GATE XL Fluid Flow, Thermodynamics & Heat Transfer in Dairy Plants: practice questions
GATE — Life Sciences (XL) with Section U Food Technology · India · IITs and IISc on rotation (2027: IIT Madras)
Original practice questions written to the published syllabus · not past papers
10worked here, free
49written to this exam in this subject
11syllabus units
About GATE XL
GATE — Life Sciences (XL) with Section U Food Technology is a postgraduate admission exam run by IITs and IISc on rotation (2027: IIT Madras), for candidates in India. Computer-based, 3 hours, 100 marks: General Aptitude 15, Section P Chemistry (compulsory) 25, and two optional sections of 30 marks each. MCQ, MSQ and NAT; −1/3 or −2/3 on wrong MCQs only; no partial credit on MSQ.
Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.
Fluid Flow, Thermodynamics & Heat Transfer in Dairy Plants in GATE XL
Fluid properties, pumping, thermodynamics and heat transfer worked as dairy plant problems.
Our 49 GATE XL questions in this subject: 6 easy, 43 medium, 0 hard, across 11 units.
10 practice questions, worked
Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.
These 10 were written to GATE XL and are not shown on any other exam's page.
Question 1 · medium
In a regenerative plate pasteuriser, pasteurised milk is kept at a higher pressure than raw milk so that:
Any leak runs from pasteurised to raw
Heat transfer through the plates doubles at higher pressure
The raw milk boils
Pumping energy falls
Answer and working
A. Any leak runs from pasteurised to raw
A pinhole must not let raw milk contaminate pasteurised milk; pressure differential is a public-health control.
Question 2 · medium
Doubling the velocity of a fully turbulent flow in a smooth pipe raises the friction head loss by a factor of about:
3.4
2
1.4
8
Answer and working
A. 3.4
h_f ∝ f v² with f ∝ Re^(−0.25), so h_f ∝ v^1.75; 2^1.75 ≈ 3.4.
Question 3 · medium
Which pump type is best suited to transferring stirred yoghurt with minimal damage to its texture?
High-speed centrifugal pump
Rotary lobe pump
Jet pump
Piston homogeniser pump
Answer and working
B. Rotary lobe pump
Lobe pumps are positive-displacement, gentle and cleanable; centrifugal pumps shear viscous products and lose performance.
Question 4 · medium
Centrifugal pumps must be installed below the supply tank or primed because they:
Are not self-priming
Cannot pump water or any other low-viscosity liquid
Run backwards when empty
Need air to work
Answer and working
A. Are not self-priming
Standard centrifugal pumps cannot lift liquid into an empty casing.
Question 5 · medium
Stirred yoghurt loses viscosity when pumped and recovers only partly at rest. This is:
Rheopexy
Dilatancy
Newtonian behaviour
Thixotropy
Answer and working
D. Thixotropy
Shearing breaks the protein network; only part rebuilds with time.
Question 6 · medium
For a steady-flow heater with no work and negligible kinetic and potential energy change, the first law reduces to:
Q = 0
W = ṁΔh
Q = ṁΔh
ΔU = 0 always
Answer and working
C. Q = ṁΔh
Heat added equals the enthalpy rise of the stream.
Question 7 · medium
Which mode of heat transfer needs no material medium?
Conduction
Radiation
Convection
Condensation
Answer and working
B. Radiation
Radiation travels as electromagnetic waves; conduction and convection need matter.
Question 8 · medium
Halving the thickness of a cheese reduces the time for salt to equalise by diffusion to about:
One half
Twice as long
No change
One quarter
Answer and working
D. One quarter
Diffusion time scales with distance squared.
Question 9 · medium
The Lewis number compares:
Inertia with viscosity
Buoyancy with viscosity
Thermal diffusivity with mass diffusivity
Conduction inside a solid with surface convection
Answer and working
C. Thermal diffusivity with mass diffusivity
Le = α/D = Sc/Pr; near 1 for air–water vapour.
Question 10 · medium
Multiple-effect evaporators save energy mainly because:
Each effect uses fresh steam
Vapour from one effect heats the next
They operate at atmospheric pressure
They remove less water
Answer and working
B. Vapour from one effect heats the next
Reusing latent heat in successive effects raises steam economy roughly in proportion to the number of effects.
A study plan for Fluid Flow, Thermodynamics & Heat Transfer in Dairy Plants in GATE XL
This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.
First, the heavy units (47% of the 49 questions): Diffusion and mass transfer coefficients (6, 12%); Dimensionless numbers and dimensional analysis (6, 12%); Sanitary centrifugal and positive displacement pumps; pump selection (6, 12%); Fluid properties and Bernoulli's equation (5, 10%).
Read the manual chapters for these first and do every worked question you can find on them.
Then the middle band: Pipe flow, Reynolds number and friction losses (5, 10%); Conduction, convection and radiation (4, 8%); Fins and insulation (4, 8%); Flow of non-Newtonian dairy fluids (4, 8%).
Aim for one sitting per unit, then mixed questions across them.
Then the lighter units: Laws of thermodynamics; steam tables (4, 8%); Heat exchangers: LMTD and effectiveness-NTU (3, 6%); Mass and energy balances in dairy processes (2, 4%).
Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.
Bank the easy marks: Flow of non-Newtonian dairy fluids (1 easy of 4); Laws of thermodynamics; steam tables (1 easy of 4).
Do these early in revision so they are fast on the day.
Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.