ICAR AIEEA-PG Milk Composition & Physical Properties: practice questions
ICAR AIEEA-PG: Dairy Science (group 16) and Dairy Technology (group 17) · India · NTA for ICAR
Original practice questions written to the published syllabus · not past papers
10worked here, free
76written to this exam in this subject
12syllabus units
About ICAR AIEEA-PG
ICAR AIEEA-PG: Dairy Science (group 16) and Dairy Technology (group 17) is a postgraduate admission exam run by NTA for ICAR, for candidates in India. Computer-based, 2 hours, 120 multiple-choice questions, +4 for a correct answer and −1 for a wrong one (2026 bulletin). One paper per major subject group.
Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.
Milk Composition & Physical Properties in ICAR AIEEA-PG
Composition and physico-chemical properties of milk and colostrum: typical values for cow and buffalo milk, lactometer and SNF calculations, freezing point and added water, titratable acidity units and natural versus developed acidity, and the effect of breed, feed and lactation on composition.
What milk is made of, how composition varies, and the physical properties used to test and process it.
Our 76 ICAR AIEEA-PG questions in this subject: 31 easy, 42 medium, 3 hard, across 12 units.
10 practice questions, worked
Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.
These 10 were written to ICAR AIEEA-PG and are not shown on any other exam's page.
Question 1 · medium
Which protein is absent from both human and camel milk but is the main whey protein of cow milk?
Alpha-lactalbumin
Lactoferrin
Serum albumin
Beta-lactoglobulin
Answer and working
D. Beta-lactoglobulin
Beta-lactoglobulin is absent from human and camel milk. Alpha-lactalbumin is present in all, as the lactose synthase subunit. Lactoferrin is higher in human milk.
Question 2 · easy
Which constituent is present at a much lower concentration in first-milking colostrum than in normal milk?
Total protein
Vitamin A
Immunoglobulin
Lactose
Answer and working
D. Lactose
Colostrum lactose is about 2.5-3% against about 4.7% in milk. Immunoglobulins, total protein and vitamin A are all much higher in colostrum.
Question 3 · medium
Why should lactometer readings not be taken on milk immediately after milking and rapid cooling?
Lactose crystallises at low temperature and gives false high readings
Fresh milk is too viscous for the lactometer to settle correctly
Density keeps rising for some hours as fat crystallises and gases escape
The lactometer usually cannot float freely in milk that still contains foam and air
Answer and working
C. Density keeps rising for some hours as fat crystallises and gases escape
This is the Recknagel phenomenon: fat crystallisation and gas loss raise density over several hours, so early readings are low.
Question 4 · medium
Taking the freezing point of genuine milk as -0.530 degrees Celsius, a sample freezes at -0.477 degrees Celsius. Using added water = (T - T')/T x 100, what is the added water?
11.1 per cent
10.0 per cent
90.0 per cent
5.3 per cent
Answer and working
B. 10.0 per cent
(0.530 - 0.477)/0.530 x 100 = 0.053/0.530 x 100 = 10.0%. 11.1 divides by the sample value 0.477 instead of the base; 90 is the genuine milk share.
Question 5 · medium
How does souring of milk affect its freezing point?
It has no effect, because lactic acid is a colloid
It lowers the freezing point further, which can mask added water
It raises the freezing point because lactose is consumed
It raises the freezing point towards zero, which can imitate added water
Answer and working
B. It lowers the freezing point further, which can mask added water
Fermentation turns one lactose molecule into more molecules of lactic acid, which ionise, increasing dissolved particles and depressing the freezing point; this can hide watering.
Question 6 · easy
Which milk component contributes most to the viscosity of whole milk?
Soluble salts
Whey proteins
Casein micelles
Lactose
Answer and working
C. Casein micelles
Casein micelles, by volume fraction, contribute most, followed by fat globules; whey proteins and lactose contribute less.
Question 7 · medium
What stabilises fat globules against coalescence by lowering the fat-water interfacial tension?
Colloidal calcium phosphate crystals on the globule core
Dissolved carbon dioxide held at the fat-water boundary
Dissolved lactose concentrated in a dense hydrated layer around each globule surface
The milk fat globule membrane and, after homogenisation, adsorbed proteins
Answer and working
D. The milk fat globule membrane and, after homogenisation, adsorbed proteins
Native MFGM (phospholipids and proteins) and, after homogenisation, adsorbed casein and whey proteins lower interfacial tension and protect globules.
Question 8 · medium
In a clean-in-place system, conductivity probes are mainly used to:
Measure the fat content of milk left in the pipes after rinsing
Measure the viscosity of the caustic solution during circulation
Detect bacterial spores remaining on stainless steel surfaces
Distinguish product, rinse water and detergent and control changeover
Answer and working
D. Distinguish product, rinse water and detergent and control changeover
Water, milk, caustic and acid differ widely in conductivity, so probes control phase changeover and detergent strength.
Question 9 · easy
The oxidation-reduction potential of fresh raw milk exposed to air is about:
0 volts exactly
+1.2 to +1.3 volts
+0.2 to +0.3 volts
-0.2 to -0.3 volts
Answer and working
C. +0.2 to +0.3 volts
Fresh milk is about +0.2 to +0.3 V, set by dissolved oxygen, ascorbate and riboflavin.
Question 10 · easy
Milk appears white because:
Lactose absorbs every visible wavelength except white light, which it reflects strongly
Casein micelles and fat globules scatter all visible wavelengths
Calcium salts crystallise as white particles
Riboflavin fluoresces white under daylight
Answer and working
B. Casein micelles and fat globules scatter all visible wavelengths
Strong scattering of all visible light by micelles and globules makes milk white.
A study plan for Milk Composition & Physical Properties in ICAR AIEEA-PG
This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.
First, the heavy units (37% of the 76 questions): Acidity and pH; titratable acidity (7, 9%); Colostrum and abnormal milks (7, 9%); Density and specific gravity; lactometer readings (7, 9%); Electrical conductivity, refractive index and thermal properties (7, 9%).
Read the manual chapters for these first and do every worked question you can find on them.
Then the middle band: Gross composition of milk and its normal ranges (7, 9%); Species differences: cow, buffalo, goat, sheep, camel, human (7, 9%); Viscosity, surface tension and interfacial tension (7, 9%); Colour and optical properties of milk (6, 8%).
Aim for one sitting per unit, then mixed questions across them.
Then the lighter units: Oxidation-reduction potential (6, 8%); Variation with breed, feed, season, lactation stage and mastitis (6, 8%); Freezing point and its use in detecting added water (5, 7%); Buffer capacity and acid-base equilibria (4, 5%).
Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.
Leave time for the hard ones: Oxidation-reduction potential (1 hard of 6), Variation with breed, feed, season, lactation stage and mastitis (1 hard of 6), Density and specific gravity; lactometer readings (1 hard of 7).
Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.
Bank the easy marks: Colostrum and abnormal milks (5 easy of 7); Gross composition of milk and its normal ranges (4 easy of 7).
Do these early in revision so they are fast on the day.
Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.