LAISHA
Open Laisha

GATE XL Novel & Non-thermal Food Processing Technologies: practice questions

GATE — Life Sciences (XL), Section U Food Technology · India · IITs and IISc on rotation (2027: IIT Madras)

Original practice questions written to the published syllabus · not past papers
10worked here, free
39written to this exam in this subject
8syllabus units

About GATE XL

GATE — Life Sciences (XL), Section U Food Technology is a postgraduate admission exam run by IITs and IISc on rotation (2027: IIT Madras), for candidates in India. Computer-based, 3 hours, 100 marks. MCQ, MSQ and NAT. Within XL, Section P Chemistry is understood to be compulsory and the candidate chooses two further sections, of which U Food Technology is one; this structure and the mark split are from earlier brochures and were not re-read for 2026.

Source: gate2026.iitg.ac.in.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Novel & Non-thermal Food Processing Technologies in GATE XL

Same as XE-G; questions often link mechanisms to microbiology — why spores resist, how membranes are damaged.

The newer ways to make food safe or change its structure with less heat damage: high-pressure processing, pulsed electric fields, ohmic, microwave and radio-frequency heating, irradiation, UV, cold plasma and ultrasound — their mechanisms, equipment, validation and regulatory status.

Our 39 GATE XL questions in this subject: 15 easy, 19 medium, 5 hard, across 8 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to GATE XL and are not shown on any other exam's page.

Question 1 · easy

Pulsed electric fields inactivate microorganisms mainly by

  1. heating cells to 121 °C
  2. ionising DNA with gamma rays from a cobalt source
  3. electroporation of cell membranes
  4. oxidising cells with ozone
Answer and working

C. electroporation of cell membranes

Field pulses create pores in membranes; irreversible pores kill the cell.

Question 2 · medium

PEF pre-treatment of potatoes for French fries is done mainly to

  1. sterilise the potatoes for long ambient storage before frying
  2. soften tissue for easier cutting and less oil uptake
  3. add colour to the fries
  4. increase the sugar content
Answer and working

B. soften tissue for easier cutting and less oil uptake

Low-field permeabilisation softens tubers, gives cleaner cuts and lowers oil uptake.

Question 3 · medium

The electrical conductivity of most foods during ohmic heating

  1. falls with temperature
  2. rises with temperature
  3. stays constant
  4. becomes zero above 60 °C
Answer and working

B. rises with temperature

Ion mobility rises as viscosity falls, so conductivity increases by a few per cent per degree.

Question 4 · medium

A pathogen has D10 = 0.5 kGy. The dose for a 5-log reduction is

  1. 2.5 kGy
  2. 0.1 kGy
  3. 10 kGy
  4. 5.5 kGy
Answer and working

A. 2.5 kGy

5 × 0.5 = 2.5 kGy. 0.1 divides; 10 multiplies by 20; 5.5 adds.

Question 5 · medium

Sprout inhibition of potatoes and onions uses

  1. low doses below 1 kGy
  2. doses above 25 kGy
  3. exactly 10 kGy
  4. doses of 100 kGy
Answer and working

A. low doses below 1 kGy

Low doses (about 0.05–0.15 kGy) stop sprouting; high doses sterilise.

Question 6 · medium

Radappertisation means irradiation to

  1. inhibit sprouting at low doses
  2. sterility, at high doses
  3. reduce spoilage organisms only
  4. disinfest grain of insects
Answer and working

B. sterility, at high doses

Radappertisation (> 10 kGy) sterilises; radurisation reduces spoilage; radicidation reduces pathogens.

Question 7 · easy

An irradiance of 2.0 mW/cm² for 15 s gives a UV dose of

  1. 7.5 mJ/cm²
  2. 17 mJ/cm²
  3. 30 mJ/cm²
  4. 0.13 mJ/cm²
Answer and working

C. 30 mJ/cm²

Dose = 2.0 × 15 = 30 mJ/cm². 7.5 divides; 17 adds; 0.13 inverts.

Question 8 · medium

A soup with electrical conductivity 1.0 S/m (ρ = 1000 kg/m³, cp = 4000 J/(kg·K)) is ohmically heated in a field of 1000 V/m. Ignoring losses, its rate of temperature rise is:

  1. 250 K/s
  2. 0.25 K/s
  3. 4.0 K/s
  4. 0.0025 K/s
Answer and working

B. 0.25 K/s

Power per unit volume = σE² = 1.0 × 1000² = 1 × 10⁶ W/m³, and dT/dt = σE²/(ρcp) = 10⁶ / (4 × 10⁶) = 0.25 K/s. 250 K/s omits ρ. 4.0 K/s inverts the ratio. 0.0025 K/s uses E rather than E² and so is too small.

Question 9 · medium

Salmonella in frozen poultry has a D₁₀ value of 0.5 kGy. The dose for a 5-log reduction is:

  1. 0.1 kGy
  2. 10 kGy
  3. 5.0 kGy
  4. 2.5 kGy
Answer and working

D. 2.5 kGy

Dose = D₁₀ × log reductions = 0.5 × 5 = 2.5 kGy. 0.1 kGy divides D₁₀ by 5. 10 kGy is the old general upper dose of Codex, not a calculated value. 5.0 kGy uses 10 log cycles.

Question 10 · hard

For a low-loss food with the same dielectric properties at both frequencies, how many times deeper does microwave power penetrate at 915 MHz than at 2450 MHz?

  1. 0.37
  2. 2.68
  3. 7.2
  4. 1.64
Answer and working

B. 2.68

For low-loss materials penetration depth ∝ λ₀√ε′/ε″, and with ε′ and ε″ fixed it scales with free-space wavelength, so 2450/915 = 2.68 times deeper. 0.37 inverts the ratio. 7.2 squares it. 1.64 takes its square root. This is why 915 MHz is chosen for thick products.

A study plan for Novel & Non-thermal Food Processing Technologies in GATE XL

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (56% of the 39 questions): High-pressure processing: principles, equipment and microbial inactivation (10, 26%); Food irradiation: dose, sources, effects and labelling (7, 18%); Microwave and radio-frequency heating (5, 13%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Ultraviolet light and pulsed light (5, 13%); Ohmic heating (4, 10%); Pulsed electric fields (4, 10%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Why non-thermal processing: quality and consumer drivers (3, 8%); Cold plasma (1, 3%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Leave time for the hard ones: High-pressure processing: principles, equipment and microbial inactivation (3 hard of 10), Microwave and radio-frequency heating (1 hard of 5), Ultraviolet light and pulsed light (1 hard of 5).

    Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.

  5. Bank the easy marks: Cold plasma (1 easy of 1); Why non-thermal processing: quality and consumer drivers (2 easy of 3).

    Do these early in revision so they are fast on the day.

  6. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — GATE XL Novel & Non-thermal Food Processing Technologies

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.