ICAR AIEEA-PG / PGS Evaporation, Dehydration & Concentration of Foods: practice questions
ICAR AIEEA-PG / PGS — Code 18 Food Science Technology · India · ICAR through the National Testing Agency
Original practice questions written to the published syllabus · not past papers
10worked here, free
54written to this exam in this subject
12syllabus units
About ICAR AIEEA-PG / PGS
ICAR AIEEA-PG / PGS — Code 18 Food Science Technology is a postgraduate admission exam run by ICAR through the National Testing Agency, for candidates in India. Computer-based, multiple choice, +4/−1 marking.
Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.
Evaporation, Dehydration & Concentration of Foods in ICAR AIEEA-PG / PGS
Unit II lists evaporation and drying among unit operations and equipment, and Unit III lists dehydration and concentration methods. MCQs test definitions and comparisons: types of evaporators and dryers, concurrent versus countercurrent tunnels, drum versus spray drying, freeze-drying principles, IMF water activity range, and simple balances.
Removing water from liquid and solid foods: evaporator types and energy economy, drying theory and dryer design, spray, drum and freeze drying, concentration by freezing and membranes, and the quality changes that drying causes. Agricultural Engineering's post-harvest-cereals-pulses-oilseeds covers grain drying; this subject covers processed foods and powders.
Our 54 ICAR AIEEA-PG / PGS questions in this subject: 18 easy, 35 medium, 1 hard, across 12 units.
10 practice questions, worked
Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.
These 10 were written to ICAR AIEEA-PG / PGS and are not shown on any other exam's page.
Question 1 · easy
The dew point of a sample of air is the temperature at which
the air becomes saturated when cooled at constant humidity ratio
a wetted thermometer bulb settles to a steady reading in moving air
water boils at the local atmospheric pressure
the air holds its maximum enthalpy
Answer and working
A. the air becomes saturated when cooled at constant humidity ratio
Cooling at constant W raises RH until it reaches 100 % at the dew point; further cooling condenses water. The wetted-bulb reading is the wet-bulb temperature.
Question 2 · medium
In forward feed, liquid moves from effect to effect without pumps because
each later effect operates at a higher pressure
the liquid becomes less dense as it concentrates
each later effect operates at a lower pressure
the vapour pushes the liquid from the last effect to the first
Answer and working
C. each later effect operates at a lower pressure
Liquid flows naturally from higher to lower pressure, from the first effect to the last.
Question 3 · easy
The evaporator type most widely used for concentrating milk and fruit juices is the
open steam-jacketed pan
falling-film evaporator
short-tube natural-circulation evaporator
agitated thin-film evaporator
Answer and working
B. falling-film evaporator
Falling-film units give short residence times at low ΔT and suit multiple effects and MVR. Open pans and short-tube units give long residence times; agitated thin-film units are for very viscous products.
Question 4 · easy
A vegetable contains 80 % moisture on a wet basis. Its moisture content on a dry basis is
0.80 kg water/kg dry solids
0.25 kg water/kg dry solids
1.25 kg water/kg dry solids
4.0 kg water/kg dry solids
Answer and working
D. 4.0 kg water/kg dry solids
X = 0.80/0.20 = 4.0. 0.80 repeats the wet basis; 0.25 inverts the ratio; 1.25 is 1/0.80.
Question 5 · easy
During the constant-rate period of drying, the surface temperature of the product is close to
the wet-bulb temperature of the drying air
the dry-bulb temperature of the drying air
the dew-point temperature of the drying air
100 °C, the boiling point of water
Answer and working
A. the wet-bulb temperature of the drying air
With free water at the surface, heat input balances evaporation and the surface stays near the wet-bulb temperature, which is why hot air does little damage early in drying.
Question 6 · medium
Many fresh fruits and vegetables show little or no constant-rate drying period because
their cell structure limits free surface water almost from the start
they contain no water that can be removed by heated air at any temperature
their surfaces are always hotter than the dry-bulb temperature of the air
their water activity is below 0.5 even before drying begins
Answer and working
A. their cell structure limits free surface water almost from the start
Moisture must move through cell walls and tissue, so internal resistance controls the rate early. Fresh produce has high water content and aw near 1.
Question 7 · medium
Two-stage spray drying with an integrated fluidised bed saves energy because
the fluidised bed atomises the feed into droplets a second time
the second stage removes the fat that would otherwise burn
the fluidised bed operates at higher temperature than the main chamber
the bed finishes the last drying gently at lower temperature
Answer and working
D. the bed finishes the last drying gently at lower temperature
Removing the last water slowly in a fluid bed at moderate temperature is more efficient and gentler than doing it all in the main chamber.
Question 8 · medium
Secondary drying in a freeze-drying cycle removes
the frozen free water by sublimation
fat from the product by melting
air from the product by flushing
sorbed, unfrozen water by desorption
Answer and working
D. sorbed, unfrozen water by desorption
Primary drying sublimes ice; secondary drying desorbs bound water to low final moisture.
Question 9 · medium
Freeze-dried foods rehydrate rapidly mainly because
they contain more water than air-dried foods at the end of drying
they are coated with emulsifiers during the drying cycle
the rigid frozen structure leaves a porous, uncollapsed matrix
their cell walls are destroyed so they dissolve completely
Answer and working
C. the rigid frozen structure leaves a porous, uncollapsed matrix
Sublimation leaves pores where ice crystals were, allowing fast water uptake. Final moisture is low, and structure is preserved rather than dissolved.
Question 10 · medium
Air-dried vegetables never fully regain their original mass on rehydration mainly because
rehydration water evaporates faster than the vegetables can absorb it
the vegetables contain too much water after drying to take up more
drying causes irreversible tissue collapse and loss of turgor
dried vegetables are always coated with fat that repels water
Answer and working
C. drying causes irreversible tissue collapse and loss of turgor
Structural and chemical changes reduce water-holding ability, so the coefficient of rehydration is below 1.
A study plan for Evaporation, Dehydration & Concentration of Foods in ICAR AIEEA-PG / PGS
This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.
First, the heavy units (43% of the 54 questions): Psychrometry, humidification and dehumidification (7, 13%); Quality changes in dried foods and rehydration (6, 11%); Drying theory: constant-rate and falling-rate periods (5, 9%); Hot-air dryers: cabinet, tunnel, belt and fluidised-bed (5, 9%).
Read the manual chapters for these first and do every worked question you can find on them.
Then the middle band: Spray drying: atomisation, powder properties and agglomeration (5, 9%); Evaporation: boiling-point elevation and heat transfer (4, 7%); Falling-film, forced-circulation and plate evaporators (4, 7%); Freeze drying: principles, cycle design and collapse temperature (4, 7%).
Aim for one sitting per unit, then mixed questions across them.
Then the lighter units: Osmotic dehydration and intermediate-moisture foods (4, 7%); Single- and multiple-effect evaporators; steam economy (4, 7%); Drum drying (3, 6%); Freeze concentration and membrane concentration (3, 6%).
Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.
Leave time for the hard ones: Psychrometry, humidification and dehumidification (1 hard of 7).
Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.
Bank the easy marks: Evaporation: boiling-point elevation and heat transfer (2 easy of 4); Falling-film, forced-circulation and plate evaporators (2 easy of 4).
Do these early in revision so they are fast on the day.
Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.