Tamil Nadu PSC — Agricultural Engineering (Code 164, degree standard) · India · Tamil Nadu Public Service Commission
Original practice questions written to the published syllabus · not past papersTamil Nadu PSC — Agricultural Engineering (Code 164, degree standard) is a government recruitment exam run by Tamil Nadu Public Service Commission, for candidates in India. Degree-standard subject paper (for posts such as Assistant Engineer (Agri)).
Source: tnpsc.gov.in.
Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.
Materials, structural members, foundations and estimates for farm buildings and small works.
Our 41 Tamil Nadu PSC questions in this subject: 29 easy, 11 medium, 1 hard, across 9 units.
Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.
These 10 were written to Tamil Nadu PSC and are not shown on any other exam's page.
A new brick wall in a farm store develops a white powdery deposit after the first rains. What is it and what causes it?
D. Efflorescence: soluble salts carried to the surface by water that evaporates
Soluble salts (often sulphates of sodium, potassium or magnesium) in the bricks or mortar dissolve, migrate to the surface and crystallise as the water evaporates. Burnt clay does not carbonate; carbonation is a reaction of calcium hydroxide in cement or lime. Mould is usually dark, not a white crystalline deposit.
A slab panel 3.5 m × 8.0 m is supported on all four edges by beams. How should it be designed?
A. As a one-way slab spanning the 3.5 m direction, because ly/lx exceeds 2
ly/lx = 8.0/3.5 = 2.29 > 2, so the slab bends mainly across the short span; main bars run parallel to the 3.5 m span with distribution bars along the long direction. Four-edge support makes it two-way only when ly/lx ≤ 2.
A column carries a service load of 750 kN. Allowing 10% for the footing's self-weight and backfill, what side length of square footing is needed on soil with an allowable bearing pressure of 150 kN/m²?
D. 2.35 m
Area = 750 × 1.10/150 = 5.50 m²; side = √5.50 = 2.35 m. Ignoring self-weight gives 2.24 m; applying the 1.5 load factor to bearing (which uses service loads) gives 2.87 m; 5.50 is the area, not the side.
When is a raft (mat) foundation usually preferred to individual column footings?
C. When the footings would cover more than half the plan area or the soil is weak and variable
A raft spreads load over the whole plan, lowering pressure and bridging soft spots to reduce differential settlement. On strong soil with small, widely spaced footings, isolated footings are cheaper.
A farm godown is to be built on expansive black cotton soil. Which foundation approach is commonly used in Indian practice to limit swelling and shrinkage damage?
C. Under-reamed piles anchored below the zone of seasonal moisture change, with a grade beam
Under-reamed piles have enlarged bulbs that anchor the structure below the active zone, and a grade beam spans between them clear of the clay. Shallow footings in the active zone move with the seasons and crack walls. Practice in other countries uses deeper footings, stiffened rafts or moisture barriers.
How much cement is needed for 0.30 m³ of dry 1:6 cement–sand mortar, taking cement bulk density as 1,440 kg/m³?
B. 61.7 kg
Cement = 0.30 × 1/(1 + 6) = 0.0429 m³ × 1,440 = 61.7 kg (about 1.23 bags). Dividing by 6 instead of 7 gives 72.0; 205.7 kg is the cement per m³ of dry mortar, not per 0.30 m³. 432.0 kg forgets the 1/7 cement share (0.30 × 1,440).
A farm office of 150 m² plinth area is to be estimated for administrative approval at a plinth-area rate of 16,000 per m², with 5% added for contingencies. What is the estimate?
C. 2,520,000
150 × 16,000 = 2,400,000; × 1.05 = 2,520,000. 2,400,000 omits contingencies; 2,280,000 subtracts them; 2,640,000 uses 10%. Contingency percentages are set by local rules.
A slab 6 m × 4 m × 0.12 m is cast in 1:1.5:3 nominal-mix concrete. With a dry-volume factor of 1.54 and cement at 1,440 kg/m³, how many 50 kg bags of cement are needed?
B. 23.2 bags
Volume = 6 × 4 × 0.12 = 2.88 m³. Cement per m³ = 1.54/5.5 × 1,440/50 = 8.06 bags; × 2.88 = 23.2 bags. Without the 1.54 factor: 15.1; 8.1 is the per-m³ figure; dividing by 4.5 (leaving out the cement part) gives 28.4.
What distinguishes a detailed specification from a general specification?
D. It describes each item's materials, workmanship, tests and mode of measurement in full
A general (brief) specification outlines the building as a whole and goes with an approximate estimate; a detailed specification covers every item fully and forms part of the contract. Costs and payments are in the estimate and contract conditions; as-built records are a separate document.
What is the measurement book used for in public works?
C. Recording measurements of work done and materials received, as the basis for payments
The measurement book is the original record of quantities measured by the engineer; running and final bills are prepared from it, and auditors check against it. Payroll, specifications and test registers are separate records.
This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.
Read the manual chapters for these first and do every worked question you can find on them.
Aim for one sitting per unit, then mixed questions across them.
Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.
Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.
Do these early in revision so they are fast on the day.
Last updated · How Laisha writes and checks its pages · Report a mistake
US$10 a month · one price worldwide · cancel any time
| Free | Smarter | |
|---|---|---|
| Grow guides, pest pages, articles | Read all | Read all |
| Ask Laisha | 5 a day | Up to 1,000 a month |
| Exam practice | The sample on each page | Every question, timed papers |
| Crop calendar and pest alerts | — | For your own fields |
| Calculators and tools | — | All |
| Uploads and reports | — | 100 a month, real files |
An AI operating system for agriculture: free guides, manuals and tools written for every country.