FSSAI Food Analyst Examination General Microbiology: practice questions
FSSAI Food Analyst Examination (and Junior Analyst Examination) · India · Food Safety and Standards Authority of India
Original practice questions written to the published syllabus · not past papers
10worked here, free
31written to this exam in this subject
10syllabus units
About FSSAI Food Analyst Examination
FSSAI Food Analyst Examination (and Junior Analyst Examination) is a licensing and registration exam run by Food Safety and Standards Authority of India, for candidates in India. A computer-based multiple-choice test in either the Chemical or the Biological discipline (+4 for a correct answer, -1 for a wrong one, 50% to qualify), then a practical examination, document verification and two weeks of compulsory training (11th Food Analyst Examination, FSSAI).
Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.
General Microbiology in FSSAI Food Analyst Examination
The microbial world before it meets food: cell structure, staining, growth, nutrition, genetics and control of bacteria, yeasts, moulds and viruses. Food microbiology (phase 2) builds directly on it.
Our 31 FSSAI Food Analyst Examination questions in this subject: 7 easy, 17 medium, 7 hard, across 10 units.
10 practice questions, worked
Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.
These 10 were written to FSSAI Food Analyst Examination and are not shown on any other exam's page.
Question 1 · hard
The direct epifluorescent filter technique (DEFT) for raw milk counts:
Gas bubbles produced in Durham tubes after inoculating lactose broth
Electrons scattered by cells on a filter coated with gold in a vacuum
Fluorochrome-stained cells retained on a membrane
Colonies that grow on a membrane placed on agar for 48 hours at 30 °C
Answer and working
C. Fluorochrome-stained cells retained on a membrane
DEFT filters the sample, stains the cells on the membrane and counts them by epifluorescence within about an hour. Counting colonies after incubation is membrane filtration plating.
Question 2 · hard
The main reason bacterial endospores resist heat far better than vegetative cells is:
A dehydrated core rich in calcium dipicolinate
High levels of catalase and superoxide dismutase in the coat
Active repair of heat damage by metabolism inside the spore
A thick outer membrane of lipopolysaccharide around the spore
Answer and working
A. A dehydrated core rich in calcium dipicolinate
Core dehydration is the chief factor, with calcium dipicolinate and small acid-soluble proteins protecting DNA. Spores are metabolically dormant and have no LPS outer membrane.
Question 3 · medium
A phage suspension diluted 10⁻⁶ gives 85 plaques when 0.1 mL is plated with host bacteria. The titre is:
8.5 × 10⁹ PFU/mL
8.5 × 10⁵ PFU/mL
8.5 × 10⁷ PFU/mL
8.5 × 10⁸ PFU/mL
Answer and working
D. 8.5 × 10⁸ PFU/mL
Titre = 85 ÷ (0.1 × 10⁻⁶) = 8.5 × 10⁸ PFU/mL. 8.5 × 10⁷ forgets the 0.1 mL volume.
Question 4 · medium
On MacConkey agar, a lactose-fermenting Gram-negative rod gives pink-red colonies. Which components respectively make the medium selective and differential?
Neutral red selects; peptone with sodium chloride differentiates
Lactose selects; bile salts with crystal violet differentiate by colour
Bile salts/crystal violet select; lactose/neutral red differentiate
Agar selects; bile salts with lactose differentiate by colony size
Answer and working
C. Bile salts/crystal violet select; lactose/neutral red differentiate
Bile salts and crystal violet inhibit Gram-positive bacteria; acid from lactose turns neutral red pink.
Question 5 · medium
To detect low numbers of Salmonella among many competitors in a food, the first culture step is usually:
Selective plating on MacConkey agar after 4 hours
Non-selective pre-enrichment in buffered peptone water
Membrane filtration of the undiluted food homogenate
Direct plating of the homogenate on blood agar without any broth
Answer and working
B. Non-selective pre-enrichment in buffered peptone water
Pre-enrichment resuscitates injured cells, then selective enrichment (Rappaport–Vassiliadis, tetrathionate) and selective plating follow.
Question 6 · hard
A Lactococcus lactis starter strain suddenly becomes a slow acid producer in milk after repeated subculture. The most likely genetic cause is:
Integration of an F plasmid into its chromosome
Loss of the plasmid for lactose use or proteinase
Mutation of its 16S rRNA gene to a different species
Gain of an R plasmid carrying resistance to penicillin
Answer and working
B. Loss of the plasmid for lactose use or proteinase
Lactose metabolism and proteinase genes of L. lactis are often plasmid-borne and can be lost on subculture.
Question 7 · easy
An inoculating loop is correctly sterilised by:
Dipping in 70% ethanol and using it while wet
Rinsing in sterile water between samples
Wiping with a dry tissue between each transfer
Flaming until red hot, then cooling it briefly
Answer and working
D. Flaming until red hot, then cooling it briefly
Flaming to red heat incinerates organisms; the loop must cool so it does not kill the inoculum. Ethanol does not kill spores.
Question 8 · medium
Cultures and contaminated plates from a food microbiology laboratory should be disposed of by:
Leaving open under UV light overnight
Pouring into the drain with tap water
Autoclaving them before any disposal
Placing in general waste in sealed bags
Answer and working
C. Autoclaving them before any disposal
All cultures and contaminated materials are decontaminated, usually by autoclaving, before leaving the laboratory.
Question 9 · easy
In a state food testing laboratory, a Food Analyst isolates and confirms non-typhoidal Salmonella from a spice sample. The minimum containment for this work is:
Biosafety level 1, open bench with no access control
Biosafety level 2, with a class II cabinet for aerosol steps
Biosafety level 3, in a negative-pressure suite with an airlock
Biosafety level 4, in a suit laboratory with chemical showers
Answer and working
B. Biosafety level 2, with a class II cabinet for aerosol steps
Non-typhoidal Salmonella is a risk group 2 agent, so routine isolation is done at BSL-2, with a class II biosafety cabinet for steps that make aerosols. BSL-1 is for agents that do not cause disease in healthy adults. BSL-3 is for risk group 3 agents spread by aerosol, such as Mycobacterium tuberculosis. BSL-4 is for agents such as Ebola virus, and no food laboratory works at that level.
Question 10 · easy
The ISO 6888-1 method used by food laboratories to count coagulase-positive staphylococci plates the sample on:
Baird-Parker egg yolk tellurite agar
Xylose lysine deoxycholate agar
Violet red bile glucose agar
Dichloran rose bengal chloramphenicol agar
Answer and working
A. Baird-Parker egg yolk tellurite agar
Baird-Parker agar uses tellurite and lithium chloride as selective agents and egg yolk to show lecithinase: Staphylococcus aureus gives black colonies with a clear halo, which are then confirmed by the coagulase test. XLD agar is a plating medium for Salmonella and Shigella. VRBG agar counts Enterobacteriaceae. DRBC agar counts yeasts and moulds.
A study plan for General Microbiology in FSSAI Food Analyst Examination
This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.
First, the heavy units (71% of the 31 questions): Aseptic technique and laboratory biosafety (7, 23%); Measurement of growth: serial dilution, plate count, MPN and turbidity (6, 19%); Control of microorganisms: physical and chemical agents and death kinetics (5, 16%); Microbial nutrition and culture media (4, 13%).
Read the manual chapters for these first and do every worked question you can find on them.
Then the middle band: Bacteria, yeasts, moulds and actinomycetes: morphology and classification (2, 6%); Microscopy: light, phase-contrast, fluorescence and electron (2, 6%); Viruses and bacteriophages (2, 6%); Microbial genetics: mutation, plasmids, transformation, transduction and conjugation (1, 3%).
Aim for one sitting per unit, then mixed questions across them.
Then the lighter units: Prokaryotic and eukaryotic cell structure; spores and vegetative cells (1, 3%); Staining: simple, Gram, acid-fast and endospore (1, 3%).
Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.
Leave time for the hard ones: Microbial genetics: mutation, plasmids, transformation, transduction and conjugation (1 hard of 1), Prokaryotic and eukaryotic cell structure; spores and vegetative cells (1 hard of 1), Measurement of growth: serial dilution, plate count, MPN and turbidity (3 hard of 6).
Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.
Bank the easy marks: Aseptic technique and laboratory biosafety (4 easy of 7); Microbial nutrition and culture media (1 easy of 4).
Do these early in revision so they are fast on the day.
Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.