LAISHA
Open Laisha

GATE XE Physical Properties, Rheology & Texture of Foods: practice questions

GATE — Engineering Sciences (XE), Section G Food Technology · India · IITs and IISc on rotation (2027: IIT Madras)

Original practice questions written to the published syllabus · not past papers
10worked here, free
30written to this exam in this subject
7syllabus units

About GATE XE

GATE — Engineering Sciences (XE), Section G Food Technology is a postgraduate admission exam run by IITs and IISc on rotation (2027: IIT Madras), for candidates in India. Computer-based, 3 hours, 100 marks. MCQ, MSQ and NAT. General Aptitude is common to every GATE paper; within XE, Section A Engineering Mathematics is compulsory (stated on the 2026 XE-A syllabus) and the candidate chooses two further sections, of which G Food Technology is one. The split of marks between GA, XE-A and the two chosen sections is from Laisha's knowledge of earlier brochures and was not re-read for 2026.

Source: gate2026.iitg.ac.in.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Physical Properties, Rheology & Texture of Foods in GATE XE

Section 4 names flow of Newtonian fluids and heat transfer; Section 1 names starch gelatinisation and retrogradation. Rheology and physical properties appear as the inputs to flow and heat-transfer calculations (viscosity, power-law parameters, thermal properties) and in reasoning about starch and gel behaviour.

Measuring and modelling how foods flow, deform, break and transfer heat: rheometry of fluids and gels, viscoelasticity, texture profile analysis, and thermal, electrical and optical properties. Agricultural Engineering's engineering-properties-biomaterials covers size, shape, density and friction of grains and produce; this subject goes deeper into processed foods and their measurement.

Our 30 GATE XE questions in this subject: 7 easy, 16 medium, 7 hard, across 7 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to GATE XE and are not shown on any other exam's page.

Question 1 · medium

Porosity strongly lowers the thermal conductivity of a dry food mainly because

  1. air in the pores conducts heat better than water
  2. porosity increases the specific heat of the solids
  3. pores always fill with ice during storage
  4. air in the pores conducts heat very poorly
Answer and working

D. air in the pores conducts heat very poorly

Air (about 0.025 W/m K) is a good insulator, so porous foods conduct poorly.

Question 2 · medium

Shear rates in the mouth during swallowing of liquids are commonly quoted as around

  1. 50 s⁻¹
  2. 10⁻⁶ s⁻¹
  3. 10⁵ s⁻¹
  4. 10⁸ s⁻¹
Answer and working

A. 50 s⁻¹

About 50 s⁻¹ is often used for sensory thickness, though values vary; 10⁻⁶ s⁻¹ is sedimentation and 10⁵ s⁻¹ homogenisation.

Question 3 · easy

A power-law fluid with n = 1 is

  1. shear-thinning
  2. shear-thickening
  3. Newtonian
  4. a Bingham plastic
Answer and working

C. Newtonian

With n = 1, τ = Kγ̇ and K equals the viscosity.

Question 4 · medium

On a log–log plot of shear stress against shear rate for a power-law fluid, the slope equals

  1. the flow behaviour index n
  2. the consistency coefficient K
  3. the yield stress
  4. the apparent viscosity
Answer and working

A. the flow behaviour index n

log τ = log K + n log γ̇: slope n, intercept log K.

Question 5 · hard

Mayonnaise holds its shape on a spoon but spreads under a knife. The model that best describes it is

  1. Newtonian
  2. power law without yield stress
  3. ideal Hookean solid
  4. Herschel–Bulkley
Answer and working

D. Herschel–Bulkley

A yield stress plus shear-thinning above it is Herschel–Bulkley.

Question 6 · medium

The yield stress of a sauce is best measured without wall-slip errors using

  1. a glass capillary viscometer
  2. a vane geometry rotated slowly
  3. a falling-ball viscometer
  4. a refractometer
Answer and working

B. a vane geometry rotated slowly

The vane shears within the sample, avoiding slip at smooth walls and disturbing the structure little.

Question 7 · hard

In an Ostwald viscometer, water (998 kg/m³, 1.00 mPa s) flows in 60 s and a syrup (1,200 kg/m³) in 300 s. The syrup's viscosity is closest to

  1. 5.0 mPa s
  2. 4.2 mPa s
  3. 7.2 mPa s
  4. 6.0 mPa s
Answer and working

D. 6.0 mPa s

μs = μw (ρs ts)/(ρw tw) = 1.00 × (1,200 × 300)/(998 × 60) = 6.0 mPa s. 5.0 ignores densities; 4.2 inverts the density ratio; 7.2 uses 1,200/1,000 × 300/50.

Question 8 · easy

In the farinograph, water absorption is the amount of water needed to bring the dough consistency peak to

  1. 500 Brabender units
  2. 100 Brabender units
  3. 1,000 Brabender units
  4. the falling-number value
Answer and working

A. 500 Brabender units

The 500 BU line is the standard reference consistency.

Question 9 · hard

A flour with a low falling number most likely

  1. came from sprouted, high-amylase wheat
  2. came from wheat with very low enzyme activity
  3. has a very high gluten content
  4. contains added malt to raise the falling number
Answer and working

A. came from sprouted, high-amylase wheat

High α-amylase liquefies the gelatinised paste so the plunger falls quickly; malt is added to raise activity when the falling number is high.

Question 10 · hard

Using P = 2πfε0ε″E² with f = 2.45 GHz, ε0 = 8.854 × 10⁻¹² F/m, ε″ = 15 and E = 1,000 V/m, the power absorbed per unit volume is closest to

  1. 3.25 × 10⁵ W/m³
  2. 2.04 × 10³ W/m³
  3. 2.04 × 10⁶ W/m³
  4. 1.06 × 10⁷ W/m³
Answer and working

C. 2.04 × 10⁶ W/m³

P = 2π × 2.45 × 10⁹ × 8.854 × 10⁻¹² × 15 × 10⁶ = 2.04 × 10⁶ W/m³. Omitting 2π gives 3.25 × 10⁵; using E instead of E² gives a value 1,000 times smaller; 1.06 × 10⁷ uses the dielectric constant ε′ (about 78) instead of the loss factor ε″.

A study plan for Physical Properties, Rheology & Texture of Foods in GATE XE

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (60% of the 30 questions): Electrical and dielectric properties of foods (6, 20%); Fundamentals of rheology: stress, strain and viscosity (6, 20%); Newtonian and non-Newtonian fluids: power-law, Herschel-Bulkley and Casson models (6, 20%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Rheology of doughs and dairy gels (4, 13%); Thermal properties: specific heat, thermal conductivity and diffusivity of foods (4, 13%); Rotational and capillary viscometry (3, 10%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Physical properties of foods: density, porosity and particle size distribution (1, 3%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Leave time for the hard ones: Electrical and dielectric properties of foods (3 hard of 6), Rotational and capillary viscometry (1 hard of 3), Rheology of doughs and dairy gels (1 hard of 4).

    Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.

  5. Bank the easy marks: Fundamentals of rheology: stress, strain and viscosity (2 easy of 6); Rotational and capillary viscometry (1 easy of 3).

    Do these early in revision so they are fast on the day.

  6. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — GATE XE Physical Properties, Rheology & Texture of Foods

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.