LAISHA
Open Laisha

GATE ES Water & Wastewater Treatment: practice questions

GATE — Environmental Science and Engineering (ES) · India · IITs and IISc on rotation (2027: IIT Madras)

Original practice questions written to the published syllabus · not past papers
10worked here, free
49written to this exam in this subject
14syllabus units

About GATE ES

GATE — Environmental Science and Engineering (ES) is a postgraduate admission exam run by IITs and IISc on rotation (2027: IIT Madras), for candidates in India. Computer-based, 3 hours, 100 marks (15 General Aptitude + 85 subject). MCQ, MSQ and NAT question types with negative marking on MCQ only, as in all GATE papers.

Source: gate2026.iitg.ac.in.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Water & Wastewater Treatment in GATE ES

Making water safe to drink and wastewater safe to release or reuse: unit operations, biological treatment, reactor kinetics, sludge, industrial effluents and zero liquid discharge. Farm-scale lagoons and manure systems are in the Agricultural Engineering subject waste-management-environmental-engg; this subject covers municipal and agro-industrial treatment to GATE ES depth.

Our 49 GATE ES questions in this subject: 21 easy, 16 medium, 12 hard, across 14 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to GATE ES and are not shown on any other exam's page.

Question 1 · medium

Water contains 40 mg/L calcium and 12 mg/L magnesium. What is its total hardness as CaCO3?

  1. 18.9 mg/L
  2. 149 mg/L
  3. 100 mg/L
  4. 52 mg/L
Answer and working

B. 149 mg/L

Hardness = 40 x 50/20.04 + 12 x 50/12.15 = 99.8 + 49.4 = 149 mg/L as CaCO3. Adding masses ignores equivalents; the third ignores Mg.

Question 2 · medium

The BOD rate constant is 0.23 per day at 20 degrees C. Using theta = 1.047, what is it at 30 degrees C?

  1. 0.145 per day
  2. 0.241 per day
  3. 0.364 per day
  4. 2.41 per day
Answer and working

C. 0.364 per day

k30 = 0.23 x 1.047^10 = 0.364. Dividing gives the 10 degrees C value.

Question 3 · hard

A wastewater has BOD5 = 200 mg/L with k = 0.23 per day (base e). What is its ultimate BOD?

  1. 137 mg/L
  2. 870 mg/L
  3. 293 mg/L
  4. 632 mg/L
Answer and working

C. 293 mg/L

L0 = BOD5/(1 - e^-1.15) = 200/0.683 = 293. Multiplying by 0.683 gives BOD5 from L0, the reverse calculation.

Question 4 · easy

A town of 100,000 grows geometrically at 2% a year. What population is expected after 30 years?

  1. 54,881
  2. 106,121
  3. 160,000
  4. 181,136
Answer and working

D. 181,136

Pn = 100,000 x 1.02^30 = 181,136. 160,000 is arithmetic growth.

Question 5 · hard

In an ideal settling tank with overflow rate 30 m3/m2/d, what fraction of particles with settling velocity 0.2 mm/s is removed?

  1. 0.0007%
  2. 58%
  3. 174%
  4. 100%
Answer and working

B. 58%

vs = 0.2 mm/s = 17.28 m/d < vo, so removal = vs/vo = 0.58. Forgetting to convert units gives nonsense.

Question 6 · medium

A plant treats 10,000 m3/d at a chlorine dose of 2.0 mg/L. How much chlorine does it use per day?

  1. 5 kg
  2. 20,000 kg
  3. 20 kg
  4. 0.02 kg
Answer and working

C. 20 kg

10,000 m3 x 2.0 g/m3 = 20,000.0 g = 20 kg. Forgetting to convert grams to kilograms overstates the amount a thousandfold.

Question 7 · easy

The minimum velocity that prevents deposition in sanitary sewers (CPHEEO) is about:

  1. 0.06 m/s
  2. 60 m/s
  3. 0.6 m/s
  4. 6 m/s
Answer and working

C. 0.6 m/s

Storm sewers need higher velocities because of grit.

Question 8 · hard

The CSTR volume is split into two equal tanks in series (total theta = 4 days, k = 0.5/day). What fraction remains?

  1. 0.250
  2. 0.500
  3. 0.333
  4. 0.135
Answer and working

A. 0.250

C/C0 = 1/(1 + k theta/n)^n = 1/(1 + 1)^2 = 0.250. Two tanks in series perform between a single CSTR and a PFR.

Question 9 · hard

A sludge cake must be reduced from 80% to 60% moisture. What fraction of its mass remains?

  1. 0.5
  2. 0.25
  3. 0.8
  4. 0.75
Answer and working

A. 0.5

Solids mass constant: M2/M1 = (100 - 80)/(100 - 60) = 20/40 = 0.5.

Question 10 · medium

In a ZLD train, which unit recovers most of the water as permeate?

  1. Equalisation tank
  2. Reverse osmosis
  3. Oil-water separator
  4. Screening
Answer and working

B. Reverse osmosis

RO permeate is reused; reject goes to evaporators.

A study plan for Water & Wastewater Treatment in GATE ES

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (45% of the 49 questions): Activated sludge, trickling filters and their design parameters (5, 10%); Screening, sedimentation, coagulation and flocculation (5, 10%); Anaerobic treatment and UASB reactors (4, 8%); Filtration, desalination and disinfection (4, 8%); Population forecasting and design flows (4, 8%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Reactor kinetics: batch, CSTR and plug flow (4, 8%); Sludge treatment and disposal (4, 8%); Water and wastewater quality parameters: BOD, COD, solids, nutrients (4, 8%); BOD kinetics (3, 6%); Primary, secondary and tertiary treatment (3, 6%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Sewers, storm sewers and appurtenances (3, 6%); Water distribution and storage (3, 6%); Agro-industrial effluents: dairy, sugar, distillery, food processing (2, 4%); Common effluent treatment plants, recycling and zero liquid discharge (1, 2%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Leave time for the hard ones: Activated sludge, trickling filters and their design parameters (2 hard of 5), BOD kinetics (1 hard of 3), Primary, secondary and tertiary treatment (1 hard of 3).

    Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.

  5. Bank the easy marks: Water and wastewater quality parameters: BOD, COD, solids, nutrients (3 easy of 4); Anaerobic treatment and UASB reactors (2 easy of 4).

    Do these early in revision so they are fast on the day.

  6. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — GATE ES Water & Wastewater Treatment

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.