LAISHA
Open Laisha

ICAR AICE-JRF/SRF Emerging & Non-thermal Dairy Processing: practice questions

ICAR AICE-JRF/SRF (PhD): Dairy Chemistry, Dairy Microbiology, Dairy Technology, Dairy Engineering · India · NTA for ICAR

Original practice questions written to the published syllabus · not past papers
10worked here, free
74written to this exam in this subject
12syllabus units

About ICAR AICE-JRF/SRF

ICAR AICE-JRF/SRF (PhD): Dairy Chemistry, Dairy Microbiology, Dairy Technology, Dairy Engineering is a PhD, fellowship and lectureship exam run by NTA for ICAR, for candidates in India.

Source: icar.org.in.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Emerging & Non-thermal Dairy Processing in ICAR AICE-JRF/SRF

Alternatives and additions to heat: high pressure, pulsed electric fields, ultrasound, ohmic and microwave heating, irradiation, carbonation and hurdle technology.

Our 74 ICAR AICE-JRF/SRF questions in this subject: 19 easy, 46 medium, 9 hard, across 12 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to ICAR AICE-JRF/SRF and are not shown on any other exam's page.

Question 1 · easy

What pressure range is most used commercially in high pressure processing?

  1. 4–6 MPa
  2. 400–600 MPa
  3. 40–60 kPa
  4. 4,000–6,000 MPa
Answer and working

B. 400–600 MPa

Commercial HPP mostly runs at 400–600 MPa for a few minutes.

Question 2 · easy

Which microorganisms are most resistant to high pressure alone at ambient temperature?

  1. Bacterial spores
  2. Moulds
  3. Yeasts
  4. Gram-negative rods
Answer and working

A. Bacterial spores

Spores need pressure combined with heat; Gram-negatives are generally more pressure sensitive than Gram-positives.

Question 3 · medium

What is the mechanism of microbial inactivation by pulsed electric fields?

  1. Dissolving cell walls with ozone
  2. Heating the cell interior to over 100 °C
  3. Electroporation of the cell membrane
  4. Breaking covalent bonds in DNA directly
Answer and working

C. Electroporation of the cell membrane

An induced transmembrane potential above about 1 V creates pores, irreversible at high intensity.

Question 4 · easy

What frequency range is typical of power ultrasound for processing?

  1. About 2–10 GHz
  2. About 2–10 MHz
  3. About 20–100 kHz
  4. About 20–100 Hz
Answer and working

C. About 20–100 kHz

High-frequency, low-intensity ultrasound (MHz) is used for measurement.

Question 5 · easy

What is the main mechanism by which power ultrasound acts in liquids?

  1. Joule heating
  2. Acoustic cavitation
  3. Electroporation
  4. Ionising radiation
Answer and working

B. Acoustic cavitation

Bubble collapse produces hot spots, shock waves, shear, microjets and radicals.

Question 6 · medium

Why is ethanol added as a co-solvent when extracting phospholipids?

  1. Ethanol sterilises the extraction vessel
  2. Supercritical CO2 is non-polar and dissolves them poorly
  3. Phospholipids react with CO2 to form gas
  4. Ethanol lowers the critical pressure of CO2 to zero
Answer and working

B. Supercritical CO2 is non-polar and dissolves them poorly

A polar modifier extends CO2's range to polar lipids.

Question 7 · hard

How do regulators usually treat deliberately engineered nanomaterials in food?

  1. They treat them exactly as bulk materials
  2. They ban all nanostructures, including casein micelles
  3. They exempt them from any assessment
  4. They require specific safety assessment
Answer and working

D. They require specific safety assessment

Particle-specific behaviour requires characterisation and toxicology; natural dairy nanostructures are not treated as engineered.

Question 8 · medium

Under a pressure treatment, the target organism's D value is 0.8 min. What minimum holding time gives a 6-log reduction?

  1. 7.5 min
  2. 4.8 min
  3. 0.13 min
  4. 6.8 min
Answer and working

B. 4.8 min

6 × 0.8 = 4.8 min. 0.13 divides 0.8 by 6.

Question 9 · medium

In EU novel food law, when is a food from a new process 'novel'?

  1. Only when the food is imported
  2. When the process significantly changes composition
  3. Whenever the factory or production line is newly built
  4. Whenever the process uses electricity at any stage
Answer and working

B. When the process significantly changes composition

Significant changes affecting nutrition, metabolism or undesirable substances trigger authorisation.

Question 10 · medium

Why can't pressure-treated milk simply be called 'pasteurised milk' in many jurisdictions?

  1. Pressure treatment is banned for all foods everywhere
  2. Pasteurisation is defined by thermal processes
  3. Pasteurised milk must be sold frozen
  4. Pressure-treated milk contains no protein
Answer and working

B. Pasteurisation is defined by thermal processes

Dairy standards list time–temperature combinations; other processes need specific recognition or a different name.

A study plan for Emerging & Non-thermal Dairy Processing in ICAR AICE-JRF/SRF

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (47% of the 74 questions): High pressure processing (10, 14%); Ohmic, microwave, radio-frequency and infrared heating (9, 12%); Pulsed electric fields (8, 11%); Regulatory approval of novel processes (8, 11%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Cold plasma (7, 9%); Irradiation and UV-C treatment of milk (7, 9%); Supercritical fluid extraction (7, 9%); Ultrasound in processing and cleaning (6, 8%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Hurdle technology (5, 7%); Microencapsulation and nanotechnology (3, 4%); 3D printing and other new formats (2, 3%); Carbonation and carbon dioxide to extend shelf life (2, 3%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Leave time for the hard ones: Microencapsulation and nanotechnology (1 hard of 3), Ohmic, microwave, radio-frequency and infrared heating (2 hard of 9), High pressure processing (2 hard of 10).

    Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.

  5. Bank the easy marks: Cold plasma (3 easy of 7); Irradiation and UV-C treatment of milk (3 easy of 7).

    Do these early in revision so they are fast on the day.

  6. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — ICAR AICE-JRF/SRF Emerging & Non-thermal Dairy Processing

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.