ICAR AIEEA-PG / PGS — Code 18 Food Science Technology · India · ICAR through the National Testing Agency
Original practice questions written to the published syllabus · not past papers
10worked here, free
44written to this exam in this subject
11syllabus units
About ICAR AIEEA-PG / PGS
ICAR AIEEA-PG / PGS — Code 18 Food Science Technology is a postgraduate admission exam run by ICAR through the National Testing Agency, for candidates in India. Computer-based, multiple choice, +4/−1 marking.
Unit II lists freezing among unit operations and refrigeration among utilities; Unit IV lists preservation by cold. MCQs test types of freezers, cryogens and their temperatures, blanching indicators, freezer burn, thaw rigor, glazing, IQF and the −18 °C standard.
Low-temperature preservation from the food's side: chilling and controlled atmospheres, freezing-point depression and ice crystallisation, freezing-time calculation, freezer types, frozen storage changes and thawing. The refrigeration cycle and cold-store design are in Agricultural Engineering's refrigeration-cold-chain.
Our 44 ICAR AIEEA-PG / PGS questions in this subject: 15 easy, 27 medium, 2 hard, across 11 units.
10 practice questions, worked
Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.
These 10 were written to ICAR AIEEA-PG / PGS and are not shown on any other exam's page.
Question 1 · medium
Overloading a retail display cabinet above its load line causes
the bottom products to freeze solid because air cannot reach them at all
the top products to warm because they sit outside the cold air curtain
the cabinet's defrost cycle to stop permanently, cooling the products better
no effect, because display cabinets cool all products equally
Answer and working
B. the top products to warm because they sit outside the cold air curtain
Products above the load line are in warmer store air outside the designed airflow and warm up quickly.
Question 2 · easy
Most foods begin to freeze at a temperature slightly below 0 °C because
foods contain air that insulates the water from cold surroundings
the cell walls hold water at a higher pressure than the atmosphere
fats in the food freeze first and release heat that keeps water liquid
dissolved solutes depress the freezing point
Answer and working
D. dissolved solutes depress the freezing point
Sugars, salts and acids lower the freezing point; typical initial freezing points are about −0.5 to −3 °C.
Question 3 · easy
In Plank's equation, the shape factors for an infinite slab are
P = 1/6 and R = 1/24
P = 1/4 and R = 1/16
P = 1 and R = 1
P = 1/2 and R = 1/8
Answer and working
D. P = 1/2 and R = 1/8
Slab 1/2 and 1/8; cylinder 1/4 and 1/16; sphere 1/6 and 1/24.
Question 4 · easy
Liquid nitrogen used in cryogenic freezing boils at atmospheric pressure at about
−78.5 °C
−40 °C
−196 °C
−273 °C
Answer and working
C. −196 °C
Liquid nitrogen boils at −196 °C; CO₂ sublimes at −78.5 °C; −273 °C is absolute zero.
Question 5 · easy
Individual quick freezing of peas is usually done in a
vertical plate freezer
fluidised-bed freezer
still-air cold room
brine immersion tank
Answer and working
B. fluidised-bed freezer
Cold air blown up through the bed suspends and separates the peas, freezing each in minutes so they flow freely.
Question 6 · medium
Horizontal plate freezers are best suited to
whole poultry carcasses of irregular shape
loose peas that must flow freely
large whole tuna
flat retail packs of uniform thickness
Answer and working
D. flat retail packs of uniform thickness
Plates must contact both flat faces; irregular items and loose particles need blast, IQF or other freezers.
Question 7 · medium
Vertical plate freezers are commonly used on fishing vessels to
individually quick freeze shrimps in a fluidised bed
freeze whole fish in still air in the hold
freeze unpacked fish into blocks
thaw frozen bait before use
Answer and working
C. freeze unpacked fish into blocks
Fish is loaded between vertical plates and frozen into blocks, compact for storage and later processing.
Question 8 · easy
Vegetables are blanched before freezing mainly to
add salt for flavour
make them sterile
inactivate enzymes
freeze them faster
Answer and working
C. inactivate enzymes
Blanching inactivates enzymes that would cause off-flavours, discoloration and nutrient loss in frozen storage; it reduces but does not eliminate microbes.
Question 9 · medium
Ice crystals found inside packages of frozen vegetables usually indicate
correct storage at a constant −25 °C throughout distribution
excessive blanching before freezing
use of IQF freezing
temperature fluctuations during storage
Answer and working
D. temperature fluctuations during storage
Warming and cooling drive moisture from the product to the pack's colder surfaces, where it refreezes as frost.
Question 10 · medium
Microwave thawing is often uneven because
liquid water absorbs microwaves much more strongly than ice
ice absorbs microwaves more strongly than water
microwaves cannot penetrate frozen food at all
metal trays are always used in thawing, reflecting all of the energy
Answer and working
A. liquid water absorbs microwaves much more strongly than ice
Thawed spots heat rapidly while neighbouring ice stays cold — runaway heating; pulsed defrost settings reduce it.
A study plan for Chilling, Freezing & Frozen Food Technology in ICAR AIEEA-PG / PGS
This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.
First, the heavy units (52% of the 44 questions): Chilling and chilled storage of foods (7, 16%); Changes during frozen storage: freezer burn, drip loss and oxidation (6, 14%); Air-blast, plate, cryogenic and IQF freezers (5, 11%); Freezing of fruits, vegetables, meat, fish and ready meals (5, 11%).
Read the manual chapters for these first and do every worked question you can find on them.
Then the middle band: Freezing-point depression and unfrozen water (5, 11%); Cold-chain requirements for chilled foods (4, 9%); Ice nucleation, crystal growth and recrystallisation (4, 9%); Thawing and tempering (4, 9%).
Aim for one sitting per unit, then mixed questions across them.
Then the lighter units: Time-temperature tolerance and shelf life of frozen foods (2, 5%); Freezing-time prediction: Plank's equation and its refinements (1, 2%); Supercooling, isochoric and other emerging freezing methods (1, 2%).
Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.
Leave time for the hard ones: Ice nucleation, crystal growth and recrystallisation (1 hard of 4), Freezing of fruits, vegetables, meat, fish and ready meals (1 hard of 5).
Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.
Bank the easy marks: Freezing-time prediction: Plank's equation and its refinements (1 easy of 1); Freezing-point depression and unfrozen water (3 easy of 5).
Do these early in revision so they are fast on the day.
Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.