Range Forest Officer recruitment Wood Seasoning, Preservation & Protection: practice questions
Range Forest Officer recruitment (state exams) · India · State Public Service Commissions and state forest departments (e.g. MPPSC, UKPSC, UPPSC)
Original practice questions written to the published syllabus · not past papers
10worked here, free
34written to this exam in this subject
12syllabus units
About Range Forest Officer recruitment
Range Forest Officer recruitment (state exams) is a government recruitment exam run by State Public Service Commissions and state forest departments (e.g. MPPSC, UKPSC, UPPSC), for candidates in India. Usually objective and/or descriptive papers in general studies and forestry or science, with physical tests and an interview in some states.
We have not been able to confirm these details against the exam body's own specification, so fees, dates and pass marks are left out on purpose. Check the current format, eligibility, fees and dates on the official site.
Wood Seasoning, Preservation & Protection in Range Forest Officer recruitment
Drying timber without defects and protecting it from decay, insects and fire, by chemical, biological and modified-wood methods.
Our 34 Range Forest Officer recruitment questions in this subject: 17 easy, 17 medium, 0 hard, across 12 units.
10 practice questions, worked
Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.
These 10 were written to Range Forest Officer recruitment and are not shown on any other exam's page.
Question 1 · easy
The most common type of timber kiln is the:
Progressive tunnel kiln with moving trolleys
Vacuum kiln operating below atmospheric pressure
Compartment or batch kiln
Open shed with natural ventilation only
Answer and working
C. Compartment or batch kiln
A whole charge is loaded and dried through a schedule.
Question 2 · easy
Curvature across the width of a board is called:
Bow
Spring
Twist
Cup
Answer and working
D. Cup
Bow is along the length on the face; spring (crook) on the edge.
Question 3 · easy
Casehardening is a condition in which:
The shell is in tension and the core in compression
The shell is in compression and the core in tension
The whole board is free of stress
The board has turned to stone
Answer and working
B. The shell is in compression and the core in tension
The surface set while the interior was wet.
Question 4 · easy
Decay fungi cannot attack wood that is:
Below about 20% moisture
Moist and warm, typically above 30%
In ground contact
Unsealed at the ends
Answer and working
A. Below about 20% moisture
Decay needs moisture near or above FSP.
Question 5 · easy
In India, copper-chrome-arsenic preservative is commonly called:
ASCU
ACQ
LOSP
PCP
Answer and working
A. ASCU
Arsenic-copper-chrome; ACQ is alkaline copper quaternary.
Question 6 · easy
The full-cell process is also called the:
Rueping process
Bethell process
Lowry process
Boucherie process
Answer and working
B. Bethell process
Rueping and Lowry are empty-cell processes.
Question 7 · medium
Incising timber before treatment:
Seals the surface against preservative
Adds strength to poles
Opens pathways for deeper penetration
Removes heartwood
Answer and working
C. Opens pathways for deeper penetration
Small cuts expose more end-grain entry points in refractory wood.
Question 8 · medium
Groundline bandages on poles already in service are used to:
Season the pole in the ground
Extend service life
Paint the pole
Measure its height
Answer and working
B. Extend service life
They deliver preservative where decay risk is highest.
Question 9 · easy
Retention of preservative is expressed as:
kg per m³ of wood
mm of penetration
litres per tree
kg per hectare
Answer and working
A. kg per m³ of wood
Penetration is depth; retention is amount per volume.
Question 10 · medium
Sawdust from treated wood should not be used as:
Landfill cover under rules
Fuel in controlled incinerators
Sealed waste
Animal bedding or mulch
Answer and working
D. Animal bedding or mulch
Preservatives could reach animals and soil.
A study plan for Wood Seasoning, Preservation & Protection in Range Forest Officer recruitment
This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.
First, the heavy units (35% of the 34 questions): Air seasoning (3, 9%); Fire retardants (3, 9%); Kiln seasoning: kiln types and schedules (3, 9%); Preservatives: oil-type, water-borne, organic solvent (3, 9%).
Read the manual chapters for these first and do every worked question you can find on them.
Then the middle band: Retention, penetration and treatment standards (3, 9%); Safety and environmental rules on preservatives (3, 9%); Sap-displacement and diffusion methods (3, 9%); Seasoning defects and their control (3, 9%).
Aim for one sitting per unit, then mixed questions across them.
Then the lighter units: Solar and other low-cost seasoning (3, 9%); Treatment methods: non-pressure and pressure (full-cell, empty-cell) (3, 9%); Biological and environmentally safer preservation; modified wood (2, 6%); Wood-destroying agents: fungi, insects, marine borers (2, 6%).
Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.
Bank the easy marks: Fire retardants (2 easy of 3); Preservatives: oil-type, water-borne, organic solvent (2 easy of 3).
Do these early in revision so they are fast on the day.
Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.