LAISHA
Open Laisha

ICAR AIEEA-PG Cheese Science & Technology: practice questions

ICAR AIEEA-PG: Dairy Science (group 16) and Dairy Technology (group 17) · India · NTA for ICAR

Original practice questions written to the published syllabus · not past papers
10worked here, free
55written to this exam in this subject
13syllabus units

About ICAR AIEEA-PG

ICAR AIEEA-PG: Dairy Science (group 16) and Dairy Technology (group 17) is a postgraduate admission exam run by NTA for ICAR, for candidates in India. Computer-based, 2 hours, 120 multiple-choice questions, +4 for a correct answer and −1 for a wrong one (2026 bulletin). One paper per major subject group.

Source: icar.org.in.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Cheese Science & Technology in ICAR AIEEA-PG

Chemistry of rennin coagulation and of changes during ripening, Cheddar and processed cheese microbiology, and manufacture and defects of dairy products. Expect direct MCQs: the chymosin cleavage site, the role of calcium and temperature in the secondary phase, the purpose of cheddaring, emulsifying salts, causes of early and late blowing.

Cheese from milk selection to ripening and processed cheese: coagulation, curd handling, salting, ripening, yield and the major variety families.

Our 55 ICAR AIEEA-PG questions in this subject: 24 easy, 30 medium, 1 hard, across 13 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to ICAR AIEEA-PG and are not shown on any other exam's page.

Question 1 · easy

A Cheddar contains 1.8% salt and 36.0% moisture. What is its salt-in-moisture (S/M)?

  1. 20.0%
  2. 5.0%
  3. 2.8%
  4. 1.8%
Answer and working

B. 5.0%

S/M = salt ÷ moisture × 100 = 1.8 ÷ 36 × 100 = 5.0%. 2.8% is salt in dry matter; 1.8% is total salt; 20.0% inverts the ratio.

Question 2 · medium

How much salt must be dissolved in 1,000 kg of water to make a brine of 20% NaCl (w/w)?

  1. 250 kg
  2. 800 kg
  3. 200 kg
  4. 166.7 kg
Answer and working

A. 250 kg

For 20% w/w, salt ÷ (salt + water) = 0.20, so salt = 0.20 × 1000 ÷ 0.80 = 250 kg. 200 kg would give 200 ÷ 1200 = 16.7%; 800 kg confuses the water fraction with the salt; 166.7 kg is 1000 × 0.2 ÷ 1.2.

Question 3 · hard

Buffalo milk (100 kg, 6.0% fat, 9.0% SNF) is made into paneer. Assume 90% of the fat and 60% of the SNF are recovered and the paneer has 55% moisture. What mass of paneer is expected?

  1. 19.6 kg
  2. 24.0 kg
  3. 10.8 kg
  4. 30.0 kg
Answer and working

B. 24.0 kg

Solids recovered = 0.9 × 6.0 + 0.6 × 9.0 = 5.4 + 5.4 = 10.8 kg; paneer = 10.8 ÷ (1 − 0.55) = 24.0 kg. 19.6 kg divides by the moisture fraction; 10.8 kg forgets the water; 30.0 kg applies 90% recovery to all solids.

Question 4 · medium

Why is nitrate added to milk for Gouda and Edam in some countries?

  1. To speed starter growth so that the curd reaches its draining pH sooner in the vat
  2. To sequester calcium so that the curd fuses well when pressed
  3. To suppress Clostridium tyrobutyricum and so prevent late blowing
  4. To fix the yellow colour of the fat during long brine salting
Answer and working

C. To suppress Clostridium tyrobutyricum and so prevent late blowing

Nitrate inhibits outgrowth of clostridial spores that cause late blowing; it is restricted or banned in some countries, where lysozyme, bactofugation or microfiltration are used. It does not speed starters or act on colour or calcium.

Question 5 · easy

The kappa-casein 'hairy layer' stabilises casein micelles mainly by:

  1. Steric and electrostatic repulsion between micelles
  2. Hydrogen bonds to lactose dissolved in the serum
  3. Binding all the calcium so none is free in milk
  4. Covalent bonds holding micelles to the fat globules
Answer and working

A. Steric and electrostatic repulsion between micelles

The protruding, charged caseinomacropeptide keeps micelles apart. It does not bind micelles to fat or lactose, and milk contains free calcium ions regardless.

Question 6 · easy

Curd for Parmesan and Emmental is cut very fine and cooked to around 50–55 °C mainly to:

  1. Keep the coagulant intact so that softening is very rapid later
  2. Produce a high-moisture curd for a soft, quickly eaten cheese
  3. Produce a low-moisture curd for a hard, long-ripened cheese
  4. Keep mesophilic starters fully active through the whole cook
Answer and working

C. Produce a low-moisture curd for a hard, long-ripened cheese

Fine cutting and a high cook give a dry curd for hard cheese, and select thermophilic flora; much of the coagulant is inactivated. Mesophilic starters are largely inactivated at these temperatures.

Question 7 · medium

At roughly what pH is Cheddar curd usually milled?

  1. About 6.6
  2. About 5.3–5.4
  3. About 4.6
  4. About 6.1
Answer and working

B. About 5.3–5.4

Curd is drained near pH 6.1–6.2 and milled near 5.3–5.4. pH 6.6 is fresh milk; 4.6 is the isoelectric point of casein, far too acid for Cheddar.

Question 8 · easy

Enzyme-modified cheese (EMC) is best described as:

  1. A processed cheese in which emulsifying salts are replaced entirely by enzymes
  2. Young cheese paste treated with enzymes for strong flavour, used as an ingredient
  3. A table cheese ripened by enzymes alone without any starter culture in the vat
  4. A fresh cheese coagulated by plant enzymes instead of animal or microbial rennet
Answer and working

B. Young cheese paste treated with enzymes for strong flavour, used as an ingredient

EMC is a concentrated flavour ingredient for processed cheese, snacks and sauces, not a table cheese.

Question 9 · easy

In the MMV process, cheese is made from milk ultrafiltered to:

  1. A fat-free retentate, to which cream is added after ripening
  2. A lactose-free permeate, which is then renneted and pressed
  3. About the final cheese composition, so no whey is drained
  4. A low protein content, so more whey can be drained after cutting
Answer and working

C. About the final cheese composition, so no whey is drained

MMV (Maubois, Mocquot and Vassal) concentrates milk by UF to cheese composition (a liquid pre-cheese) and coagulates it directly, as in cast Feta-type cheese. The permeate carries lactose and is not renneted.

Question 10 · medium

Why does ultrafiltration raise cheese yield?

  1. Fat globules are broken down so that more fat dissolves in the curd
  2. Casein is converted into whey protein, which binds more water
  3. Lactose is concentrated in the curd and adds to the cheese mass
  4. Whey proteins are retained with casein and fat instead of being lost in whey
Answer and working

D. Whey proteins are retained with casein and fat instead of being lost in whey

UF retains whey proteins (and more water with them). Lactose passes to the permeate; casein is not converted.

A study plan for Cheese Science & Technology in ICAR AIEEA-PG

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (51% of the 55 questions): Milk quality and pre-treatment for cheese (7, 13%); Rennet coagulation and gel formation (6, 11%); Cheddaring, pasta filata stretching and other curd treatments (5, 9%); Cutting, cooking and syneresis (5, 9%); Fresh cheeses: cottage, cream cheese, quark, queso fresco, paneer (5, 9%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Ripening and accelerated ripening (5, 9%); Salting: dry, brine and its effect (5, 9%); Coagulants: calf rennet, microbial, fermentation-produced chymosin, plant (4, 7%); Varieties: Cheddar, Gouda, Swiss types, Mozzarella, Parmesan, blue and soft cheeses (4, 7%); Mechanised and UF-based cheese making (3, 5%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Cheese defects and grading (2, 4%); Cheese yield: formulas and factors (2, 4%); Processed cheese and cheese spreads: emulsifying salts (2, 4%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Leave time for the hard ones: Fresh cheeses: cottage, cream cheese, quark, queso fresco, paneer (1 hard of 5).

    Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.

  5. Bank the easy marks: Coagulants: calf rennet, microbial, fermentation-produced chymosin, plant (3 easy of 4); Varieties: Cheddar, Gouda, Swiss types, Mozzarella, Parmesan, blue and soft cheeses (3 easy of 4).

    Do these early in revision so they are fast on the day.

  6. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — ICAR AIEEA-PG Cheese Science & Technology

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.