LAISHA
Open Laisha

ICAR AICE-JRF/SRF Dairy Plant Utilities & Energy Management: practice questions

ICAR AICE-JRF/SRF (PhD): Dairy Chemistry, Dairy Microbiology, Dairy Technology, Dairy Engineering · India · NTA for ICAR

Original practice questions written to the published syllabus · not past papers
10worked here, free
72written to this exam in this subject
10syllabus units

About ICAR AICE-JRF/SRF

ICAR AICE-JRF/SRF (PhD): Dairy Chemistry, Dairy Microbiology, Dairy Technology, Dairy Engineering is a PhD, fellowship and lectureship exam run by NTA for ICAR, for candidates in India.

Source: icar.org.in.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Dairy Plant Utilities & Energy Management in ICAR AICE-JRF/SRF

Subject 37 Unit 3: water conservation methods. Subject 38 Units 4 and 5: thermodynamics and heat transfer, pressure vessels (codes, design for pressure and temperature, testing). Expect boiler efficiency, flash steam, heat recovery and pressure-vessel safety questions.

Steam, water, compressed air and electricity in the milk plant, and how to audit and cut energy and water use.

Our 72 ICAR AICE-JRF/SRF questions in this subject: 1 easy, 41 medium, 30 hard, across 10 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to ICAR AICE-JRF/SRF and are not shown on any other exam's page.

Question 1 · medium

A boiler makes 2,000 kg/h of steam (enthalpy 2,770 kJ/kg) from feed water at 335 kJ/kg, burning 140 kg/h of oil with a gross calorific value of 42,000 kJ/kg. What is its efficiency by the direct method?

  1. 82.8%
  2. 94.2%
  3. 106.1%
  4. 91.5%
Answer and working

A. 82.8%

Efficiency = 2,000 × (2,770 − 335) ÷ (140 × 42,000) = 82.8%. The others ignore feed enthalpy, subtract the feed temperature instead of its enthalpy, or invert the ratio.

Question 2 · medium

Condensate with a sensible heat of 721 kJ/kg is released to atmospheric pressure (sensible heat 419 kJ/kg, latent heat 2,257 kJ/kg). What fraction flashes to steam?

  1. 18.6%
  2. 41.9%
  3. 13.4%
  4. 11.3%
Answer and working

C. 13.4%

Flash fraction = (721 − 419) ÷ 2,257 = 13.4%. The others divide by the condensate enthalpy, use the wrong numerator, or divide by total steam enthalpy.

Question 3 · hard

What line current does a 100 kW three-phase load draw at 415 V and a power factor of 0.85?

  1. 283 A
  2. 139 A
  3. 164 A
  4. 118 A
Answer and working

C. 164 A

I = P ÷ (√3 × V × PF) = 100,000 ÷ (1.732 × 415 × 0.85) = 164 A. The others omit √3, omit the PF, or multiply by it.

Question 4 · hard

Biogas from the reactor above (700 m³/day of methane) is 65% methane. What volume of biogas is produced?

  1. 1,077 m³/day
  2. 700 m³/day
  3. 2,000 m³/day
  4. 455 m³/day
Answer and working

A. 1,077 m³/day

Biogas = 700 ÷ 0.65 = 1,077 m³/day. 455 multiplies by the methane share; 2,000 divides by the methane yield.

Question 5 · hard

What happens when a burner is tuned to too little excess air?

  1. Less CO in flue gas
  2. A larger dry flue gas loss from heating surplus air
  3. Higher feed-water hardness
  4. Incomplete combustion and soot
Answer and working

D. Incomplete combustion and soot

Below the minimum safe excess air, fuel is left unburnt as CO and soot, which also fouls tubes; too much air raises flue gas loss.

Question 6 · medium

Why is steam often distributed at higher pressure and reduced near the point of use?

  1. High-pressure steam carries more latent heat per kilogram to the user
  2. Pressure-reducing valves superheat it for food
  3. Mains are smaller; low-pressure steam has more latent heat
  4. It avoids steam traps
Answer and working

C. Mains are smaller; low-pressure steam has more latent heat

Higher pressure means denser steam and smaller pipes; latent heat per kilogram rises as pressure falls.

Question 7 · medium

Which dryer is needed when air lines pass through freezing areas?

  1. No dryer
  2. Desiccant dryer
  3. Refrigerated dryer with a +3 °C dew point
  4. Aftercooler only
Answer and working

B. Desiccant dryer

Desiccant dryers reach dew points well below freezing; refrigerated dryers stay above it.

Question 8 · medium

Where does most of the electrical input to an air compressor end up?

  1. As noise
  2. As heat
  3. As vibration of the frame
  4. As stored air energy
Answer and working

B. As heat

Most input becomes heat, which can be recovered for water or space heating.

Question 9 · medium

Which international standard provides a framework for energy management systems?

  1. ISO 9001
  2. ISO 50001
  3. ISO 14001
  4. ISO 8573-1
Answer and working

B. ISO 50001

ISO 50001 covers energy policy, baselines, performance indicators and improvement.

Question 10 · medium

At what pressure are boiler safety valves set?

  1. At any pressure the operator chooses on the day
  2. Well above design pressure
  3. At or below the design pressure, sealed
  4. At atmospheric pressure
Answer and working

C. At or below the design pressure, sealed

Valves are set not above the allowed working pressure and sealed against tampering.

A study plan for Dairy Plant Utilities & Energy Management in ICAR AICE-JRF/SRF

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (56% of the 72 questions): Boilers: types, fittings, mountings and efficiency (12, 17%); Heat recovery and cogeneration (10, 14%); Steam distribution and condensate recovery (10, 14%); Electrical supply and power factor (8, 11%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Boiler and pressure-vessel safety rules (7, 10%); Water conservation and reuse (7, 10%); Renewable energy in dairy plants: solar thermal, biogas (6, 8%); Compressed air systems (4, 6%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Energy audits (4, 6%); Water supply, treatment and quality for dairy use (4, 6%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Leave time for the hard ones: Water supply, treatment and quality for dairy use (3 hard of 4), Renewable energy in dairy plants: solar thermal, biogas (4 hard of 6), Electrical supply and power factor (4 hard of 8).

    Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.

  5. Bank the easy marks: Heat recovery and cogeneration (1 easy of 10).

    Do these early in revision so they are fast on the day.

  6. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — ICAR AICE-JRF/SRF Dairy Plant Utilities & Energy Management

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.