LAISHA
Open Laisha

ICAR AICE-JRF/SRF Soil Science for Engineers: practice questions

ICAR AICE-JRF/SRF (PhD) — Agricultural Engineering subjects 38–43 · India · National Testing Agency for ICAR

Original practice questions written to the published syllabus · not past papers
10worked here, free
83written to this exam in this subject
9syllabus units

About ICAR AICE-JRF/SRF

ICAR AICE-JRF/SRF (PhD) — Agricultural Engineering subjects 38–43 is a PhD, fellowship and lectureship exam run by National Testing Agency for ICAR, for candidates in India. LAN-based computer test, 2 hours, 120 MCQs: 20 Part A (general knowledge and reasoning), 50 Part B (core group), 50 Part C (specialisation); four options.

Source: icar.org.in.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Soil Science for Engineers in ICAR AICE-JRF/SRF

PG-depth questions on soil water potential and retention curves, unsaturated conductivity and the Richards equation, infiltration theory (Green-Ampt, Philip sorptivity), hysteresis, reclamation chemistry and gypsum requirement, and land capability classification.

The soil an engineer tills, irrigates, drains and builds on: its physical, water and chemical properties.

Our 83 ICAR AICE-JRF/SRF questions in this subject: 2 easy, 50 medium, 31 hard, across 9 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to ICAR AICE-JRF/SRF and are not shown on any other exam's page.

Question 1 · medium

In the World Reference Base for Soil Resources (WRB), which Reference Soil Group is defined by high soluble salt content?

  1. Gleysols
  2. Solonetz
  3. Calcisols
  4. Solonchaks
Answer and working

D. Solonchaks

Solonchaks are the saline soils of WRB. Solonetz have a dense, sodium-rich subsoil horizon (sodic rather than saline), Gleysols are groundwater-affected, and Calcisols have secondary calcium carbonate accumulation.

Question 2 · hard

Using Stokes' law at 20 °C (viscosity 1.002 × 10⁻³ Pa s, Δρ = 1650 kg/m³), what is the settling velocity of a 0.02 mm silt particle?

  1. 0.718 mm/s
  2. 0.090 mm/s
  3. 0.577 mm/s
  4. 0.359 mm/s
Answer and working

D. 0.359 mm/s

v = 9.81 × (2 × 10⁻⁵)² × 1650/(18 × 1.002 × 10⁻³) = 3.590 × 10⁻⁴ m/s = 0.359 mm/s. 0.090 puts the 0.01 mm radius in place of the diameter; 0.577 uses particle density 2650 instead of the density difference; 0.718 uses 9η in place of 18η.

Question 3 · easy

Why does a clay soil usually have a higher total porosity than a sandy soil, yet drain and aerate more poorly?

  1. Its particles are denser than sand grains, so the remaining pores are smaller and fewer
  2. Its total porosity is in fact always lower than that of a sand when measured correctly
  3. Most of its pores are fine and stay water-filled, with few large drainable pores
  4. Its large pores are filled with organic matter, which blocks the flow of water and air
Answer and working

C. Most of its pores are fine and stay water-filled, with few large drainable pores

Clays have many tiny pores, so total porosity is high, but those pores stay water-filled at field suctions. Clay particle density is similar to sand, measured total porosity is usually higher in clays, and organic matter does not fill the large pores.

Question 4 · hard

Using de Vries' coefficients (minerals 1.92, organic matter 2.51, water 4.18 MJ m⁻³ K⁻¹), what is the volumetric heat capacity of a soil with 0.50 volume fraction of minerals, no organic matter and volumetric water content 0.30?

  1. 3.17 MJ m⁻³ K⁻¹
  2. 0.96 MJ m⁻³ K⁻¹
  3. 2.21 MJ m⁻³ K⁻¹
  4. 3.05 MJ m⁻³ K⁻¹
Answer and working

C. 2.21 MJ m⁻³ K⁻¹

C = 1.92 × 0.50 + 4.18 × 0.30 = 0.96 + 1.254 = 2.21 MJ m⁻³ K⁻¹ (air contributes almost nothing). 0.96 omits the water; 3.17 forgets to weight the minerals by their volume fraction; 3.05 is an unweighted average.

Question 5 · medium

Why do poorly drained soils warm up more slowly in spring than well-drained soils of the same texture?

  1. Wet soils have a lower particle density, so each cubic metre holds less mineral matter
  2. Water raises their heat capacity and evaporation from the wet surface consumes energy
  3. Water lowers their thermal conductivity so that no heat can reach the subsoil
  4. Wet soils reflect almost all incoming solar radiation because water is highly reflective
Answer and working

B. Water raises their heat capacity and evaporation from the wet surface consumes energy

Water has the highest volumetric heat capacity of any soil constituent (4.18 MJ m⁻³ K⁻¹), and evaporation uses latent heat. Wetting actually raises thermal conductivity, wet soils are darker and absorb more radiation, and particle density does not change with wetness.

Question 6 · medium

For the Kostiakov equation I = 2.5 t^0.6 (I in cm, t in hours), what is the infiltration rate at t = 2 hours?

  1. 3.79 cm/h
  2. 1.50 cm/h
  3. 1.89 cm/h
  4. 1.14 cm/h
Answer and working

D. 1.14 cm/h

Rate = dI/dt = a b t^(b−1) = 2.5 × 0.6 × 2^(−0.4) = 1.14 cm/h. 3.79 is the cumulative depth; 1.89 is the average rate over the first 2 hours, which is higher than the instantaneous rate; 1.50 is the rate at 1 hour.

Question 7 · medium

The permanent negative charge of 2:1 clay minerals such as montmorillonite arises mainly from:

  1. Protonation of hydroxyl groups at broken edges when the soil pH falls
  2. Isomorphous substitution, such as Mg²⁺ for Al³⁺ in the octahedral sheet
  3. Adsorption of nitrate and chloride anions onto the planar clay surfaces
  4. Dissociation of hydrogen from carboxyl groups on the edges of the clay
Answer and working

B. Isomorphous substitution, such as Mg²⁺ for Al³⁺ in the octahedral sheet

Substitution of a lower-valence cation during crystal formation (Al³⁺ for Si⁴⁺, Mg²⁺ for Al³⁺) leaves a permanent negative charge independent of pH. Carboxyl dissociation is the pH-dependent charge of humus; protonation at low pH creates positive, not negative, charge; and anion adsorption is not the source.

Question 8 · medium

Residual sodium carbonate (RSC) of an irrigation water is calculated as:

  1. (CO₃²⁻ + HCO₃⁻)/(Ca²⁺ + Mg²⁺), all in mmol/L
  2. Na⁺ − (CO₃²⁻ + HCO₃⁻), all in milligrams per litre
  3. (Ca²⁺ + Mg²⁺) − (CO₃²⁻ + HCO₃⁻), all in meq/L
  4. (CO₃²⁻ + HCO₃⁻) − (Ca²⁺ + Mg²⁺), all in meq/L
Answer and working

D. (CO₃²⁻ + HCO₃⁻) − (Ca²⁺ + Mg²⁺), all in meq/L

RSC = (CO₃²⁻ + HCO₃⁻) − (Ca²⁺ + Mg²⁺) in meq/L. A positive RSC means carbonate and bicarbonate exceed calcium and magnesium, which precipitate as carbonates and leave sodium dominant. The reversed difference, a ratio, or mg/L are wrong forms.

Question 9 · hard

How many tonnes of gypsum dihydrate (equivalent weight 86.09 g/eq) are equivalent in reclamation value to 1 t of elemental sulphur (equivalent weight 16 g/eq)?

  1. 2.69 t
  2. 0.19 t
  3. 10.76 t
  4. 5.38 t
Answer and working

D. 5.38 t

Sulphur oxidises to H₂SO₄, which supplies 2 equivalents per mole of S (32 g), so its equivalent weight is 16 g/eq. One tonne of S therefore carries 10⁶/16 equivalents, and the same equivalents of gypsum weigh 10⁶/16 × 86.09 g: 1 t S ≈ 86.09/16 = 5.38 t gypsum. 0.19 t is the inverse (tonnes of S per tonne of gypsum); 2.69 t uses the molar mass of S with the equivalent weight of gypsum; 10.76 t uses the molar mass of gypsum with the equivalent weight of S.

Question 10 · medium

Why is gypsum not used to raise the pH of an acid soil?

  1. It reacts with exchangeable aluminium to form more acidity and so lowers the pH further
  2. It is a neutral salt that supplies calcium and sulphate but does not neutralise acidity
  3. It is too insoluble to react with soil acidity in any reasonable period of time
  4. It raises the pH too sharply and causes zinc and iron deficiency in the first season
Answer and working

B. It is a neutral salt that supplies calcium and sulphate but does not neutralise acidity

CaSO₄ is the salt of a strong acid and a strong base; it replaces exchangeable cations but adds no base to neutralise H⁺. It can still help in acid subsoils by supplying Ca and reducing Al toxicity. Gypsum is sparingly but sufficiently soluble, does not raise pH sharply, and does not create acidity.

A study plan for Soil Science for Engineers in ICAR AICE-JRF/SRF

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (41% of the 83 questions): Problem soils: saline, sodic and acid (12, 14%); Bulk density, particle density and porosity (11, 13%); Soil chemistry: pH and electrical conductivity (11, 13%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Soil formation and profile (10, 12%); Infiltration (9, 11%); Hydraulic conductivity and Darcy's law (8, 10%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Sodicity: SAR and ESP (8, 10%); Soil texture and structure (7, 8%); Soil water: field capacity, wilting point and available water (7, 8%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Leave time for the hard ones: Sodicity: SAR and ESP (5 hard of 8), Soil water: field capacity, wilting point and available water (4 hard of 7), Problem soils: saline, sodic and acid (6 hard of 12).

    Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.

  5. Bank the easy marks: Bulk density, particle density and porosity (1 easy of 11); Soil chemistry: pH and electrical conductivity (1 easy of 11).

    Do these early in revision so they are fast on the day.

  6. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — ICAR AICE-JRF/SRF Soil Science for Engineers

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.