LAISHA
Open Laisha

Agricultural and Biosystems Engineers Licensure Examination Sprinkler & Micro-Irrigation Systems: practice questions

Agricultural and Biosystems Engineers Licensure Examination (ABELE) · Philippines · Professional Regulatory Board of Agricultural and Biosystems Engineering, PRC

Original practice questions written to the published syllabus · not past papers
10worked here, free
45written to this exam in this subject
14syllabus units

About Agricultural and Biosystems Engineers Licensure Examination

Agricultural and Biosystems Engineers Licensure Examination (ABELE) is a licensing and registration exam run by Professional Regulatory Board of Agricultural and Biosystems Engineering, PRC, for candidates in Philippines. Paper-based, 2 days (Day 1 6 hours; Day 2 5 hours + 4 hours). Non-programmable calculator only; the Dec 2025 programme bans the Casio fx-991ES/ES Plus by name.

Source: prc.gov.ph.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Sprinkler & Micro-Irrigation Systems in Agricultural and Biosystems Engineers Licensure Examination

Designing and evaluating sprinkler and drip systems, from emitter hydraulics to pump selection.

Our 45 Agricultural and Biosystems Engineers Licensure Examination questions in this subject: 30 easy, 15 medium, 0 hard, across 14 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to Agricultural and Biosystems Engineers Licensure Examination and are not shown on any other exam's page.

Question 1 · easy

A centre pivot irrigates a full circle inscribed in a square field with no corner arm or end gun. What fraction of the square is irrigated?

  1. 100 %
  2. About 63.7 % (2/π)
  3. About 78.5 % (π/4)
  4. 50 %
Answer and working

C. About 78.5 % (π/4)

Circle area πr² divided by square area (2r)² = π/4 ≈ 0.785. 2/π (63.7 %) confuses the area ratio with a different circle constant; the corners (about 21.5 %) stay dry unless a corner system or end gun is used. 100 % ignores the dry corners; 50 % treats the circle as half the square.

Question 2 · medium

A centre pivot lateral is 400 m long from pivot to the last sprinkler (no end gun). What area does it irrigate?

  1. 64.0 ha
  2. 50.3 ha
  3. 16.0 ha
  4. 12.6 ha
Answer and working

B. 50.3 ha

Area = πr² = π × 400² = 502655 m² = 50.3 ha. 64.0 ha is the enclosing square (800 m × 800 m); 16.0 ha is 400 m × 400 m; 12.6 ha treats 400 m as the diameter.

Question 3 · easy

What value of Christiansen's uniformity coefficient indicates perfectly uniform application?

  1. 0 %
  2. 100 %
  3. 50 %
  4. 85 %
Answer and working

B. 100 %

If every can catches the mean depth, the sum of absolute deviations is zero and CU = 100 %. 85 % is a commonly cited design target for high-value crops, not the ideal. 0 % and 50 % have no special meaning for CU; 0 % would require deviations as large as the mean.

Question 4 · easy

Where on a pressurised mainline should combination air-release and vacuum-relief valves be installed?

  1. At high points and at the pump discharge
  2. Only at the lowest point
  3. Immediately upstream of every sprinkler
  4. Only at the end of each lateral
Answer and working

A. At high points and at the pump discharge

Air collects at high points and must be released during filling and operation; vacuum relief at high points prevents pipe collapse and suction when the line drains. Low points get drain valves instead.

Question 5 · easy

Christiansen's rule limits pressure variation along a sprinkler lateral to about 20 % of the operating pressure. What discharge variation does this correspond to?

  1. About 20 %
  2. About 10 %
  3. About 40 %
  4. About 4 %
Answer and working

B. About 10 %

Nozzle discharge varies with the square root of pressure, so a 20 % pressure change gives about √1.2 − 1 ≈ 9.5 % (or 1 − √0.8 ≈ 10.6 %) change, i.e. about 10 %. 20 % would be true only if discharge were proportional to pressure. 40 % doubles the pressure variation instead of roughly halving it; 4 % squares the 20 % fraction (0.2² = 0.04).

Question 6 · medium

An emitter discharges 2.0 L/h at 100 kPa and 2.2 L/h at 150 kPa. What is its discharge exponent x?

  1. 0.200
  2. 0.235
  3. 0.500
  4. 4.25
Answer and working

B. 0.235

x = ln(q1/q2)/ln(h1/h2) = ln(2.2/2.0)/ln(150/100) = 0.0953/0.4055 = 0.235. 0.200 is the ratio of percentage changes (10 %/50 %), a linear approximation that is poor for a 50 % change; 4.25 inverts the ratio. 0.500 simply assumes a fully turbulent emitter.

Question 7 · easy

Which filter is effective for removing sand from well water but ineffective against algae and organic matter?

  1. Media (sand) filter
  2. Hydrocyclone (centrifugal sand separator)
  3. Disc filter
  4. Screen filter with 200 mesh
Answer and working

B. Hydrocyclone (centrifugal sand separator)

A hydrocyclone separates particles denser than water by centrifugal action; algae and organic matter have densities close to water and pass through. Media filters are preferred for organic loads.

Question 8 · easy

Approximately what opening size corresponds to a 120-mesh screen?

  1. About 1.20 mm
  2. About 12 µm
  3. About 75 µm
  4. About 125 µm
Answer and working

D. About 125 µm

120 mesh (120 openings per inch) has openings of about 0.125 mm = 125 µm. About 75 µm corresponds to 200 mesh. About 1.20 mm and about 12 µm are factor-of-ten slips.

Question 9 · easy

When should a drip system filter be backflushed or cleaned?

  1. Only at the end of each season
  2. When pressure drop rises
  3. Whenever the pump is started
  4. When the emitters have visibly clogged or the plants begin to show water stress
Answer and working

B. When pressure drop rises

Filters are cleaned on a pressure-differential criterion read from gauges or a differential switch (or on a timer). Waiting for emitter clogging means the filter has already failed.

Question 10 · medium

A common rule for selecting filtration fineness for drip emitters is that the filter should remove particles:

  1. Equal in size to the emitter passage
  2. Twice as large as the emitter passage, since smaller particles usually pass straight through
  3. Several times smaller than the smallest emitter passage, per the maker
  4. Only those visible to the eye
Answer and working

C. Several times smaller than the smallest emitter passage, per the maker

Particles smaller than the passage can still bridge and aggregate, so filters are chosen several times finer than the passage (sources quote fractions from about one-quarter to one-tenth); the manufacturer's recommendation governs.

A study plan for Sprinkler & Micro-Irrigation Systems in Agricultural and Biosystems Engineers Licensure Examination

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (51% of the 45 questions): Drip system components (6, 13%); Sprinkler types and components (5, 11%); Economics of pressurised irrigation (4, 9%); Filtration (4, 9%); Sprinkler spacing and application rate (4, 9%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Allowable pressure variation and the friction factor F (3, 7%); Automation (3, 7%); Christiansen's uniformity coefficient (3, 7%); Fertigation (3, 7%); Sprinkler lateral and main design (3, 7%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Drip lateral and sub-main design (2, 4%); Emitter hydraulics: exponent and coefficient of variation (2, 4%); System layout and pump selection (2, 4%); Emission uniformity (1, 2%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Bank the easy marks: Drip lateral and sub-main design (2 easy of 2); System layout and pump selection (2 easy of 2).

    Do these early in revision so they are fast on the day.

  5. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — Agricultural and Biosystems Engineers Licensure Examination Sprinkler & Micro-Irrigation S

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.