LAISHA
Open Laisha

GATE Farm Power Sources: practice questions

GATE — Agricultural Engineering (AG) · India · IITs and IISc on rotation (2027: IIT Madras)

Original practice questions written to the published syllabus · not past papers
10worked here, free
46written to this exam in this subject
9syllabus units

About GATE

GATE — Agricultural Engineering (AG) is a postgraduate admission exam run by IITs and IISc on rotation (2027: IIT Madras), for candidates in India. Computer-based, 3 hours, 100 marks (15 General Aptitude + 85 technical: 25 one-mark and 30 two-mark questions). MCQ, MSQ and NAT; negative marking on MCQ only (−1/3 for one-mark, −2/3 for two-mark); no partial credit on MSQ. On-screen virtual calculator.

Source: gate2027.iitm.ac.in.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Farm Power Sources in GATE

Section 3 'Sources of Power': short calculations and NAT questions on power in wind (½ρAV³, Betz limit), PV fill factor and module area or efficiency, biogas plant sizing, and power from draught and speed. Unit handling (kgf, km/h, metric hp) decides marks.

Where the energy for farm work comes from, how much is available, and how mechanisation is measured.

Our 46 GATE questions in this subject: 14 easy, 14 medium, 18 hard, across 9 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to GATE and are not shown on any other exam's page.

Question 1 · easy

Standard agricultural engineering textbooks commonly take the mechanical power an adult worker can sustain over a working day as roughly:

  1. 0.075–0.1 kW
  2. 0.75–1.0 kW
  3. 7.5–10 W
  4. 0.3–0.4 kW
Answer and working

A. 0.075–0.1 kW

About 0.1 hp, i.e. roughly 75 W, is the usual textbook figure for continuous work; planning studies often use about 0.05 kW. 0.75–1 kW is only reachable for a few seconds in a sprint, and 0.3–0.4 kW is closer to a draught animal's output.

Question 2 · hard

A worker lifts 2400 litres of water through 5 m by hand in one hour. What is the useful (water-lifting) power output?

  1. 3.33 W
  2. 1,962 W
  3. 32.7 W
  4. 0.33 W
Answer and working

C. 32.7 W

P = mgh/t = 2400 × 9.81 × 5 / 3600 = 32.7 W (1 litre of water = 1 kg). Forgetting g gives 3.33 W; dividing by 60 instead of 3600 (minutes for seconds) gives 1,962 W, which no person can sustain. 0.33 W is a factor-of-ten slip on the 3.33 W value.

Question 3 · hard

A diesel engine delivers 30 kW brake power while consuming 8 L/h of fuel (density 0.84 kg/L, calorific value 42 MJ/kg). What is its brake thermal efficiency?

  1. 32.1%
  2. 38.3%
  3. 27.0%
  4. 3.83%
Answer and working

B. 38.3%

Fuel energy rate = 8 × 0.84 × 42 = 282.24 MJ/h = 78.4 kW. Efficiency = 30/78.4 = 38.3%. Ignoring density gives 32.1%; dividing by density instead of multiplying gives 27.0%. 3.83% is a factor-of-ten slip.

Question 4 · easy

The Betz limit states that the maximum fraction of the power in the wind that an ideal rotor can extract is:

  1. 1/2, 50%
  2. 16/27, about 59.3%
  3. 8/27, about 29.6%
  4. 100%, if the rotor is large enough
Answer and working

B. 16/27, about 59.3%

Betz's analysis shows the maximum power coefficient is 16/27 ≈ 0.593, because air must keep flowing through the rotor. Real rotors achieve less.

Question 5 · easy

If wind speed doubles, the power in the wind:

  1. Doubles
  2. Increases four times
  3. Is unchanged
  4. Increases eight times
Answer and working

D. Increases eight times

Power ∝ V³, so 2³ = 8. Four times would be the effect of doubling rotor diameter (area ∝ D²).

Question 6 · hard

Wind speed measured at 10 m is 5 m/s over open farmland. Using the power law with exponent 1/7, estimate the speed at a 30 m hub height.

  1. 15.00 m/s
  2. 5.85 m/s
  3. 8.66 m/s
  4. 5.00 m/s
Answer and working

B. 5.85 m/s

V30 = 5 × (30/10)^(1/7) = 5 × 1.1699 = 5.85 m/s. Scaling linearly with height gives 15 m/s; using a square root gives 8.66 m/s. The power gain is (1.170)³ ≈ 1.60 times.

Question 7 · easy

The main constituents of biogas from a cattle-dung digester are:

  1. Methane 50–70%, CO2 30–45%
  2. Carbon monoxide about 20% and hydrogen about 15%, rest nitrogen
  3. Methane about 95% with traces of CO2
  4. Hydrogen about 60% and oxygen about 30%
Answer and working

A. Methane 50–70%, CO2 30–45%

Biogas is mainly CH4 and CO2 with small H2S and water vapour. The CO + H2 + N2 mix describes producer gas from gasification; 95% methane is upgraded biomethane or natural gas.

Question 8 · hard

A digester yields 3.2 m³ of biogas per day with a calorific value of 20 MJ/m³. If a gas engine-generator converts 25% of the gas energy to electricity, how much electricity is produced per day?

  1. 17.78 kWh
  2. 16.0 kWh
  3. 71.1 kWh
  4. 4.44 kWh
Answer and working

D. 4.44 kWh

Gas energy = 3.2 × 20 = 64 MJ = 64/3.6 = 17.78 kWh; electricity = 0.25 × 17.78 = 4.44 kWh. 17.78 kWh is the fuel energy; 16.0 is MJ mislabelled as kWh. 71.1 kWh divides by the 25% efficiency instead of multiplying (17.78/0.25).

Question 9 · hard

A block has 400 ha net sown area, 25 tractors of 30 kW, 10 power tillers of 9 kW, 150 electric motors of 5 kW, 60 diesel engines of 4 kW, 300 draught animals (0.38 kW each) and 900 workers (0.05 kW each). What is the farm power availability?

  1. 4.58 kW/ha
  2. 4.97 kW/ha
  3. 2.84 kW/ha
  4. 1.88 kW/ha
Answer and working

B. 4.97 kW/ha

Total = 750 + 90 + 750 + 240 + 114 + 45 = 1,989 kW; ÷ 400 ha = 4.97 kW/ha. Excluding people and animals gives 4.58; counting tractors only gives 1.88; dividing by a gross cropped area of 700 ha gives 2.84.

Question 10 · medium

Why do mechanisation studies count a draught animal at a conventional figure of a few tenths of a kW rather than its peak output?

  1. The factor represents sustained usable power over working hours, not a brief maximum
  2. Peak output cannot be measured at all
  3. Animals always pull exactly 0.38 kW at any speed
  4. Conventional factors include the power of the implement
Answer and working

A. The factor represents sustained usable power over working hours, not a brief maximum

Animals and people can exceed their conventional figures briefly, but planning needs sustained power. Factors are conventions, differ between studies, and must be stated.

A study plan for Farm Power Sources in GATE

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (46% of the 46 questions): Wind power as a farm power source (8, 17%); Solar power as a farm power source (7, 15%); Biomass and biofuels as power sources (6, 13%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Human power and its limits (6, 13%); Mechanical power: engines and tractors (6, 13%); Animal draught power and harnessing (5, 11%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Electrical power on the farm (3, 7%); Farm power availability (kW/ha) (3, 7%); Mechanisation indices (2, 4%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Leave time for the hard ones: Electrical power on the farm (2 hard of 3), Wind power as a farm power source (4 hard of 8), Biomass and biofuels as power sources (3 hard of 6).

    Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.

  5. Bank the easy marks: Animal draught power and harnessing (2 easy of 5); Wind power as a farm power source (3 easy of 8).

    Do these early in revision so they are fast on the day.

  6. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — GATE Farm Power Sources

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.