Agricultural and Biosystems Engineers Licensure Examination (ABELE) · Philippines · Professional Regulatory Board of Agricultural and Biosystems Engineering, PRC
Original practice questions written to the published syllabus · not past papersAgricultural and Biosystems Engineers Licensure Examination (ABELE) is a licensing and registration exam run by Professional Regulatory Board of Agricultural and Biosystems Engineering, PRC, for candidates in Philippines. Paper-based, 2 days (Day 1 6 hours; Day 2 5 hours + 4 hours). Non-programmable calculator only; the Dec 2025 programme bans the Casio fx-991ES/ES Plus by name.
Source: prc.gov.ph.
Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.
Turning crop residues, dung and oils into fuel: briquettes, gasifiers, biogas plants and liquid biofuels, and auditing farm energy.
Our 52 Agricultural and Biosystems Engineers Licensure Examination questions in this subject: 19 easy, 28 medium, 5 hard, across 13 units.
Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.
These 10 were written to Agricultural and Biosystems Engineers Licensure Examination and are not shown on any other exam's page.
The difference between the higher (gross) and lower (net) heating value of a fuel is:
B. The latent heat of water vapour in the products, from fuel moisture and hydrogen combustion
HHV assumes all water in the products is condensed to liquid at the reference temperature, releasing its latent heat; LHV assumes it leaves as vapour. The water comes from fuel moisture and from burning hydrogen (9 kg water per kg H). Ash and flue-gas nitrogen losses are part of an appliance's efficiency, not of the HHV–LHV definition.
The dry flue gas from a husk-fired furnace contains 6% O2 by volume. Using the approximation excess air ≈ O2 ÷ (21 − O2), the excess air is about:
B. 40%
Excess air ≈ 6 ÷ (21 − 6) = 0.40, i.e. 40%. Dividing by 21 alone (28.6%) forgets that the excess air itself dilutes the gas. The approximation ignores small CO and fuel-oxygen effects but is the standard field check. 250% inverts the ratio (15 ÷ 6).
A charcoal maker wants a higher charcoal yield and less smoke than a traditional earth-mound kiln gives. The most effective change is to:
A. Use a retort or improved kiln that burns the pyrolysis vapours to heat the charge
In a mound kiln part of the wood itself is burned to supply heat, and the vapours escape as smoke. A retort heats the charge indirectly and burns the vapours as fuel, so more of the wood ends as charcoal and less as pollution. More air burns charcoal away; very high final temperatures raise fixed carbon but reduce yield; wet wood wastes heat on drying.
Wet scrubbing of producer gas with water in a village power plant creates a liquid effluent that:
B. Toxic; must be treated or recycled
Scrubber water collects condensed tar, phenolic compounds and fine char. It is toxic to aquatic life and can contaminate soil and groundwater. Good practice is closed-loop recirculation, separation of tar for burning, and treatment of bleed-off; many plants use dry filtration where possible to reduce this stream.
The correct order of the four stages of anaerobic digestion is:
C. Hydrolysis, acidogenesis, acetogenesis, methanogenesis
Complex polymers (carbohydrates, proteins, fats) are first hydrolysed to sugars, amino acids and fatty acids; acidogenic bacteria ferment these to volatile fatty acids, alcohols, H2 and CO2; acetogens convert the longer acids to acetate, H2 and CO2; methanogenic archaea finally produce methane from acetate or from H2 and CO2.
A farmer has 10 cattle, each giving 10 kg of fresh dung per day. The dung is mixed with water in a 1:1 ratio by mass, the slurry density is taken as 1000 kg/m³ and the hydraulic retention time is 40 days. The required digester volume is:
A. 8 m³
Dung = 10 × 10 = 100 kg/day; slurry (1:1) = 200 kg/day = 0.2 m³/day. Digester volume = daily slurry × HRT = 0.2 × 40 = 8 m³. Forgetting the added water gives 4 m³; 0.2 m³ is one day's feed, not the digester.
A family of 5 needs 0.34 m³ of biogas per person per day for cooking. The gas yield is 0.04 m³ per kg of fresh dung, dung is mixed 1:1 with water (slurry 1000 kg/m³), and the HRT is 50 days. The required digester volume is about:
C. 4.25 m³
Gas demand = 5 × 0.34 = 1.70 m³/day. Dung = 1.70 ÷ 0.04 = 42.5 kg/day; slurry = 85 kg/day = 0.085 m³/day. Volume = 0.085 × 50 = 4.25 m³. Multiplying gas demand by HRT (85.0 m³) confuses gas volume with slurry volume. 2.13 m³ forgets the dilution water (42.5 kg dung only, 0.0425 × 50).
The overall equation for the fermentation of glucose by yeast to ethanol is:
D. C6H12O6 → 2C2H5OH + 2CO2
Yeasts such as Saccharomyces cerevisiae convert each glucose molecule to two ethanol and two CO2 molecules under anaerobic conditions. Three CH4 plus three CO2 is the Buswell result for anaerobic digestion; the equation with O2 is aerobic respiration.
After an alkali-catalysed biodiesel reaction, the mixture is allowed to settle. The correct description is:
D. A lower glycerol layer holding most catalyst and soap separates from the upper ester layer
Glycerol (density about 1.26 kg/L) is much denser than methyl esters (about 0.88 kg/L) and poorly soluble in them, so it settles out. The ester layer still carries traces of methanol, catalyst, soap and glycerol, removed by washing (water or dry adsorbents) and drying to meet the specification's limits on free glycerol, water and residual methanol.
A rice mill processes 1000 t of paddy per season. Husk is 20% of paddy mass and has a heating value of 13 MJ/kg. The energy available in the husk is:
C. 2600 GJ
Husk = 1000 × 0.20 = 200 t = 200,000 kg. Energy = 200,000 × 13 MJ = 2,600,000 MJ = 2600 GJ. Using the whole paddy mass gives 13,000 GJ; the other options are unit slips (1 GJ = 1000 MJ). The husk share of paddy commonly lies near 20% but varies by variety and milling.
This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.
Read the manual chapters for these first and do every worked question you can find on them.
Aim for one sitting per unit, then mixed questions across them.
Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.
Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.
Do these early in revision so they are fast on the day.
Last updated · How Laisha writes and checks its pages · Report a mistake
US$10 a month · one price worldwide · cancel any time
| Free | Smarter | |
|---|---|---|
| Grow guides, pest pages, articles | Read all | Read all |
| Ask Laisha | 5 a day | Up to 1,000 a month |
| Exam practice | The sample on each page | Every question, timed papers |
| Crop calendar and pest alerts | — | For your own fields |
| Calculators and tools | — | All |
| Uploads and reports | — | 100 a month, real files |
An AI operating system for agriculture: free guides, manuals and tools written for every country.