GATE — Agricultural Engineering (AG) · India · IITs and IISc on rotation (2027: IIT Madras)
Original practice questions written to the published syllabus · not past papersGATE — Agricultural Engineering (AG) is a postgraduate admission exam run by IITs and IISc on rotation (2027: IIT Madras), for candidates in India. Computer-based, 3 hours, 100 marks (15 General Aptitude + 85 technical: 25 one-mark and 30 two-mark questions). MCQ, MSQ and NAT; negative marking on MCQ only (−1/3 for one-mark, −2/3 for two-mark); no partial credit on MSQ. On-screen virtual calculator.
Source: gate2027.iitm.ac.in.
Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.
Numerical: net and gross irrigation depth from field capacity, present moisture and bulk density; irrigation interval from available water, MAD and ETc; area a tubewell can command; Kc × ET₀; weir and flume discharge; application, storage and uniformity (Christiansen CU, low-quarter DU) calculations. Most items need a calculation; watch mass versus volume basis and unit conversions.
How much water a crop needs, when to give it, how to measure and convey it, and how to design surface irrigation.
Our 71 GATE questions in this subject: 28 easy, 34 medium, 9 hard, across 14 units.
Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.
These 10 were written to GATE and are not shown on any other exam's page.
Cumulative infiltration in a basin follows the Kostiakov equation I = 1.5 t^0.5, with I in cm and t in hours. How long must water stand to infiltrate 4.5 cm?
D. 9 h
t = (I / a)^(1/b) = (4.5 / 1.5)^2 = 3² = 9 h. 3 h forgets to square (it treats the exponent as 1); 6 h doubles instead of squaring; 1.5 h confuses the coefficient with time.
Class A pan evaporation is 8.0 mm/day, the pan coefficient is 0.70 and the crop coefficient is 1.10. What is the crop evapotranspiration?
C. 6.16 mm/day
ET₀ = Kp × Epan = 0.70 × 8.0 = 5.60 mm/day; ETc = Kc × ET₀ = 1.10 × 5.60 = 6.16 mm/day. 5.60 stops at ET₀; 8.80 skips the pan coefficient; 12.57 divides by Kp instead of multiplying.
For the same crop and climate, which condition gives the highest Kc ini?
B. Light irrigation every two days
In the initial stage ET is dominated by soil evaporation, so Kc ini rises with the frequency of surface wetting and can approach 1.0 or more. Infrequent wetting, mulches and fast-drying sands keep the surface dry and Kc ini low.
Using the USDA SCS formula as simplified in FAO CROPWAT, what is the effective rainfall for a month with 200 mm of rain?
C. 136 mm
For P ≤ 250 mm: Pe = P (125 − 0.2P)/125 = 200 × (125 − 40)/125 = 136 mm. 145 mm uses the P > 250 mm branch (125 + 0.1P); 160 mm is a fixed 80 %; 200 mm treats all rain as effective.
A wheat scheduling recommendation is an IW/CPE ratio of 0.8 with an irrigation depth of 50 mm. At what cumulative pan evaporation since the last irrigation should the next irrigation be given?
D. 62.5 mm
CPE = IW / ratio = 50 / 0.8 = 62.5 mm. 40 mm multiplies instead of dividing; 50 mm ignores the ratio; 80 mm confuses the ratio with the CPE.
When flow is estimated with surface floats, the float velocity is multiplied by a coefficient less than one because:
C. Surface velocity is higher than the mean velocity over the section
Velocity is highest near the surface and lowest near the bed and banks, so mean velocity is typically about 0.8–0.9 of surface velocity. Wind can push floats either way, and area is a separate measurement.
A lined rectangular channel is to have a flow area of 2.0 m² and the best hydraulic section. What are its depth and width?
A. Depth 1.0 m, width 2.0 m
For the best rectangle b = 2y, so A = 2y² = 2.0 and y = 1.0 m, b = 2.0 m. A square section (1.41 × 1.41) has a larger wetted perimeter (4.24 m versus 4.0 m); the others are further from optimum.
Which of these is an earth-type (non-rigid, soil-based) canal lining?
B. Soil-cement
Soil-cement, compacted earth and bentonite blankets are earth linings. Concrete, brick and asphaltic concrete are hard-surface linings.
What is the purpose of cutback irrigation in furrows?
C. To advance quickly with a large stream, then reduce it to about the intake rate to limit runoff
A large initial stream reduces advance time and the head-tail opportunity-time difference; reducing it after advance matches inflow to intake and cuts tailwater. Starting small slows advance, the opposite of the aim.
A wheat crop yields 6,000 kg/ha of grain with a seasonal ET of 500 mm. What is its crop water use efficiency?
A. 1.2 kg/m³
500 mm on 1 ha = 0.5 m × 10,000 m² = 5,000 m³. WUE = 6,000 / 5,000 = 1.2 kg/m³. The others are factor-of-ten or hundred slips in converting mm·ha to m³. 12 and 0.12 kg/m³ are factor-of-ten slips, and 120 kg/m³ a factor-of-hundred slip.
This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.
Read the manual chapters for these first and do every worked question you can find on them.
Aim for one sitting per unit, then mixed questions across them.
Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.
Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.
Do these early in revision so they are fast on the day.
Last updated · How Laisha writes and checks its pages · Report a mistake
US$10 a month · one price worldwide · cancel any time
| Free | Smarter | |
|---|---|---|
| Grow guides, pest pages, articles | Read all | Read all |
| Ask Laisha | 5 a day | Up to 1,000 a month |
| Exam practice | The sample on each page | Every question, timed papers |
| Crop calendar and pest alerts | — | For your own fields |
| Calculators and tools | — | All |
| Uploads and reports | — | 100 a month, real files |
An AI operating system for agriculture: free guides, manuals and tools written for every country.