ICAR AICE-JRF/SRF (PhD) — Agricultural Engineering subjects 38–43 · India · National Testing Agency for ICAR
Original practice questions written to the published syllabus · not past papersICAR AICE-JRF/SRF (PhD) — Agricultural Engineering subjects 38–43 is a PhD, fellowship and lectureship exam run by National Testing Agency for ICAR, for candidates in India. LAN-based computer test, 2 hours, 120 MCQs: 20 Part A (general knowledge and reasoning), 50 Part B (core group), 50 Part C (specialisation); four options.
Source: icar.org.in.
Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.
PG-depth theory: assumptions of Hooghoudt, Ernst, Kirkham and Glover-Dumm, equivalent depth, drainable porosity, envelope design criteria, USBR dynamic equilibrium, bio-drainage and vertical drainage, reclamation chemistry and the gypsum requirement.
Removing excess water and salt: surface and subsurface drain design, and reclaiming saline and sodic land.
Our 59 ICAR AICE-JRF/SRF questions in this subject: 1 easy, 36 medium, 22 hard, across 11 units.
Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.
These 10 were written to ICAR AICE-JRF/SRF and are not shown on any other exam's page.
In a piezometer nest, the piezometer open at 2 m depth has its water level 0.8 m below the ground surface and the one open at 6 m depth has its water level 0.3 m below the surface. What is the direction and magnitude of the vertical hydraulic gradient between them?
A. Upward, gradient 0.125
Taking the ground surface as datum, head at 2 m = -0.8 m and at 6 m = -0.3 m. The deeper point has the higher head, so water moves upward. Gradient = 0.5 m / (6 - 2) m = 0.125. Reporting 0.5 forgets to divide by the 4 m distance; 'downward' reads the levels as depths instead of heads. Upward seepage means relief wells or drains designed for extra inflow.
Over six consecutive days the water-table depths were 5, 15, 25, 35, 20 and 40 cm. What is SEW30 for this period?
C. 55 cm-days
SEW30 sums (30 - depth) only for days when the water table is shallower than 30 cm: 25 + 15 + 5 + 10 = 55 cm-days; the 35 and 40 cm days add nothing. 40 wrongly subtracts the deep days; 65 adds depths instead of excesses; 4 counts days.
In Hiler's stress day index (SDI) for drainage design, what are the two factors multiplied for each growth stage?
A. A stress-day factor such as SEW30 and a crop susceptibility factor for that stage
SDI = sum of (SD x CS): the stress-day factor measures how wet the soil was, and the crop susceptibility factor measures how sensitive the crop is at that stage. The other pairs are design inputs, not stress indices.
Ernst: q = 6 mm/day, L = 40 m, Kv = 0.5 m/day over Dv = 0.3 m above drains, transmissivity Sum(KD) = 4.0 m2/day, radial layer Kr = 0.8 m/day and Dr = 5 m, wetted perimeter u = 0.3 m, a = 1. What total midpoint head h results?
D. 0.57 m
hv = qDv/Kv = 0.006 x 0.3 / 0.5 = 0.0036 m. hh = qL^2 / (8 Sum KD) = 0.006 x 1600 / 32 = 0.300 m. hr = (qL / pi Kr) ln(Dr/u) = (0.24 / 2.513) x ln(16.67) = 0.269 m. Total = 0.57 m. 0.30 m keeps only the horizontal term; 0.42 m uses log10 in the radial term; 0.27 m is the radial term alone.
Glover-Dumm: K = 1.0 m/day, average flow depth D = 4.5 m, drainable porosity 0.05, initial midpoint head 1.0 m above drains, required head 0.7 m after 3 days (initial shape a fourth-degree parabola). What drain spacing is needed?
C. 73 m
L^2 = pi^2 K D t / [mu ln(1.16 h0/ht)] = 9.870 x 1.0 x 4.5 x 3 / [0.05 x ln(1.657)] = 133.2 / (0.05 x 0.5051) = 5276 m2; L = 73 m. 23 m omits pi^2; 67 m uses 1.27 (flat initial water table); 7.3 m enters porosity as 5 instead of 0.05.
In the Glover-Dumm spacing equation, with all else unchanged, the drainable porosity of a soil is found to be twice the design value. The required spacing becomes:
C. The original spacing divided by about 1.41
L^2 is inversely proportional to mu, so L scales with 1/sqrt(mu): doubling mu divides L by sqrt 2 = 1.41. More water must drain per metre of fall, so drains must be closer, not wider.
Mole drainage is best suited to which situation?
A. A stable clay subsoil in which an unlined channel keeps its shape
A mole plough forms an unlined channel that survives only in cohesive, stable clay. It collapses in sand, cannot be drawn through stones, and deforms in peat.
Vertical drainage by tubewells is most attractive where:
D. A transmissive aquifer lies beneath and the pumped water is fresh enough to reuse
The pumped water then becomes an irrigation supply, giving conjunctive use. Thin clay over rock and perched tables have no aquifer to pump; saline water without an outlet creates a disposal problem.
Controlled drainage (drainage water management) with an adjustable outlet structure is used mainly to:
D. Raise the drain water level when drainage is not needed, conserving water and cutting nitrate losses
Raising the outlet holds water in the profile outside critical periods and cuts nitrate export; it is lowered before field operations.
Using the leaching relation (C/C0)(Dw/Ds) = 0.3 for continuous ponding, how much water must infiltrate to reduce salinity in the top 0.6 m to 20 % of its initial value?
C. 0.9 m
Dw = k x Ds / (C/C0) = 0.3 x 0.6 / 0.2 = 0.9 m. 0.3 m uses k = 0.1, which applies to intermittent ponding; 0.036 m multiplies by C/C0; 3.0 m omits k. Constants are soil-specific; confirm in a trial.
This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.
Read the manual chapters for these first and do every worked question you can find on them.
Aim for one sitting per unit, then mixed questions across them.
Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.
Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.
Do these early in revision so they are fast on the day.
Last updated · How Laisha writes and checks its pages · Report a mistake
US$10 a month · one price worldwide · cancel any time
| Free | Smarter | |
|---|---|---|
| Grow guides, pest pages, articles | Read all | Read all |
| Ask Laisha | 5 a day | Up to 1,000 a month |
| Exam practice | The sample on each page | Every question, timed papers |
| Crop calendar and pest alerts | — | For your own fields |
| Calculators and tools | — | All |
| Uploads and reports | — | 100 a month, real files |
An AI operating system for agriculture: free guides, manuals and tools written for every country.