LAISHA
Open Laisha

GATE XE Shelf-life Science & Food Stability: practice questions

GATE — Engineering Sciences (XE), Section G Food Technology · India · IITs and IISc on rotation (2027: IIT Madras)

Original practice questions written to the published syllabus · not past papers
10worked here, free
26written to this exam in this subject
6syllabus units

About GATE XE

GATE — Engineering Sciences (XE), Section G Food Technology is a postgraduate admission exam run by IITs and IISc on rotation (2027: IIT Madras), for candidates in India. Computer-based, 3 hours, 100 marks. MCQ, MSQ and NAT. General Aptitude is common to every GATE paper; within XE, Section A Engineering Mathematics is compulsory (stated on the 2026 XE-A syllabus) and the candidate chooses two further sections, of which G Food Technology is one. The split of marks between GA, XE-A and the two chosen sections is from Laisha's knowledge of earlier brochures and was not re-read for 2026.

Source: gate2026.iitg.ac.in.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Shelf-life Science & Food Stability in GATE XE

Section 3 names hurdle technology and intermediate-moisture foods and packaging; Section 1 names chemical changes during processing; Section 4 names permeability through films. Expect numericals on first-order kinetics and half-lives, Q10 and Arrhenius, and film-limited moisture gain.

Predicting and proving how long a food stays safe and acceptable: the kinetics of quality loss, temperature and water-activity effects, accelerated shelf-life testing, packaging-limited shelf life, challenge tests and date labelling.

Our 26 GATE XE questions in this subject: 6 easy, 13 medium, 7 hard, across 6 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to GATE XE and are not shown on any other exam's page.

Question 1 · easy

A chilled ready-to-eat salad that could support Listeria growth should carry a

  1. best-before date, since quality is the only concern
  2. date of manufacture only, with no expiry
  3. use-by date
  4. sell-by date intended for the retailer only
Answer and working

C. use-by date

Safety-limited foods carry use-by dates; best-before is for quality-limited foods.

Question 2 · medium

The hurdle concept explains the stability of intermediate-moisture foods by

  1. one severe treatment, usually full sterilisation in a retort
  2. freezing the product to below −18 °C
  3. removing all water from the product
  4. several moderate barriers combined
Answer and working

D. several moderate barriers combined

Moderate aw reduction, pH, preservatives and packaging combine to inhibit microbes while keeping quality.

Question 3 · medium

For a first-order quality loss, a straight line is obtained by plotting

  1. A against time
  2. 1/A against time
  3. A against ln time
  4. ln A against time
Answer and working

D. ln A against time

ln(A/A0) = −kt; a plot of A against t is linear for zero order.

Question 4 · easy

A product has a shelf life of 30 days at 35 °C and Q10 = 2.5. Its estimated shelf life at 25 °C is

  1. 12 days
  2. 32.5 days
  3. 300 days
  4. 75 days
Answer and working

D. 75 days

ts(25) = 30 × 2.5 = 75 days. 12 divides; 32.5 adds; 300 multiplies by 10.

Question 5 · medium

A quality reaction has a z value of 25 °C. Its Q10 is

  1. 0.40
  2. 2.51
  3. 25.0
  4. 4.00
Answer and working

B. 2.51

Q10 = 10^(10/z) = 10^0.4 = 2.51. 0.40 is the exponent; 4.00 multiplies 10 × 0.4.

Question 6 · easy

Most spoilage bacteria cannot grow below a water activity of about

  1. 0.99
  2. 0.90
  3. 0.60
  4. 0.30
Answer and working

B. 0.90

Most bacteria need aw above about 0.90; moulds grow to about 0.80; nothing grows below about 0.6.

Question 7 · hard

In a moist cake with crisp biscuit pieces, moisture moves from

  1. the biscuit to the cake, from lower to higher aw
  2. the cake to the biscuit, from higher to lower aw
  3. nowhere, because both are in the same pack
  4. the pack film into the cake only
Answer and working

B. the cake to the biscuit, from higher to lower aw

Water migrates down the aw gradient until aw is equal; matching aw or a barrier prevents sogginess.

Question 8 · hard

A pack can tolerate 10 cm³ of oxygen; 2 cm³ remains after flushing; area is 0.05 m² and OTR 4 cm³/m² day. The oxygen-limited shelf life is

  1. 40 days
  2. 50 days
  3. 8 days
  4. 200 days
Answer and working

A. 40 days

(10 − 2)/(4 × 0.05) = 8/0.2 = 40 days. 50 ignores residual O2; 8 omits the ingress rate; 200 omits area.

Question 9 · medium

Milk in clear plastic bottles develops off-flavours under shop lighting mainly through

  1. Maillard browning at 4 °C
  2. hydrolysis of lactose by light
  3. photo-oxidation sensitised by riboflavin
  4. growth of Clostridium bacteria in the light
Answer and working

C. photo-oxidation sensitised by riboflavin

Light excites riboflavin, producing singlet oxygen and off-flavours; opaque or pigmented packs protect it.

Question 10 · medium

Bread staling during storage is mainly due to

  1. amylopectin retrogradation
  2. fat oxidation
  3. yeast growth
  4. protein hydrolysis
Answer and working

A. amylopectin retrogradation

Amylopectin recrystallises over days, firming the crumb; mould limits safety and quality too.

A study plan for Shelf-life Science & Food Stability in GATE XE

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (50% of the 26 questions): Kinetics of quality loss: zero- and first-order reactions (7, 27%); Temperature dependence: Arrhenius equation and Q10 (6, 23%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Water activity, sorption isotherms and moisture-limited shelf life (5, 19%); Shelf-life concepts: safety-limited and quality-limited shelf life (4, 15%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Packaging-limited shelf life and permeability calculations (3, 12%); Shelf life of specific product groups (1, 4%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Leave time for the hard ones: Packaging-limited shelf life and permeability calculations (2 hard of 3), Water activity, sorption isotherms and moisture-limited shelf life (2 hard of 5), Temperature dependence: Arrhenius equation and Q10 (2 hard of 6).

    Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.

  5. Bank the easy marks: Shelf-life concepts: safety-limited and quality-limited shelf life (2 easy of 4); Kinetics of quality loss: zero- and first-order reactions (2 easy of 7).

    Do these early in revision so they are fast on the day.

  6. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — GATE XE Shelf-life Science & Food Stability

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.