LAISHA
Open Laisha

ICAR AIEEA-PG / PGS Transport Phenomena in Food Processing: Fluid Flow, Heat & Mass Transfer: practice questions

ICAR AIEEA-PG / PGS — Code 18 Food Science Technology · India · ICAR through the National Testing Agency

Original practice questions written to the published syllabus · not past papers
10worked here, free
56written to this exam in this subject
15syllabus units

About ICAR AIEEA-PG / PGS

ICAR AIEEA-PG / PGS — Code 18 Food Science Technology is a postgraduate admission exam run by ICAR through the National Testing Agency, for candidates in India. Computer-based, multiple choice, +4/−1 marking.

Source: icar.org.in.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Transport Phenomena in Food Processing: Fluid Flow, Heat & Mass Transfer in ICAR AIEEA-PG / PGS

Unit II names system analysis, mass and energy balance, heat and mass transfer, heat exchanging, steam generation and process equipment design. MCQs test definitions (Re, Nu, Bi, Fo), flow regimes, heat-exchanger types, steam quality and short calculations.

Mass and energy balances and the three transfer processes — momentum, heat and mass — applied to foods: pumping viscous products, heating cans and pouches, and moisture and gas movement through foods and packaging films.

Our 56 ICAR AIEEA-PG / PGS questions in this subject: 25 easy, 25 medium, 6 hard, across 15 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to ICAR AIEEA-PG / PGS and are not shown on any other exam's page.

Question 1 · easy

The SI unit of dynamic viscosity is

  1. Pa s
  2. N/m
  3. m²/s
  4. kg/m³
Answer and working

A. Pa s

Viscosity is shear stress (Pa) divided by shear rate (1/s), giving Pa s. m²/s is kinematic viscosity (or diffusivity); N/m is surface tension; kg/m³ is density.

Question 2 · easy

A pressure of 2.5 bar expressed in kilopascals is

  1. 25 kPa
  2. 2,500 kPa
  3. 250 kPa
  4. 0.25 kPa
Answer and working

C. 250 kPa

1 bar = 100 kPa, so 2.5 bar = 250 kPa.

Question 3 · easy

Water flows at 1.0 m/s in a 50 mm pipe that narrows to 25 mm. The velocity in the narrow section is

  1. 2.0 m/s
  2. 0.25 m/s
  3. 0.5 m/s
  4. 4.0 m/s
Answer and working

D. 4.0 m/s

v2 = v1(D1/D2)² = 1.0 × 4 = 4.0 m/s. 2.0 m/s uses the diameter ratio rather than its square; 0.25 and 0.5 m/s invert the ratio.

Question 4 · medium

In pipe flow of a yield-stress food such as mayonnaise, the central region where shear stress is below the yield stress

  1. stays completely stationary against the wall
  2. moves as a solid plug
  3. flows faster than the Newtonian parabola would predict
  4. boils because of frictional heating
Answer and working

B. moves as a solid plug

Below the yield stress the material does not deform, so it moves as an unsheared plug carried by the sheared annulus near the wall.

Question 5 · medium

A cold-store wall has 100 mm of polyurethane (k = 0.025 W/m K) with surface coefficients 10 W/m² K (inside) and 25 W/m² K (outside). Inside −25 °C, outside 30 °C. The heat gain per m² is closest to

  1. 13.8 W
  2. 102 W
  3. 13.3 W
  4. 393 W
Answer and working

C. 13.3 W

R = 1/25 + 0.1/0.025 + 1/10 = 4.14 m² K/W; q = 55/4.14 = 13.3 W. 13.8 W ignores the films; 102 W uses 10 mm of insulation instead of 100 mm; 393 W omits the insulation.

Question 6 · hard

A food surface at 20 °C (ε = 0.9) is in an oven whose walls are at 200 °C. The net radiant heat flux to the food is closest to

  1. 82 W/m²
  2. 2,178 W/m²
  3. 54 W/m²
  4. 2,420 W/m²
Answer and working

B. 2,178 W/m²

q = εσ(T1⁴ − T2⁴) = 0.9 × 5.67 × 10⁻⁸ × (473⁴ − 293⁴) = 2,178 W/m². 82 W/m² uses Celsius temperatures; 54 W/m² raises the difference to the fourth power; 2,420 W/m² omits ε.

Question 7 · hard

A film 25 µm thick has oxygen permeability P = 1 × 10⁻¹⁷ kg m/(m² s Pa). Through 0.5 m² with an oxygen partial-pressure difference of 20 kPa, the oxygen transmitted in one day is closest to

  1. 345.60 mg
  2. 345600 mg
  3. 4.00e-03 mg
  4. 0.3456 mg
Answer and working

A. 345.60 mg

q = PAtΔp/L = 10⁻¹⁷ × 0.5 × 86,400 × 20,000/(25 × 10⁻⁶) = 3.46e-04 kg = 345.60 mg. 345600 mg treats the thickness as 25 nm; 4.00e-03 mg is per second; 0.3456 mg uses 20 Pa instead of 20 kPa.

Question 8 · easy

In the solution–diffusion model of gas permeation through polymers, the permeability coefficient equals

  1. diffusivity ÷ solubility
  2. solubility ÷ thickness
  3. diffusivity × solubility
  4. thickness × pressure difference
Answer and working

C. diffusivity × solubility

P = D × S; flux = PΔp/L.

Question 9 · medium

Doubling the thickness of a single-layer packaging film, other conditions unchanged, changes the gas transmission rate by a factor of

  1. 2
  2. 0.25
  3. 0.5
  4. 1
Answer and working

C. 0.5

Flux = PΔp/L, so doubling L halves transmission.

Question 10 · medium

WVTR values of films must always be reported with

  1. the colour of the film
  2. the food's protein content
  3. the test temperature and relative humidity
  4. the pack's printed design
Answer and working

C. the test temperature and relative humidity

Transmission depends strongly on temperature and on the humidity gradient across the film.

A study plan for Transport Phenomena in Food Processing: Fluid Flow, Heat & Mass Transfer in ICAR AIEEA-PG / PGS

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (41% of the 56 questions): Material balances on mixing, concentration and drying (5, 9%); Pumps for foods: centrifugal and positive-displacement (5, 9%); Units, dimensions and dimensional analysis (5, 9%); Convection: film coefficients and dimensionless numbers (4, 7%); Energy balances and steam tables (4, 7%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Flow in pipes: Reynolds number, friction factor and pressure drop for Newtonian fluids (4, 7%); Permeability through single and multilayer films (4, 7%); Radiation heat transfer (4, 7%); Steady-state conduction through slabs, cylinders and composite walls (4, 7%); Flow of non-Newtonian foods in pipes (3, 5%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Fluid statics and the Bernoulli equation (3, 5%); Heat exchangers: plate, tubular and scraped-surface; LMTD and effectiveness (3, 5%); Molecular diffusion and Fick's law (3, 5%); Unsteady-state heat transfer: lumped systems and Heisler charts (3, 5%); Convective mass transfer (2, 4%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Leave time for the hard ones: Convective mass transfer (1 hard of 2), Material balances on mixing, concentration and drying (2 hard of 5), Molecular diffusion and Fick's law (1 hard of 3).

    Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.

  5. Bank the easy marks: Fluid statics and the Bernoulli equation (2 easy of 3); Material balances on mixing, concentration and drying (3 easy of 5).

    Do these early in revision so they are fast on the day.

  6. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — ICAR AIEEA-PG / PGS Transport Phenomena in Food Processing: Fluid Flow, Heat & Mass Transf

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.