LAISHA
Open Laisha

GATE XE Fish & Seafood Processing Technology: practice questions

GATE — Engineering Sciences (XE), Section G Food Technology · India · IITs and IISc on rotation (2027: IIT Madras)

Original practice questions written to the published syllabus · not past papers
10worked here, free
38written to this exam in this subject
9syllabus units

About GATE XE

GATE — Engineering Sciences (XE), Section G Food Technology is a postgraduate admission exam run by IITs and IISc on rotation (2027: IIT Madras), for candidates in India. Computer-based, 3 hours, 100 marks. MCQ, MSQ and NAT. General Aptitude is common to every GATE paper; within XE, Section A Engineering Mathematics is compulsory (stated on the 2026 XE-A syllabus) and the candidate chooses two further sections, of which G Food Technology is one. The split of marks between GA, XE-A and the two chosen sections is from Laisha's knowledge of earlier brochures and was not re-read for 2026.

Source: gate2026.iitg.ac.in.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Fish & Seafood Processing Technology in GATE XE

Section 3 names drying, canning and freezing of fish. Expect conceptual items on post-mortem change, TMAO and TMA, why fish spoils faster than meat, glazing, freezer burn and protein denaturation, canned-fish defects such as struvite and blackening, and numerical-answer items on drying yield, glaze percentage, drip loss, water-phase salt and K value.

Handling and processing fish and shellfish: post-mortem spoilage and freshness, chilling and freezing at sea and ashore, canning, curing, smoking and drying, surimi and value-added products, and seafood safety hazards.

Our 38 GATE XE questions in this subject: 12 easy, 20 medium, 6 hard, across 9 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to GATE XE and are not shown on any other exam's page.

Question 1 · medium

In a fatty fish such as herring, as fat content rises through the feeding season, the water content of the flesh

  1. Rises, because fat tissue holds extra water
  2. Stays the same while protein content falls
  3. Falls, so fat plus water stays roughly constant
  4. Rises and falls independently of the fat content
Answer and working

C. Falls, so fat plus water stays roughly constant

Fat replaces water in the flesh of fatty fish, so the two vary inversely and their sum stays roughly constant. Fat tissue does not hold extra water, and the inverse relation is well established.

Question 2 · medium

Freshwater fish give low trimethylamine readings even when spoiled because they

  1. Lack spoilage bacteria
  2. Contain little TMAO
  3. Have very low pH
  4. Contain no protein nitrogen
Answer and working

B. Contain little TMAO

TMA comes from bacterial reduction of TMAO, which marine fish accumulate for osmoregulation and freshwater fish contain little of, so TMA is not a useful index in freshwater species. They do have spoilage bacteria, their pH is not especially low, and they contain protein.

Question 3 · medium

1000 g of glazed frozen shrimp weighs 850 g after the glaze is removed. The glaze, as a percentage of the glazed weight, is

  1. 15.0%
  2. 17.6%
  3. 85.0%
  4. 8.5%
Answer and working

A. 15.0%

Glaze = 1000 − 850 = 150 g; 150 ÷ 1000 × 100 = 15.0%. 17.6% expresses the glaze on the deglazed weight (150 ÷ 850); 85% is the net shrimp; 8.5% is a decimal slip.

Question 4 · medium

Whole tuna are precooked before canning mainly to

  1. Destroy histamine formed during frozen storage
  2. Sterilise the fish before packing
  3. Coagulate protein and ease loin cleaning
  4. Raise the oil content of the loins
Answer and working

C. Coagulate protein and ease loin cleaning

Precooking coagulates the protein, removes oil and water that would separate in the can, and makes it easy to remove skin, bones and dark meat. It does not destroy histamine, does not sterilise, and lowers rather than raises oil content.

Question 5 · easy

In kench salting of fish, the brine formed

  1. Is kept covering the fish
  2. Drains away from the fish
  3. Is boiled and reused
  4. Is replaced by vinegar
Answer and working

B. Drains away from the fish

Kench salting stacks fish with dry salt and lets the brine drain off; pickle curing keeps the fish in its own brine. Boiling brine and vinegar are not part of kench salting.

Question 6 · medium

100 kg of fresh fish at 80% moisture (wet basis) is dried to 15% moisture (wet basis). The dried yield is

  1. 23.5 kg
  2. 20.0 kg
  3. 18.8 kg
  4. 35.0 kg
Answer and working

A. 23.5 kg

Solids = 20 kg; dried mass = 20 ÷ 0.85 = 23.5 kg. 20 kg is bone-dry solids; 18.8 kg divides 15 by 0.80; 35 kg adds the final moisture percentage to the solids.

Question 7 · easy

Cold smoking of salmon is carried out at a temperature

  1. High enough to coagulate the protein
  2. Above 100 °C to sterilise the fish
  3. Below −18 °C to freeze the fish
  4. Below that at which the flesh cooks
Answer and working

D. Below that at which the flesh cooks

Cold smoking, commonly below about 30 °C, flavours and partly dries the fish but leaves it raw in texture; hot smoking cooks it. Smoking is not done above 100 °C or below freezing.

Question 8 · medium

1,000 kg of fish at 25 °C is to be cooled to 0 °C with melting ice. Taking the specific heat of fish as 3.35 kJ/kg K and the latent heat of ice as 335 kJ/kg, the ice melted just to cool the fish is

  1. 250 kg
  2. 25 kg
  3. 2,500 kg
  4. 1,000 kg
Answer and working

A. 250 kg

Heat removed = 1,000 × 3.35 × 25 = 83,750 kJ, and each kilogram of melting ice absorbs 335 kJ, so ice = 83,750/335 = 250 kg. In practice more ice is needed to absorb heat leaking in from the hold or boxes. 25 kg and 2,500 kg misplace the decimal. 1,000 kg assumes a 1:1 fish-to-ice ratio, which is a common field rule but not this calculation.

Question 9 · medium

Late in the air drying of salted fish, raising the air velocity barely speeds drying. The reason is that the process is in the

  1. Constant-rate period, set by air humidity
  2. Initial warm-up period, set by fish temperature
  3. Constant-rate period, set by surface evaporation
  4. Falling-rate period, set by internal diffusion
Answer and working

D. Falling-rate period, set by internal diffusion

Once the surface is no longer saturated, moisture must diffuse from the interior to the surface, and that internal resistance controls the rate; external air conditions then matter little. In the constant-rate period, by contrast, the surface behaves like free water and air velocity and humidity are decisive. The warm-up period is brief and occurs at the very start of drying, not late.

Question 10 · easy

1,000 kg of press cake at 55% moisture is dried to fish meal at 10% moisture. The water evaporated in the dryer is

  1. 450 kg
  2. 500 kg
  3. 550 kg
  4. 900 kg
Answer and working

B. 500 kg

Dry solids are conserved: 1,000 × 0.45 = 450 kg, so meal = 450/0.90 = 500 kg and water evaporated = 1,000 − 500 = 500 kg. 450 kg is the dry solids, not the water removed. 550 kg is the water originally present, which ignores the 10% remaining in the meal. 900 kg has no basis in the solids balance.

A study plan for Fish & Seafood Processing Technology in GATE XE

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (50% of the 38 questions): Chilling and freezing of fish (7, 18%); Fish canning (6, 16%); Surimi and fish mince products (6, 16%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Composition of fish and shellfish (5, 13%); Post-mortem changes and spoilage of fish (5, 13%); Salting, drying and smoking of fish (5, 13%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Freshness assessment: sensory, TVB-N, TMA and K value (2, 5%); Fish meal, fish oil and by-products (1, 3%); Shellfish and crustacean processing (1, 3%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Leave time for the hard ones: Shellfish and crustacean processing (1 hard of 1), Fish canning (2 hard of 6), Post-mortem changes and spoilage of fish (1 hard of 5).

    Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.

  5. Bank the easy marks: Fish meal, fish oil and by-products (1 easy of 1); Composition of fish and shellfish (2 easy of 5).

    Do these early in revision so they are fast on the day.

  6. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — GATE XE Fish & Seafood Processing Technology

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.