LAISHA
Open Laisha

GATE ES Circular Economy & Bio-based Resources: practice questions

GATE — Environmental Science and Engineering (ES) · India · IITs and IISc on rotation (2027: IIT Madras)

Original practice questions written to the published syllabus · not past papers
10worked here, free
24written to this exam in this subject
8syllabus units

About GATE ES

GATE — Environmental Science and Engineering (ES) is a postgraduate admission exam run by IITs and IISc on rotation (2027: IIT Madras), for candidates in India. Computer-based, 3 hours, 100 marks (15 General Aptitude + 85 subject). MCQ, MSQ and NAT question types with negative marking on MCQ only, as in all GATE papers.

Source: gate2026.iitg.ac.in.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Circular Economy & Bio-based Resources in GATE ES

Waste hierarchy and 3R/resource recovery in Section 7, zero liquid discharge and recycling of water in Section 5, sustainable development and resource efficiency in Section 9. Expect definitions, ordering of the hierarchy, and short numericals: mass balances, recovery fractions across ZLD or recycling chains, stoichiometric by-product yields.

Designing waste out of the system: circular-economy principles, the biological cycle, industrial symbiosis, material flow analysis and the bioeconomy. Composting, biogas and briquetting technology are in the Agricultural Engineering subjects bioenergy-systems and waste-management-environmental-engg; this subject covers the system design, metrics and policy.

Our 24 GATE ES questions in this subject: 9 easy, 11 medium, 4 hard, across 8 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to GATE ES and are not shown on any other exam's page.

Question 1 · easy

Which description best fits the linear economy?

  1. Take, make, use and dispose
  2. Reduce, reuse, recycle and recover
  3. Share, maintain, refurbish and recycle
  4. Grow, harvest, digest and return to soil
Answer and working

A. Take, make, use and dispose

The linear model extracts resources, makes products, uses them and discards them. The other sequences describe circular strategies: the R-hierarchy, the technical loops and the biological loop of the butterfly diagram.

Question 2 · medium

In the butterfly diagram, why are the inner loops of the technical cycle (maintain, reuse) preferred to the outer loop (recycle)?

  1. They need no collection or reverse logistics of any kind at the end of use
  2. They retain more of the value, energy and labour embodied in the product
  3. They are required by law in every country before recycling is allowed
  4. They produce higher-purity secondary raw materials than recycling does
Answer and working

B. They retain more of the value, energy and labour embodied in the product

Maintaining or reusing a product keeps the whole product and its embodied energy and labour in service; recycling keeps only the material and needs energy-intensive reprocessing. Inner loops still need some logistics, their priority is a design principle not a universal legal rule, and they do not produce raw materials at all.

Question 3 · hard

Flue-gas desulphurisation with limestone follows SO2 + CaCO3 + ½O2 + 2H2O → CaSO4·2H2O + CO2. How much gypsum forms per tonne of SO2 captured at full conversion?

  1. 2.12 t
  2. 1.56 t
  3. 2.69 t
  4. 0.37 t
Answer and working

C. 2.69 t

Molar masses: SO2 64.07, CaSO4·2H2O 172.17 g/mol; gypsum per t SO2 = 172.17/64.07 = 2.69 t. 2.12 uses anhydrous CaSO4 (136.14); 1.56 is the limestone needed; 0.37 inverts the ratio.

Question 4 · medium

Which practice is an example of cleaner production at the level of a single factory?

  1. Sending treated effluent to a common effluent treatment plant
  2. Substituting a less toxic input and recycling process water on site
  3. Buying carbon credits to offset the factory's emissions
  4. Relocating the factory to a region with weaker standards
Answer and working

B. Substituting a less toxic input and recycling process water on site

Cleaner production prevents pollution at source through good housekeeping, input substitution, process change and on-site recycling. End-of-pipe treatment, offsetting and relocation do not prevent pollution at source.

Question 5 · hard

Struvite is MgNH4PO4·6H2O (molar mass 245.4 g/mol). What is its phosphorus content by mass?

  1. 12.6 %
  2. 38.7 %
  3. 5.7 %
  4. 28.9 %
Answer and working

A. 12.6 %

P = 30.97/245.4 = 12.6 %. 38.7 % is the PO4 content, not P; 5.7 % is the N content; 28.9 % expresses P as P2O5 equivalent.

Question 6 · hard

One tonne of dry straw contains 38 % cellulose. Hydrolysis adds water (glucose = 1.111 × cellulose mass) and the theoretical ethanol yield is 0.511 g per g glucose. What is the maximum ethanol from the cellulose?

  1. 194 kg
  2. 422 kg
  3. 511 kg
  4. 216 kg
Answer and working

D. 216 kg

Glucose = 380 × 1.111 = 422 kg; ethanol = 422 × 0.511 = 216 kg. 194 skips the hydration factor; 422 is the glucose; 511 applies the yield to the whole straw mass.

Question 7 · medium

Bio-polyethylene made from sugar-cane ethanol is best described as:

  1. Biodegradable but not bio-based
  2. Bio-based but not biodegradable
  3. Both bio-based and biodegradable
  4. Neither bio-based nor biodegradable
Answer and working

B. Bio-based but not biodegradable

Bio-PE is a drop-in polymer chemically identical to fossil PE: its carbon is biogenic but it does not biodegrade and is recycled with fossil PE. PBAT is the reverse case (fossil, biodegradable); PLA and PHA can be both.

Question 8 · medium

Why did the EU ban oxo-degradable plastics under the Single-Use Plastics Directive?

  1. They fragment into microplastics without fully biodegrading
  2. They biodegrade too quickly and contaminate compost with their additives
  3. They are made from food crops and so compete with human food supply
  4. They are identical to PLA and confuse the sorting of compostable waste
Answer and working

A. They fragment into microplastics without fully biodegrading

Oxo-degradable plastics are conventional polymers with additives that accelerate fragmentation; the fragments persist as microplastics. They are fossil-based, not food-crop-based, and are chemically distinct from PLA.

Question 9 · hard

PLA is made by polymerising lactic acid (C3H6O3, 90.08 g/mol), with each unit losing one water molecule to give a repeat unit of 72.06 g/mol. What is the maximum PLA from 1 kg of lactic acid?

  1. 1.00 kg
  2. 1.25 kg
  3. 0.20 kg
  4. 0.80 kg
Answer and working

D. 0.80 kg

PLA = 1 × 72.06/90.08 = 0.80 kg; the rest leaves as water. 1.00 kg ignores the water lost; 1.25 inverts the ratio; 0.20 kg is the water removed.

Question 10 · easy

What is extended producer responsibility (EPR)?

  1. A policy making producers financially and/or physically responsible for their products after use
  2. A voluntary label awarded to producers who use recycled packaging materials in at least half of their product range
  3. A tax on consumers who fail to separate household waste at source
  4. A warranty extension that producers offer to buyers of durable goods
Answer and working

A. A policy making producers financially and/or physically responsible for their products after use

The OECD defines EPR as extending producers' responsibility to the post-consumer stage, financially and/or physically. Labels, consumer penalties and warranties are different instruments.

A study plan for Circular Economy & Bio-based Resources in GATE ES

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (71% of the 24 questions): Bio-based and biodegradable materials: claims and evidence (6, 25%); Material flow analysis and resource-efficiency metrics (6, 25%); Industrial ecology and industrial symbiosis (5, 21%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Linear versus circular economy; the butterfly diagram (3, 13%); Cascading use of biomass (1, 4%); Circular agriculture: nutrient and carbon recycling (1, 4%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Extended producer responsibility and eco-design (1, 4%); Food waste valorisation and biorefineries (1, 4%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Leave time for the hard ones: Circular agriculture: nutrient and carbon recycling (1 hard of 1), Food waste valorisation and biorefineries (1 hard of 1), Industrial ecology and industrial symbiosis (1 hard of 5).

    Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.

  5. Bank the easy marks: Cascading use of biomass (1 easy of 1); Extended producer responsibility and eco-design (1 easy of 1).

    Do these early in revision so they are fast on the day.

  6. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — GATE ES Circular Economy & Bio-based Resources

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.