GATE XE Principles of Food Science & Food Preservation: practice questions
GATE — Engineering Sciences (XE), Section G Food Technology · India · IITs and IISc on rotation (2027: IIT Madras)
Original practice questions written to the published syllabus · not past papers
10worked here, free
34written to this exam in this subject
12syllabus units
About GATE XE
GATE — Engineering Sciences (XE), Section G Food Technology is a postgraduate admission exam run by IITs and IISc on rotation (2027: IIT Madras), for candidates in India. Computer-based, 3 hours, 100 marks. MCQ, MSQ and NAT. General Aptitude is common to every GATE paper; within XE, Section A Engineering Mathematics is compulsory (stated on the 2026 XE-A syllabus) and the candidate chooses two further sections, of which G Food Technology is one. The split of marks between GA, XE-A and the two chosen sections is from Laisha's knowledge of earlier brochures and was not re-read for 2026.
Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.
Principles of Food Science & Food Preservation in GATE XE
The first map of the whole field: what food is, why it deteriorates, and the families of preservation (heat, cold, drying, chemicals, fermentation, irradiation, packaging and hurdles). Each family is studied in depth later; this subject teaches the logic that connects them.
Our 34 GATE XE questions in this subject: 4 easy, 21 medium, 9 hard, across 12 units.
10 practice questions, worked
Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.
These 10 were written to GATE XE and are not shown on any other exam's page.
Question 1 · medium
Which discovery of the 1860s explained why Appert's sealed, heated foods did not spoil?
Heat crystallised the sugars in food so that water became fully unavailable to decay
Heat killed the microorganisms that caused spoilage, and sealing kept others out
Heat destroyed the vitamins that spoilage organisms needed to begin to grow at all
Heat drove all oxygen from food, and oxygen alone was the cause of every kind of spoilage
Answer and working
B. Heat killed the microorganisms that caused spoilage, and sealing kept others out
Pasteur showed that microorganisms cause fermentation and spoilage and that heat kills them. Excluding oxygen alone does not prevent spoilage, as anaerobic spore-formers demonstrate.
Question 2 · medium
Hay-like off-flavours in frozen peas that were not blanched are mainly due to:
Lipoxygenase activity during frozen storage
Starch retrogradation in the frozen peas
Maillard browning during the freezing step
Growth of lactic acid bacteria at −18 °C
Answer and working
A. Lipoxygenase activity during frozen storage
Lipoxygenase oxidises unsaturated fatty acids to volatile off-flavour compounds, even in frozen storage; blanching inactivates it.
Question 3 · medium
What is the z value?
The temperature change that changes the D value tenfold
The pH below which Clostridium botulinum cannot grow at all
The time needed at 121.1 °C to kill twelve log cycles of spores
The number of log reductions delivered by a thermal process
Answer and working
A. The temperature change that changes the D value tenfold
z links D to temperature; for C. botulinum spores it is taken as 10 °C.
Question 4 · hard
A product is held at 115 °C for 10 min. Taking z = 10 °C, what is the equivalent lethality F0 at 121.1 °C?
About 10 min
About 0.61 min
About 2.45 min
About 40.7 min
Answer and working
C. About 2.45 min
F0 = 10 × 10^((115 − 121.1)/10) = 10 × 10^−0.61 ≈ 2.45 min. 40.7 inverts the exponent; 10 ignores the temperature difference.
Question 5 · easy
A product contains 80% moisture on a wet basis. What is its moisture on a dry basis?
0.25 kg/kg
4.0 kg/kg
1.25 kg/kg
0.8 kg/kg
Answer and working
B. 4.0 kg/kg
Dry basis = 0.80/0.20 = 4.0 kg water per kg solids. 0.25 is solids per water.
Question 6 · hard
1,000 kg of fruit at 85% moisture is dried to 12% moisture. What mass of dried product is obtained?
120.0 kg
170.5 kg
829.5 kg
150.0 kg
Answer and working
B. 170.5 kg
Solids = 150 kg; product = 150/0.88 = 170.5 kg. 150 kg ignores remaining water; 829.5 kg is the water removed.
Question 7 · medium
Why are liquid foods often evaporated under vacuum?
To raise the boiling temperature so that the product browns and caramelises
To sterilise the product without any heating at all
To lower the boiling temperature and protect heat-sensitive quality
To dissolve more air into the product for foaming
Answer and working
C. To lower the boiling temperature and protect heat-sensitive quality
Reduced pressure lowers the boiling point, limiting browning and flavour loss; multiple effects reuse vapour to save energy.
Question 8 · medium
Which vitamin is destroyed by sulphur dioxide, which is why sulphites are not used in meats?
Vitamin A
Riboflavin
Thiamin
Vitamin D
Answer and working
C. Thiamin
Sulphite cleaves thiamin; meats are an important thiamin source.
Question 9 · medium
Which radiation sources does the Codex General Standard for Irradiated Foods permit?
Gamma rays from cobalt-60 or caesium-137, X-rays and electrons up to 10 MeV
Gamma rays from any radioactive isotope and electrons of unlimited energy
Microwaves, infrared heaters and radio-frequency fields up to 100 MHz
Neutron beams from reactors, alpha particles and ultraviolet lamps of any power
Answer and working
A. Gamma rays from cobalt-60 or caesium-137, X-rays and electrons up to 10 MeV
Codex limits sources to those whose energies cannot induce radioactivity in food.
Question 10 · hard
A food absorbs 10 kGy. Treating it as water (4.18 kJ/kg K), by about how much does its temperature rise?
About 42 °C
About 0.24 °C
About 2.4 °C
About 24 °C
Answer and working
C. About 2.4 °C
10 kGy = 10 kJ/kg; ΔT = 10/4.18 ≈ 2.4 °C. That is why irradiation is called a cold process.
A study plan for Principles of Food Science & Food Preservation in GATE XE
This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.
First, the heavy units (62% of the 34 questions): Preservation by heat: blanching, pasteurisation and sterilisation (7, 21%); Preservation by removal of water: drying, concentration and intermediate-moisture foods (6, 18%); Preservation by chemicals, sugar, salt and smoke (4, 12%); Water activity and its relation to spoilage (4, 12%).
Read the manual chapters for these first and do every worked question you can find on them.
Then the middle band: Preservation by irradiation (3, 9%); Causes of food deterioration: microbial, enzymatic, chemical, physical and pest (2, 6%); Hurdle technology (2, 6%); Preservation by low temperature: chilling and freezing (2, 6%).
Aim for one sitting per unit, then mixed questions across them.
Then the lighter units: Food fortification and enrichment (1, 3%); Food groups, composition and food attributes: colour, texture, flavour and nutrition (1, 3%); History, scope and structure of the food industry worldwide (1, 3%); Raw-material quality factors for processing (1, 3%).
Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.
Leave time for the hard ones: Food fortification and enrichment (1 hard of 1), Water activity and its relation to spoilage (2 hard of 4), Preservation by heat: blanching, pasteurisation and sterilisation (3 hard of 7).
Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.
Bank the easy marks: Hurdle technology (1 easy of 2); Preservation by irradiation (1 easy of 3).
Do these early in revision so they are fast on the day.
Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.