ICAR AIEEA-PG / PGS — Code 18 Food Science Technology · India · ICAR through the National Testing Agency
Original practice questions written to the published syllabus · not past papers
10worked here, free
58written to this exam in this subject
11syllabus units
About ICAR AIEEA-PG / PGS
ICAR AIEEA-PG / PGS — Code 18 Food Science Technology is a postgraduate admission exam run by ICAR through the National Testing Agency, for candidates in India. Computer-based, multiple choice, +4/−1 marking.
Reducing and using food-industry waste: characterisation and treatment of food-plant effluents, recovery of by-products, water and energy reduction, life-cycle assessment and circular-economy approaches. General agricultural waste engineering is in Agricultural Engineering's waste-management-environmental-engg.
Our 58 ICAR AIEEA-PG / PGS questions in this subject: 21 easy, 36 medium, 1 hard, across 11 units.
10 practice questions, worked
Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.
These 10 were written to ICAR AIEEA-PG / PGS and are not shown on any other exam's page.
Question 1 · medium
In which part of the chain are losses of perishable produce often proportionally largest in many low-income countries?
Supermarket shelves in large city centres
Restaurant kitchens serving tourists in cities
Post-harvest handling, storage and transport
Household kitchens after purchase from shops
Answer and working
C. Post-harvest handling, storage and transport
Lack of cold chains, storage, drying and roads causes large post-harvest losses in many low-income settings, while household waste dominates in many higher-income countries.
Question 2 · medium
A dairy effluent is diluted 1 in 100 for a BOD test. Dissolved oxygen falls from 8.5 to 4.0 mg/L in 5 days. What is the BOD₅?
45 mg/L
450 mg/L
4.5 mg/L
850 mg/L
Answer and working
B. 450 mg/L
BOD₅ = (D₁ − D₂)/P = (8.5 − 4.0)/0.01 = 450 mg/L. 4.5 mg/L forgets the dilution; 850 mg/L divides the initial DO by P; 45 mg/L uses a dilution of 1 in 10.
Question 3 · easy
An aeration tank of 3000 m³ receives 1000 m³ of effluent per day. What is the hydraulic retention time?
8 hours
72 hours
3 hours
0.33 hours
Answer and working
B. 72 hours
HRT = V/Q = 3000/1000 = 3 days = 72 hours. 3 hours confuses days with hours; 0.33 inverts the ratio; 8 hours takes a third of a day.
Question 4 · easy
What is the typical methane content of biogas from anaerobic digestion?
About 20 to 25 per cent
About 50 to 70 per cent
About 90 to 99 per cent
About 5 to 10 per cent
Answer and working
B. About 50 to 70 per cent
Biogas is mainly methane (about 50–70%) and carbon dioxide, with traces of H₂S; upgrading is needed to reach near-pure biomethane.
Question 5 · medium
How is chitosan obtained from shrimp shells?
Fermentation of the shells by yeasts into ethanol
Extraction of the oil from the shells with hexane
Acid hydrolysis of the shells into pure glucose syrup
Demineralise, deproteinise, then deacetylate chitin
Answer and working
D. Demineralise, deproteinise, then deacetylate chitin
Shells are treated with acid to remove minerals and alkali to remove protein, giving chitin, which is deacetylated with strong alkali to chitosan.
Question 6 · easy
What is the main use of brewers' spent grain?
Cattle feed
Paper whitening
Biodiesel production
Glass manufacture
Answer and working
A. Cattle feed
Spent grain, the largest brewery by-product, goes mostly to cattle feed, with growing use as dried food ingredients. The other uses are not standard.
Question 7 · medium
In counter-current washing of vegetables, where does clean water enter?
At the first stage, flowing forward to the later stages
At the last stage, then flowing back to the earlier stages
At every stage separately, with no reuse between stages
Only during the final rinse after the vegetables are cooked
Answer and working
B. At the last stage, then flowing back to the earlier stages
Clean water meets the cleanest product last and then flows backwards to wash dirtier product, cutting water use while keeping the final rinse clean.
Question 8 · easy
Under the GHG Protocol, which scope covers emissions from electricity purchased by a food factory?
Scope 3
Scope 2
Scope 1
Scope 0
Answer and working
B. Scope 2
Scope 2 is indirect emissions from purchased electricity, steam, heat and cooling. Scope 1 is direct; scope 3 is other value-chain emissions.
Question 9 · easy
What is aquafaba, an upcycled ingredient?
Chickpea cooking liquid used as an egg-white substitute
Fish sauce made from fish processing waste
Coffee cherry husk used for infusions
Water recovered from milk evaporation
Answer and working
A. Chickpea cooking liquid used as an egg-white substitute
Aquafaba, the cooking liquid of chickpeas, whips like egg white. The other descriptions are fish sauce, cow water and cascara.
Question 10 · easy
What does the "polluter pays" principle mean?
Consumers pay a tax on every product bought
Those who cause pollution bear the costs of it
Polluters receive subsidies to reduce pollution
Governments pay all pollution clean-up costs
Answer and working
B. Those who cause pollution bear the costs of it
The principle places the costs of preventing and remedying pollution on those responsible for it.
A study plan for Food Waste Valorisation, By-products & Sustainable Food Processing in ICAR AIEEA-PG / PGS
This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.
First, the heavy units (47% of the 58 questions): Recovery of by-products from fruit, cereal, dairy, meat and fish processing (8, 14%); Characteristics of food-industry wastes: BOD, COD and solids (7, 12%); Anaerobic digestion of food-processing waste (6, 10%); Energy efficiency and carbon footprint (6, 10%).
Read the manual chapters for these first and do every worked question you can find on them.
Then the middle band: Circular economy and upcycled foods (5, 9%); Effluent treatment for food plants: primary, secondary and tertiary (5, 9%); Environmental regulation for food industries (5, 9%); Food loss and waste along the chain (5, 9%).
Aim for one sitting per unit, then mixed questions across them.
Then the lighter units: Water reuse and water footprint in food plants (5, 9%); Extraction of bioactives from by-products (4, 7%); Life-cycle assessment of food products (2, 3%).
Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.
Leave time for the hard ones: Water reuse and water footprint in food plants (1 hard of 5).
Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.
Bank the easy marks: Energy efficiency and carbon footprint (3 easy of 6); Extraction of bioactives from by-products (2 easy of 4).
Do these early in revision so they are fast on the day.
Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.