).
A sample of moist soil has a bulk density of 1.90 g/cm³ and a water content of 20%. The specific gravity of solids is 2.70. What is its void ratio?
A. 0.705
ρd = ρ/(1 + w) = 1.90/1.20 = 1.5833 g/cm³. e = Gρw/ρd − 1 = 2.70/1.5833 − 1 = 0.705. Using bulk density gives 0.421; wG = 0.540 is the void ratio only if the soil is saturated, which it is not here; 0.414 is the porosity e/(1 + e) = 0.705/1.705.
This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.
Read the manual chapters for these first and do every worked question you can find on them.
Aim for one sitting per unit, then mixed questions across them.
Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.
Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.
Do these early in revision so they are fast on the day.
Last updated · How Laisha writes and checks its pages · Report a mistake
US$10 a month · one price worldwide · cancel any time
| Free | Smarter | |
|---|---|---|
| Grow guides, pest pages, articles | Read all | Read all |
| Ask Laisha | 5 a day | Up to 1,000 a month |
| Exam practice | The sample on each page | Every question, timed papers |
| Crop calendar and pest alerts | — | For your own fields |
| Calculators and tools | — | All |
| Uploads and reports | — | 100 a month, real files |
An AI operating system for agriculture: free guides, manuals and tools written for every country.