Japan Professional Engineer (技術士) First-stage Exam — Agriculture division · Japan · Institution of Professional Engineers, Japan (IPEJ)
Original practice questions written to the published syllabus · not past papersJapan Professional Engineer (技術士) First-stage Exam — Agriculture division is a licensing and registration exam run by Institution of Professional Engineers, Japan (IPEJ), for candidates in Japan. Five-option multiple choice on mark sheet: basic science 1 h (15 of 30), aptitude/ethics 1 h (15 questions), specialist 2 h (25 of 35, 50 marks). No eligibility limits.
Source: engineer.or.jp.
Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.
Enough agronomy to design for the crop: sowing geometry for planters, application rates for sprayers, moisture at harvest.
Our 30 Japan Professional Engineer First-stage Exam questions in this subject: 8 easy, 17 medium, 5 hard, across 2 units.
Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.
These 10 were written to Japan Professional Engineer First-stage Exam and are not shown on any other exam's page.
Glyphosate is best described as a:
A. Non-selective, systemic herbicide that inhibits EPSP synthase
Glyphosate is translocated through the plant and blocks EPSP synthase in the shikimate pathway; it kills almost all green plants. The other descriptions fit contact herbicides, dinitroanilines such as pendimethalin, and auxins such as 2,4-D respectively.
Why is 2,4-D used for weed control in wheat and maize?
C. It is a synthetic auxin that kills many broadleaf weeds while grass crops tolerate it
2,4-D mimics auxin and causes uncontrolled growth in susceptible dicots; cereals are largely tolerant at labelled rates and stages. It does not target grasses (the reverse), it is not a PSII inhibitor, and it is not a soil sterilant.
In an experiment, weed dry matter is 240 g/m² in the unweeded control and 36 g/m² in a herbicide treatment. What is the weed control efficiency?
A. 85 %
WCE = (240 − 36) ÷ 240 × 100 = 85 %. 15 % is the share of weeds remaining (36 ÷ 240); 567 % divides the reduction by the treated value (204 ÷ 36); 118 % inverts the formula (240 ÷ 204).
Purple nutsedge (Cyperus rotundus) is hard to control by tillage mainly because:
B. It spreads by underground tubers that tillage cuts up and distributes
Nutsedge is a perennial sedge that reproduces mostly by tubers on rhizomes; tillage fragments and spreads them. It is not an annual grass; its control problem is tubers, not invulnerable seed; and it thrives in upland soils.
Little seed canary grass (Phalaris minor) in rice–wheat fields of north-west India became resistant to isoproturon after years of repeated use. Which strategy best delays resistance to the replacement herbicides?
A. Rotate and mix herbicide modes of action and combine them with cultural controls such as zero-till and competitive sowing
Resistance comes from repeated selection with one mode of action; rotating and mixing modes, and adding non-chemical controls that reduce the seed bank, slow it. Lower-than-label rates select partially resistant plants; escalating doses of the same mode still select resistance; leaving weeds uncontrolled lets the resistant population set seed and devastates the crop.
A pre-emergence herbicide is labelled at 1.0 kg a.i./ha and is sold as a 30 % emulsifiable concentrate (30 % w/v a.i.). How many litres of product are needed per hectare?
B. 3.33 L
30 % w/v means 300 g a.i. per litre. Product = 1,000 g ÷ 300 g/L = 3.33 L/ha. 0.30 L multiplies the dose by the fraction; 3.0 L rounds 1 ÷ 0.3 down and under-doses by 10 %; 0.33 L is a factor-of-ten slip.
A boom sprayer has nozzles at 0.5 m spacing, each delivering 0.8 L/min, and travels at 6 km/h. What is the application rate?
D. 160 L/ha
Rate = 600 × q ÷ (v × w) = 600 × 0.8 ÷ (6 × 0.5) = 160 L/ha. 16 and 1,600 are factor-of-ten slips in the 600 constant; 80 L/ha leaves out the nozzle spacing, treating each nozzle as covering 1 m (600 × 0.8 ÷ 6).
A farmer wants to apply 200 L/ha with nozzles at 0.5 m spacing at a forward speed of 7.2 km/h. What flow must each nozzle deliver?
D. 1.2 L/min
q = rate × v × w ÷ 600 = 200 × 7.2 × 0.5 ÷ 600 = 1.2 L/min. 0.17 omits speed; 2.4 omits nozzle spacing; 12 uses 60 instead of 600.
Trichogramma wasps released in sugarcane, rice and cotton fields act as:
C. Egg parasitoids of moth pests
Trichogramma lay their eggs inside lepidopteran eggs, killing them before larvae hatch. They are not general predators, pollinators, or fungi.
Late blight of potato, which caused the Irish famine of the 1840s, is caused by:
C. Phytophthora infestans, an oomycete
Late blight is caused by the oomycete Phytophthora infestans. Ralstonia causes bacterial wilt; PVY is a viral disease; Alternaria solani causes early blight.
Last updated · How Laisha writes and checks its pages · Report a mistake
US$10 a month · one price worldwide · cancel any time
| Free | Smarter | |
|---|---|---|
| Grow guides, pest pages, articles | Read all | Read all |
| Ask Laisha | 5 a day | Up to 1,000 a month |
| Exam practice | The sample on each page | Every question, timed papers |
| Crop calendar and pest alerts | — | For your own fields |
| Calculators and tools | — | All |
| Uploads and reports | — | 100 a month, real files |
An AI operating system for agriculture: free guides, manuals and tools written for every country.