Tamil Nadu PSC Agricultural Structures & Environmental Control: practice questions
Tamil Nadu PSC — Agricultural Engineering (Code 164, degree standard) · India · Tamil Nadu Public Service Commission
Original practice questions written to the published syllabus · not past papers
10worked here, free
35written to this exam in this subject
12syllabus units
About Tamil Nadu PSC
Tamil Nadu PSC — Agricultural Engineering (Code 164, degree standard) is a government recruitment exam run by Tamil Nadu Public Service Commission, for candidates in India. Degree-standard subject paper (for posts such as Assistant Engineer (Agri)).
Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.
Agricultural Structures & Environmental Control in Tamil Nadu PSC
Unit V farm structures: farm buildings, godowns, dairy and poultry housing, threshing floors and rural roads, mainly descriptive with simple calculations.
Planning a farmstead and designing its buildings, stores and animal houses, including the ventilation that keeps animals healthy.
Our 35 Tamil Nadu PSC questions in this subject: 25 easy, 9 medium, 1 hard, across 12 units.
10 practice questions, worked
Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.
These 10 were written to Tamil Nadu PSC and are not shown on any other exam's page.
Question 1 · easy
In a well-planned farmstead, where should the farm dwelling normally be placed relative to the livestock buildings?
Upwind in the odour season and uphill of the livestock area
Downwind and downhill of the livestock area, for shelter
Directly between the livestock buildings and the manure store for easy supervision
In the lowest part of the site, where drainage water from the yards collects
Answer and working
A. Upwind in the odour season and uphill of the livestock area
Placing the house upwind and uphill means odours, dust and drainage move away from it. Putting it downwind or downhill sends smells and yard runoff toward the family, and the lowest part of the site collects cold air and flood water.
Question 2 · easy
Why do planners leave one side of each major farm building clear of other structures?
So that rainwater from neighbouring roofs can be collected on that side
So the building can be extended later without demolition or relocation
Because building codes forbid more than three walls next to any structure
So that the side can be used as a permanent manure heap for the unit
Answer and working
B. So the building can be extended later without demolition or relocation
Farm enterprises grow; keeping one side open lets a barn or store be lengthened instead of duplicated elsewhere on the site. It has nothing to do with rain collection or a code rule on walls, and manure heaps are kept downwind in their own zone.
Question 3 · easy
Which of these is classified as dead load on a farm building?
Weight of bagged fertiliser stored on the floor during the cropping season
Self-weight of roof sheeting, purlins and trusses permanently in place
Weight of cattle standing on a slatted floor laid over a slurry pit below
Weight of a maintenance worker walking across the roof sheets to repair them
Answer and working
B. Self-weight of roof sheeting, purlins and trusses permanently in place
Dead load is the permanent self-weight of the structure and fixed equipment. Stored fertiliser, animals and maintenance workers come and go, so they are live (or product) loads.
Question 4 · easy
Which feature is most important for a good threshing floor?
A soft, loose earthen surface that absorbs grain impact and reduces breakage
A deep depression in the middle so rainwater collects and can be reused
A rough gravel surface, which helps separate stones from the grain
A hard, smooth, crack-free surface, raised and sloped to an edge drain
Answer and working
D. A hard, smooth, crack-free surface, raised and sloped to an edge drain
Grain must be swept up clean and the floor must shed rain quickly, so it is hard, smooth, raised and drained. Loose earth and gravel mix soil and stones with the grain, and a central depression floods the produce.
Question 5 · medium
Why should a rural kitchen that burns biomass fuel have a chimney or smokeless stove?
A chimney raises the flame temperature so that cooking needs almost no fuel at all
Building codes ban indoor open fires only because of the fire risk to thatch roofs
Indoor smoke from biomass fuel causes much respiratory illness in households
Smoke improves the taste of food, and the chimney stores it for later cooking
Answer and working
C. Indoor smoke from biomass fuel causes much respiratory illness in households
Household smoke from biomass cooking causes chronic lung disease and pneumonia, especially in women and children, so removing it is the main health reason. Chimneys do not remove the need for fuel, and fire risk is a secondary reason.
Question 6 · medium
Why are steps to the loading platform of a rat-proof godown made removable or detached from the plinth?
Removable steps are cheaper because they need no foundation of their own
Detached steps let trucks reverse closer to the door for unloading
A fixed step joined to the plinth would act as a ladder for rats
Fixed steps are banned because workers might trip on them at night
Answer and working
C. A fixed step joined to the plinth would act as a ladder for rats
Any fixed structure touching the plinth gives rodents a route past the rat guard. Cost, truck access and tripping are not the reason for the detail.
Question 7 · medium
Why are bags in a godown stacked on dunnage with a gap from the walls?
To keep bags off damp floors and allow inspection, fumigation and rodent control
To raise the stacks so that rats can run underneath them without touching any grain
To let the walls support the stacks and so reduce the load on the floor slab
To increase the store's capacity by using the otherwise wasted space by the walls
Answer and working
A. To keep bags off damp floors and allow inspection, fumigation and rodent control
Dunnage keeps bags clear of floor moisture and condensation, and the wall gap and alleys give access for inspection, treatment and rodent control. Leaning stacks on walls loads them sideways; the gap reduces, not increases, capacity.
Question 8 · easy
A farm road 3.6 m wide has a two-way camber of 1 in 30. How high is the crown above the edges?
60 mm
120 mm
54 mm
30 mm
Answer and working
A. 60 mm
Each half is 1.8 m wide; rise = 1.8/30 = 0.060 m = 60 mm. 120 mm uses the full width; 54 mm multiplies half the width by 30 (taken as mm); 30 mm halves the answer again.
Question 9 · easy
In a tie-stall dairy barn, what is the main advantage of a head-to-head arrangement of the two rows?
One central dunging alley serves both rows, making milking quicker
One central feed alley serves both rows, making feeding quicker
Cows face the walls, so light falls on their udders for milking
No mangers are needed because cows eat from the floor between rows
Answer and working
B. One central feed alley serves both rows, making feeding quicker
Head-to-head puts the mangers on a shared central feed alley. A shared dunging alley and better light on the udders are the advantages of tail-to-tail. Mangers are still required.
Question 10 · medium
Which door detail is standard in a rat-proof godown?
Timber doors with a 5 cm gap at the bottom to ventilate the grain stacks
Doors left open by day so that cats can enter and keep the rats down
Close-fitting doors, metal-sheeted below, with no gap at the threshold
Mesh doors with 25 mm openings so workers can see inside the store
Answer and working
C. Close-fitting doors, metal-sheeted below, with no gap at the threshold
Rats gnaw timber and pass through small gaps, so doors are metal-faced and close-fitting. A bottom gap or 25 mm mesh admits rodents, and open doors defeat the purpose of rat-proofing.
A study plan for Agricultural Structures & Environmental Control in Tamil Nadu PSC
This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.
First, the heavy units (66% of the 35 questions): Rat-proof godowns (7, 20%); Farm roads and fencing (6, 17%); Rural houses and threshing floors (6, 17%); Dairy cattle housing (4, 11%).
Read the manual chapters for these first and do every worked question you can find on them.
Then the middle band: Farmstead planning (2, 6%); Poultry housing (2, 6%); Space requirements for livestock (2, 6%); Ventilation rate from heat and moisture balance (2, 6%).
Aim for one sitting per unit, then mixed questions across them.
Then the lighter units: Design loads: dead, live, wind, snow and grain (1, 3%); Manure storage structures (1, 3%); Structural design of bins and silos (1, 3%); Swine housing (1, 3%).
Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.
Leave time for the hard ones: Rat-proof godowns (1 hard of 7).
Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.
Bank the easy marks: Dairy cattle housing (4 easy of 4); Farmstead planning (2 easy of 2).
Do these early in revision so they are fast on the day.
Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.