LAISHA
Open Laisha

ICAR AICE-JRF/SRF Evaporation, Dehydration & Concentration of Foods: practice questions

ICAR AICE-JRF/SRF (PhD) — Food Processing Technology, Food Safety & Quality, Processing and Food Engineering · India · ICAR through the National Testing Agency

Original practice questions written to the published syllabus · not past papers
10worked here, free
69written to this exam in this subject
13syllabus units

About ICAR AICE-JRF/SRF

ICAR AICE-JRF/SRF (PhD) — Food Processing Technology, Food Safety & Quality, Processing and Food Engineering is a PhD, fellowship and lectureship exam run by ICAR through the National Testing Agency, for candidates in India. Computer-based, multiple choice.

Source: icar.org.in.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Evaporation, Dehydration & Concentration of Foods in ICAR AICE-JRF/SRF

35.a Units 2 and 5 cover dehydration and associated quality changes, solar drying and intermediate-moisture foods; 37 Unit 3 covers concentration and dehydration advances, freeze dehydration and glass transition in dried milks; 41 covers drying and evaporation machinery. Expect deeper questions on drying kinetics, collapse temperature, stickiness, vapour recompression and membrane concentration limits.

Removing water from liquid and solid foods: evaporator types and energy economy, drying theory and dryer design, spray, drum and freeze drying, concentration by freezing and membranes, and the quality changes that drying causes. Agricultural Engineering's post-harvest-cereals-pulses-oilseeds covers grain drying; this subject covers processed foods and powders.

Our 69 ICAR AICE-JRF/SRF questions in this subject: 2 easy, 47 medium, 20 hard, across 13 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to ICAR AICE-JRF/SRF and are not shown on any other exam's page.

Question 1 · medium

A plant wants to dry a heat-sensitive herb at 35 °C while still getting a fast rate. The most suitable air-treatment approach is

  1. humidify the inlet air with steam so that the herb does not lose its aroma during drying
  2. raise the air temperature to 90 °C and shorten the drying time to a few minutes only
  3. dehumidify the inlet air with a heat-pump or desiccant system before mild heating
  4. recirculate all of the exhaust air without venting, so that no heat at all is lost
Answer and working

C. dehumidify the inlet air with a heat-pump or desiccant system before mild heating

Lowering inlet humidity increases the drying driving force at low temperature. Humidifying slows drying; 90 °C damages the herb; full recirculation saturates the air and stops drying.

Question 2 · medium

Adding one thermocompressor to a multiple-effect evaporator usually improves steam economy by roughly the same amount as

  1. doubling the number of effects
  2. removing the condenser
  3. adding one more effect
  4. halving the feed rate
Answer and working

C. adding one more effect

A TVR unit typically gives a gain comparable to one extra effect; it does not double economy.

Question 3 · medium

Plate evaporators are attractive for smaller plants handling heat-sensitive products because they

  1. need no cleaning, since plates never foul with protein or minerals
  2. work only with very viscous products that cannot flow through tubes
  3. need no vacuum because the plates withstand any boiling temperature
  4. are compact, give short residence times and are extended by adding plates
Answer and working

D. are compact, give short residence times and are extended by adding plates

Plate units are compact, accessible for cleaning and expandable. They do foul and are usually run under vacuum.

Question 4 · hard

In the constant-rate period, the heat transfer coefficient is 30 W/m² K, the air is at 60 °C with wet-bulb temperature 30 °C, and the latent heat at 30 °C is 2,430 kJ/kg. The drying rate is closest to

  1. 0.370 kg/m² h
  2. 1.33 kg/m² h
  3. 2.67 kg/m² h
  4. 1333 kg/m² h
Answer and working

B. 1.33 kg/m² h

Rc = h(Ta − Tw)/λ = 30 × 30/2,430,000 kg/m² s = 3.70 × 10⁻⁴ kg/m² s = 1.33 kg/m² h. 0.370 leaves the result in g/m² s mislabelled; 2.67 uses the air temperature instead of the wet-bulb depression; 1333 forgets kJ-to-J conversion.

Question 5 · medium

A producer wants a light-coloured, aroma-rich instant fruit powder but has only a drum dryer available. Which modification best limits heat damage?

  1. Use a vacuum drum dryer so the film dries at a lower temperature
  2. Raise the steam pressure in the drum to finish drying faster
  3. Apply a thicker film so that the product spends longer on the drum
  4. Recycle the dried flakes back onto the drum for a second pass
Answer and working

A. Use a vacuum drum dryer so the film dries at a lower temperature

Vacuum drum drying lowers boiling and film temperatures. Higher steam pressure, thicker films and second passes increase heat damage.

Question 6 · hard

Lactose in whey concentrate is often pre-crystallised before spray drying to

  1. remove the lactose completely so that only protein remains
  2. avoid hygroscopic amorphous lactose that makes powder sticky
  3. increase the amount of amorphous lactose for better solubility
  4. convert lactose into glucose and galactose for sweetness
Answer and working

B. avoid hygroscopic amorphous lactose that makes powder sticky

Crystalline α-lactose monohydrate is non-hygroscopic; amorphous lactose absorbs water, passes its Tg and causes stickiness and caking.

Question 7 · medium

Soft pet foods and snack bars with aw around 0.85 usually also contain sorbate or another preservative mainly because

  1. most pathogenic bacteria grow fastest at water activities below 0.85
  2. the preservative is needed to lower the water activity further
  3. moulds and osmophilic yeasts still grow at this water activity
  4. preservatives prevent Maillard browning at intermediate water activity
Answer and working

C. moulds and osmophilic yeasts still grow at this water activity

Many bacteria are inhibited near 0.85, but moulds and yeasts grow to about 0.61–0.80, so extra hurdles such as preservatives and low pH are used.

Question 8 · medium

Ultrafiltration of milk differs from reverse osmosis in that ultrafiltration

  1. retains water, lactose and salts but passes proteins and fat
  2. retains proteins and fat but passes water, lactose and salts
  3. retains all solutes including lactose and salts
  4. passes everything except bacteria and somatic cells
Answer and working

B. retains proteins and fat but passes water, lactose and salts

UF is a fractionation that concentrates protein and fat; RO retains nearly all solutes; microfiltration removes bacteria.

Question 9 · medium

In freeze concentration, a ripening vessel after the scraped-surface crystalliser is used to

  1. melt all the ice so that it can be returned to the juice
  2. freeze the concentrate solid for storage
  3. add sugar to raise the freezing point
  4. let small ice crystals dissolve and large ones grow so they separate cleanly
Answer and working

D. let small ice crystals dissolve and large ones grow so they separate cleanly

Ostwald ripening produces large, uniform crystals that wash well in the separation column with little solute loss.

Question 10 · medium

Sulphur dioxide or sulphites are traditionally used on dried apricots mainly to

  1. increase water activity for a softer texture
  2. add sweetness to the dried fruit
  3. sterilise the fruit so that no drying is needed
  4. prevent browning and help retain colour and vitamin C
Answer and working

D. prevent browning and help retain colour and vitamin C

Sulphites inhibit enzymatic and non-enzymatic browning and protect ascorbic acid; their use is permitted and labelled in many but not all markets.

A study plan for Evaporation, Dehydration & Concentration of Foods in ICAR AICE-JRF/SRF

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (51% of the 69 questions): Freeze drying: principles, cycle design and collapse temperature (8, 12%); Spray drying: atomisation, powder properties and agglomeration (8, 12%); Drying theory: constant-rate and falling-rate periods (7, 10%); Freeze concentration and membrane concentration (6, 9%); Vapour recompression: thermal and mechanical (6, 9%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Falling-film, forced-circulation and plate evaporators (5, 7%); Osmotic dehydration and intermediate-moisture foods (5, 7%); Quality changes in dried foods and rehydration (5, 7%); Single- and multiple-effect evaporators; steam economy (5, 7%); Drum drying (4, 6%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Evaporation: boiling-point elevation and heat transfer (4, 6%); Hot-air dryers: cabinet, tunnel, belt and fluidised-bed (4, 6%); Psychrometry, humidification and dehumidification (2, 3%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Leave time for the hard ones: Quality changes in dried foods and rehydration (3 hard of 5), Spray drying: atomisation, powder properties and agglomeration (4 hard of 8), Drying theory: constant-rate and falling-rate periods (3 hard of 7).

    Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.

  5. Bank the easy marks: Falling-film, forced-circulation and plate evaporators (1 easy of 5); Vapour recompression: thermal and mechanical (1 easy of 6).

    Do these early in revision so they are fast on the day.

  6. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — ICAR AICE-JRF/SRF Evaporation, Dehydration & Concentration of Foods

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.