LAISHA
Open Laisha

CUET-UG Environmental Monitoring & Instrumental Analysis: practice questions

CUET-UG — Environmental Studies domain test · India · National Testing Agency

Original practice questions written to the published syllabus · not past papers
10worked here, free
22written to this exam in this subject
12syllabus units

About CUET-UG

CUET-UG — Environmental Studies domain test is a university entrance exam run by National Testing Agency, for candidates in India. Computer-based MCQ domain test taken with language and other domain tests for undergraduate admission.

Official site: cuet.nta.nic.in.

We have not been able to confirm these details against the exam body's own specification, so fees, dates and pass marks are left out on purpose. Check the current format, eligibility, fees and dates on the official site.

Environmental Monitoring & Instrumental Analysis in CUET-UG

How environmental samples are taken and analysed and how good the numbers are: sampling plans, gravimetric and volumetric methods, spectroscopy, chromatography, quality assurance and monitoring networks.

Our 22 CUET-UG questions in this subject: 22 easy, 0 medium, 0 hard, across 12 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to CUET-UG and are not shown on any other exam's page.

Question 1 · easy

Monitoring carried out before a project begins, to describe existing conditions for an environmental impact assessment, is called

  1. baseline monitoring
  2. trend monitoring
  3. effectiveness monitoring
  4. compliance monitoring
Answer and working

A. baseline monitoring

Baseline monitoring records pre-project conditions; compliance checks standards; effectiveness checks controls; trend tracks change over time.

Question 2 · easy

Which sampling design divides a heterogeneous area into more uniform sub-areas and samples each randomly?

  1. Judgemental sampling
  2. Simple random sampling
  3. Composite sampling
  4. Stratified random sampling
Answer and working

D. Stratified random sampling

Stratification improves precision for heterogeneous areas; the others do not stratify.

Question 3 · easy

Why are quartz cuvettes used for measurements in the ultraviolet region?

  1. Quartz blocks visible light completely
  2. Quartz reacts with analytes to produce colour
  3. Glass and plastics absorb UV; quartz does not
  4. Quartz cuvettes are cheaper than glass
Answer and working

C. Glass and plastics absorb UV; quartz does not

Ordinary glass absorbs below about 340 nm; quartz is transparent to UV.

Question 4 · easy

In atomic absorption spectrometry, the light source for each element is usually a

  1. hollow cathode lamp made of that element
  2. laser of variable wavelength
  3. deuterium lamp
  4. tungsten filament lamp
Answer and working

A. hollow cathode lamp made of that element

Element-specific hollow cathode lamps emit the element's characteristic lines.

Question 5 · easy

Which technique is the standard method for measuring several anions such as fluoride, chloride, nitrate and sulphate in one run?

  1. Gas chromatography
  2. Gravimetry
  3. Atomic absorption
  4. Ion chromatography
Answer and working

D. Ion chromatography

Ion chromatography separates anions on ion-exchange columns with conductivity detection.

Question 6 · easy

Which international standard is used for hydrogen and oxygen isotope ratios in water?

  1. Vienna Standard Mean Ocean Water (VSMOW)
  2. Atmospheric nitrogen
  3. Canyon Diablo Troilite
  4. Vienna Pee Dee Belemnite (VPDB)
Answer and working

A. Vienna Standard Mean Ocean Water (VSMOW)

VSMOW for H and O; VPDB for carbon; air N2 for nitrogen; CDT for sulphur.

Question 7 · easy

What is the approximate half-life of carbon-14 used in radiocarbon dating?

  1. About 5730 years
  2. About 30 years
  3. About 12.3 years
  4. About 22 years
Answer and working

A. About 5730 years

14C ≈ 5730 years; tritium ≈ 12.3; 210Pb ≈ 22; 137Cs ≈ 30.

Question 8 · easy

Replicate measurements have a mean of 10 mg/L and a standard deviation of 0.5 mg/L. What is the relative standard deviation?

  1. 5 per cent
  2. 20 per cent
  3. 0.05 per cent
  4. 50 per cent
Answer and working

A. 5 per cent

RSD = 0.5/10 × 100 = 5%.

Question 9 · easy

Beta attenuation monitors are used to measure

  1. radon in homes
  2. particulate matter mass concentration
  3. noise levels
  4. dissolved oxygen
Answer and working

B. particulate matter mass concentration

BAMs measure the attenuation of beta radiation by particles collected on filter tape.

Question 10 · easy

Abundant Tubifex worms and chironomid larvae in a stream usually indicate

  1. very clean, well-oxygenated water
  2. organic pollution and low oxygen
  3. high salinity from seawater
  4. acid mine drainage only
Answer and working

B. organic pollution and low oxygen

These tolerant taxa dominate where EPT taxa disappear under organic pollution.

A study plan for Environmental Monitoring & Instrumental Analysis in CUET-UG

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (41% of the 22 questions): Bioindicators and biomonitoring (3, 14%); Atomic absorption and ICP techniques (2, 9%); Detection limits, accuracy, precision and calibration (2, 9%); Electrochemical methods and sensors (2, 9%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Gas and liquid chromatography; mass spectrometry (2, 9%); Monitoring objectives and network design (2, 9%); Sampling and preservation of water, soil, air and biota (2, 9%); Stable and radioactive isotopes in environmental analysis (2, 9%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: UV-visible spectrophotometry and colorimetry (2, 9%); Continuous and low-cost sensor monitoring (1, 5%); Gravimetric and volumetric analysis (1, 5%); Quality assurance, quality control and laboratory accreditation (1, 5%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Bank the easy marks: Bioindicators and biomonitoring (3 easy of 3); Atomic absorption and ICP techniques (2 easy of 2).

    Do these early in revision so they are fast on the day.

  5. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — CUET-UG Environmental Monitoring & Instrumental Analysis

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.