LAISHA
Open Laisha

Agricultural and Biosystems Engineers Licensure Examination Agricultural Waste Management & Environmental Engineering: practice questions

Agricultural and Biosystems Engineers Licensure Examination (ABELE) · Philippines · Professional Regulatory Board of Agricultural and Biosystems Engineering, PRC

Original practice questions written to the published syllabus · not past papers
10worked here, free
67written to this exam in this subject
9syllabus units

About Agricultural and Biosystems Engineers Licensure Examination

Agricultural and Biosystems Engineers Licensure Examination (ABELE) is a licensing and registration exam run by Professional Regulatory Board of Agricultural and Biosystems Engineering, PRC, for candidates in Philippines. Paper-based, 2 days (Day 1 6 hours; Day 2 5 hours + 4 hours). Non-programmable calculator only; the Dec 2025 programme bans the Casio fx-991ES/ES Plus by name.

Source: prc.gov.ph.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Agricultural Waste Management & Environmental Engineering in Agricultural and Biosystems Engineers Licensure Examination

Waste management within the structures and environment paper: composting process and C:N, biogas and lagoon concepts, BOD and COD definitions, wastewater treatment stages, livestock waste handling, environmental impact assessment and the relevant Philippine laws and standards (check the current PAES and DENR texts).

Handling residues, manure and wastewater so that farms and plants do not pollute soil, water and air.

Our 67 Agricultural and Biosystems Engineers Licensure Examination questions in this subject: 31 easy, 33 medium, 3 hard, across 9 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to Agricultural and Biosystems Engineers Licensure Examination and are not shown on any other exam's page.

Question 1 · medium

Anaerobic lagoons are built relatively deep compared with facultative ponds mainly because depth:

  1. Removes the need for any liner in permeable soils
  2. Allows wind action to mix oxygen into the bottom sludge layer
  3. Increases surface area, which raises algal oxygen production
  4. Reduces surface area, lowering odour release and heat loss
Answer and working

D. Reduces surface area, lowering odour release and heat loss

For a given volume, a deeper lagoon has less surface, so less odour escapes and less heat is lost, which helps the anaerobic bacteria. Algal oxygen and wind mixing are features of facultative ponds; liner rules depend on soil and local standards, not depth.

Question 2 · easy

During the thermophilic phase of a well-managed compost pile, core temperatures are commonly in the range of:

  1. 25–40 °C
  2. 45–70 °C
  3. 15–25 °C
  4. 80–100 °C
Answer and working

B. 45–70 °C

Thermophilic microbes dominate from about 45 °C, and well-run piles commonly run 55–65 °C, which inactivates pathogens and weed seeds. Above roughly 70 °C microbial activity itself declines; 15–40 °C is mesophilic.

Question 3 · easy

The earthworm species most widely used in vermicomposting worldwide is:

  1. Aporrectodea caliginosa, an endogeic soil-feeding worm
  2. Lumbricus terrestris, an anecic deep-burrowing worm
  3. Eisenia fetida, an epigeic surface-dwelling worm
  4. Pheretima posthuma, a deep mineral-soil worm
Answer and working

C. Eisenia fetida, an epigeic surface-dwelling worm

Epigeic worms live in surface litter and eat organic matter, which suits vermicompost beds; Eisenia fetida (and in the tropics Eudrilus eugeniae) are the standard species. Anecic and endogeic worms burrow in mineral soil and do poorly in beds.

Question 4 · easy

A compost feedstock has 60% moisture on a wet basis. Its moisture on a dry basis is:

  1. 150%
  2. 60%
  3. 67%
  4. 40%
Answer and working

A. 150%

Per 100 kg wet: 60 kg water, 40 kg dry. Dry-basis moisture = 60/40 = 150%. 40% is the dry-matter fraction; 60% repeats the wet basis; 67% is 40/60.

Question 5 · easy

The '4R' framework of nutrient stewardship refers to the right:

  1. Soil, rainfall, tillage and yield
  2. Nitrogen, phosphorus, potassium and sulphur
  3. Source, rate, time and place
  4. Crop, cost, labour and machine
Answer and working

C. Source, rate, time and place

4R is right source, right rate, right time and right place, the organising idea of nutrient management plans.

Question 6 · medium

In the Leopold matrix, each interaction between a project action and an environmental component is scored for:

  1. Magnitude and importance, each on a 1–10 scale
  2. Area and depth, each in metric units
  3. Probability and duration, each as a percentage
  4. Cost and benefit, each in monetary units
Answer and working

A. Magnitude and importance, each on a 1–10 scale

The Leopold matrix (developed for the US Geological Survey) crosses project actions with environmental characteristics and scores each interaction for magnitude and importance on scales of 1 to 10.

Question 7 · medium

To show that manure spreading leads to nitrate leaching, then to well contamination, then to health effects in a village, the most suitable EIA identification method is:

  1. A single-layer map
  2. A network or cause-effect diagram
  3. A cost-benefit table
  4. A simple checklist
Answer and working

B. A network or cause-effect diagram

Networks trace chains of primary, secondary and tertiary impacts. Checklists only list factors; a single map shows location but not cause and effect.

Question 8 · easy

Overlay mapping in EIA, now usually done in a geographic information system, is mainly used to:

  1. Predict ammonia concentration with a dispersion model
  2. Record public objections at the hearing in sequence
  3. Locate environmentally sensitive areas by combining spatial layers
  4. Score each project action for cost per unit of impact
Answer and working

C. Locate environmentally sensitive areas by combining spatial layers

Overlays combine layers such as soils, slopes, water bodies and habitats to identify constraints and choose sites or routes. Dispersion modelling is a separate quantitative tool.

Question 9 · medium

An engineer preparing an EIA for a new distillery in one country uses the project category thresholds from another country's rules. This is wrong because:

  1. Thresholds apply only to private projects and never to distilleries
  2. Categories, thresholds and procedures are set nationally and are revised
  3. Distilleries are exempt from EIA under every international convention
  4. All countries use the same thresholds, so a foreign text is out of date
Answer and working

B. Categories, thresholds and procedures are set nationally and are revised

Which projects need EIA, the size thresholds, categories, timelines and hearing rules are national, and they are revised; the current official text of the country concerned must be used.

Question 10 · medium

An EIA for a new dairy plant considers an alternative site, an alternative treatment technology, and not building the plant. Including the 'no project' option is required because:

  1. It removes the need for a baseline survey of the existing environment
  2. It is the baseline against which all project impacts are compared
  3. It is always the option the authority must approve
  4. It guarantees that no mitigation will be needed
Answer and working

B. It is the baseline against which all project impacts are compared

The no-project alternative describes how the environment would evolve without the project and is the reference for judging impacts. It is not automatically chosen and does not replace the baseline study.

A study plan for Agricultural Waste Management & Environmental Engineering in Agricultural and Biosystems Engineers Licensure Examination

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (46% of the 67 questions): Composting (11, 16%); Crop-residue management (10, 15%); Environmental impact assessment (10, 15%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Basics of wastewater treatment (9, 13%); Manure handling systems (9, 13%); Wastewater characteristics: BOD and COD (6, 9%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Anaerobic lagoons (5, 7%); Nutrient management plans (4, 6%); Air quality and odour (3, 4%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Leave time for the hard ones: Crop-residue management (2 hard of 10), Anaerobic lagoons (1 hard of 5).

    Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.

  5. Bank the easy marks: Air quality and odour (2 easy of 3); Composting (6 easy of 11).

    Do these early in revision so they are fast on the day.

  6. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — Agricultural and Biosystems Engineers Licensure Examination Agricultural Waste Management

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.