GATE — Engineering Sciences (XE), Section G Food Technology · India · IITs and IISc on rotation (2027: IIT Madras)
Original practice questions written to the published syllabus · not past papersGATE — Engineering Sciences (XE), Section G Food Technology is a postgraduate admission exam run by IITs and IISc on rotation (2027: IIT Madras), for candidates in India. Computer-based, 3 hours, 100 marks. MCQ, MSQ and NAT. General Aptitude is common to every GATE paper; within XE, Section A Engineering Mathematics is compulsory (stated on the 2026 XE-A syllabus) and the candidate chooses two further sections, of which G Food Technology is one. The split of marks between GA, XE-A and the two chosen sections is from Laisha's knowledge of earlier brochures and was not re-read for 2026.
Source: gate2026.iitg.ac.in.
Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.
Section 3 names packaging materials, aseptic packaging, and controlled and modified atmosphere storage; Section 4 names permeability through single and multilayer films. Expect questions on polymer barrier properties, laminate structures, MAP gas roles, aseptic package sterilisation, and numericals on film permeation, WVTR from cup tests and series barrier layers.
Packaging as part of the preservation system: materials and their barrier properties, package design and testing, metal cans, glass, paper and plastics, aseptic, modified-atmosphere, active and intelligent packaging, migration and food-contact law, and packaging sustainability. Agricultural Engineering's storage-engineering-packaging covers bulk storage and an introduction to packaging materials; this subject is the full packaging course.
Our 43 GATE XE questions in this subject: 17 easy, 16 medium, 10 hard, across 14 units.
Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.
These 10 were written to GATE XE and are not shown on any other exam's page.
Food glass containers are mainly made of
D. soda-lime-silica glass
Soda-lime-silica is cheap and suitable; borosilicate is used for laboratory and ovenware.
WVTR and OTR values must be reported with
D. the test temperature and humidity
Transmission rises with temperature and, for hydrophilic films, with humidity; values are meaningless without conditions.
In aseptic packaging, the filling zone is kept sterile mainly by
D. positive pressure of HEPA-filtered sterile air
Overpressure filtered air excludes contamination; surfaces are sterilised before production.
In modified-atmosphere packaging, carbon dioxide mainly
D. inhibits aerobic spoilage bacteria and moulds
CO2 inhibits Gram-negative aerobes such as Pseudomonas and moulds; N2 is the filler; O2 gives meat bloom.
Equilibrium MAP for fresh-cut produce relies on
B. film permeability matched to produce respiration
Transmission balances respiration at low O2, raised CO2, avoiding anaerobic fermentation.
Wax coatings on apples and citrus are an example of
C. edible coating
Waxes reduce moisture loss and add gloss.
A film has an OTR of 10 cm³/m² day measured at 1 atm oxygen partial pressure difference. A pack with 0.05 m² of this film sits in air (0.21 atm O₂) with essentially no oxygen inside. The daily oxygen ingress is about
A. 0.105 cm³/day
Permeation scales with area and with the partial pressure difference, so ingress = 10 × 0.05 × 0.21 = 0.105 cm³ per day. 0.5 cm³/day forgets that air contains only 21% oxygen, while the test used pure oxygen. 2.1 cm³/day multiplies OTR by 0.21 but ignores the small area. 0.0105 cm³/day slips a decimal place.
In a sealed LDPE bag of respiring fresh produce with a respiratory quotient near 1, the steady-state oxygen fall below 21% is usually much larger than the CO₂ rise above 0%. This is because
B. The film is several times more permeable to CO₂ than to O₂
At steady state, gas leaving or entering through the film equals respiratory exchange. With RQ near 1 the produce makes roughly as much CO₂ as it uses O₂, but polyolefins pass CO₂ about three to six times faster than O₂, so CO₂ escapes with a small build-up while O₂ must fall further to drive enough inflow. Tissue absorption is minor and not permanent. Nitrogen is inert.
LDPE has a density of 0.92 g/cm³. The mass of 1 m² of 50 µm LDPE film is
D. 46 g
Volume of 1 m² at 50 µm is 1 m² × 50 × 10⁻⁶ m = 5 × 10⁻⁵ m³, which is 50 cm³. Mass = 50 × 0.92 = 46 g, so the film's grammage is 46 g/m². 54 g divides thickness by density instead of multiplying. 4.6 g and 460 g misplace the decimal by a factor of ten. Film grammage is used to estimate material costs and pack weights.
A Gelbo flex test is run on a foil laminate before it is approved for a pouch that will be shipped long distances. The test checks
B. Pinhole formation and barrier loss on repeated flexing
The Gelbo tester twists and crushes film repeatedly, simulating handling and transport, after which pinholes are counted or oxygen and water vapour transmission are remeasured. Aluminium foil and metallised layers are especially prone to flex cracking. Tear resistance is measured by the Elmendorf test, seal strength by peel or hot-tack tests, and slip by coefficient of friction testing.
This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.
Read the manual chapters for these first and do every worked question you can find on them.
Aim for one sitting per unit, then mixed questions across them.
Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.
Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.
Do these early in revision so they are fast on the day.
Last updated · How Laisha writes and checks its pages · Report a mistake
US$10 a month · one price worldwide · cancel any time
| Free | Smarter | |
|---|---|---|
| Grow guides, pest pages, articles | Read all | Read all |
| Ask Laisha | 5 a day | Up to 1,000 a month |
| Exam practice | The sample on each page | Every question, timed papers |
| Crop calendar and pest alerts | — | For your own fields |
| Calculators and tools | — | All |
| Uploads and reports | — | 100 a month, real files |
An AI operating system for agriculture: free guides, manuals and tools written for every country.