LAISHA
Open Laisha

ICAR AICE-JRF/SRF Protected Cultivation & Greenhouse Engineering: practice questions

ICAR AICE-JRF/SRF (PhD) — Agricultural Engineering subjects 38–43 · India · National Testing Agency for ICAR

Original practice questions written to the published syllabus · not past papers
10worked here, free
71written to this exam in this subject
13syllabus units

About ICAR AICE-JRF/SRF

ICAR AICE-JRF/SRF (PhD) — Agricultural Engineering subjects 38–43 is a PhD, fellowship and lectureship exam run by National Testing Agency for ICAR, for candidates in India. LAN-based computer test, 2 hours, 120 MCQs: 20 Part A (general knowledge and reasoning), 50 Part B (core group), 50 Part C (specialisation); four options.

Source: icar.org.in.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Protected Cultivation & Greenhouse Engineering in ICAR AICE-JRF/SRF

Subject 40 Unit 9 and subject 43 Unit 5 name protected cultivation: greenhouse types and cladding properties, heat balance and ventilation, fan-pad cooling, fertigation equipment, hydroponics and plastic mulch and lining. Expect quick recall and one-step calculations at PhD-entrance depth.

Designing greenhouses and controlling the climate inside them, with the plastics and soilless systems that go with them.

Our 71 ICAR AICE-JRF/SRF questions in this subject: 8 easy, 40 medium, 23 hard, across 13 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to ICAR AICE-JRF/SRF and are not shown on any other exam's page.

Question 1 · hard

Which statement about structural design codes for commercial greenhouses (for example EN 13031-1 in Europe and IS 14462 in India) is correct?

  1. Codes ignore crop loads because plants hung on wires weigh far less than any snow load
  2. Codes set one fixed wind pressure for every greenhouse in a country, whatever the local wind climate or terrain
  3. Codes treat greenhouses as temporary sheds, so no anchorage calculation is required
  4. Codes allow film houses a shorter design life than permanent buildings, which lowers the design wind speed
Answer and working

D. Codes allow film houses a shorter design life than permanent buildings, which lowers the design wind speed

A shorter reference period for light film structures reduces the characteristic wind speed used in design. Crop loads from hanging vine crops are a named load case, wind pressure depends on the site's wind climate, and anchorage against uplift is a central check.

Question 2 · medium

What is the purpose of horizontal air-flow (HAF) fans hung in the canopy of a closed greenhouse?

  1. To stir the inside air so that temperature and humidity are even and leaves dry faster
  2. To replace exhaust fans by exchanging inside air with outside air during summer
  3. To pressurise the house so that insects cannot enter through gaps in the cover
  4. To push carbon dioxide out of the house so that the crop does not over-enrich
Answer and working

A. To stir the inside air so that temperature and humidity are even and leaves dry faster

HAF fans circulate air inside the house to remove warm and humid pockets and reduce disease; they do not exchange air with outside, so they cannot replace exhaust fans. They are not used to pressurise the house or to remove CO2.

Question 3 · medium

A 30% shade net and a 50% shade net are used together, one above the other. What is the combined shade?

  1. 80%
  2. 35%
  3. 15%
  4. 65%
Answer and working

D. 65%

Transmissions multiply: (1 − 0.3) × (1 − 0.5) = 0.35, so shade = 1 − 0.35 = 65%. Adding the ratings gives 80%; 35% is the light that passes, not the shade; 15% multiplies the shade fractions.

Question 4 · medium

Low tunnels of thin transparent film over hoops are used in cold winters to raise crops such as cucurbits ahead of the field season. How are they managed as days warm?

  1. They are sealed tighter each week with soil on the edges, because warming spring days call for more heat retention
  2. They are sprayed with black paint inside, so that the crop is shaded and kept dormant
  3. Holes are cut or the edges raised for ventilation, and the tunnels are removed when outside temperatures allow
  4. They are filled with fog from a high-pressure line, so that the crop stays humid
Answer and working

C. Holes are cut or the edges raised for ventilation, and the tunnels are removed when outside temperatures allow

Unventilated low tunnels overheat quickly in sunshine, so growers open them progressively and then take them off. Sealing, painting or fogging them would cause heat or disease damage.

Question 5 · easy

In the nutrient film technique (NFT), the roots of the crop

  1. hang in a closed chamber and are sprayed with a fine mist at short intervals
  2. sit in rafts floating on a deep tank of aerated solution that rarely moves
  3. lie in shallow sloping channels with a thin film of solution flowing past them
  4. grow in slabs of rockwool fed by drippers, with the drain run to waste
Answer and working

C. lie in shallow sloping channels with a thin film of solution flowing past them

NFT uses a thin, flowing film so that the upper root mat is in air and the lower part in solution. The misted chamber is aeroponics, the floating raft is deep-water culture, and dripper-fed slabs are substrate culture.

Question 6 · hard

Which soilless system gives the crop the most time to survive if the circulation pump fails on a hot day?

  1. Aeroponics, since roots in a misted chamber need no water for several days
  2. Deep-water floating-raft culture, since the large aerated tank buffers water and temperature
  3. Nutrient film technique, since the thin film of solution left in the channels keeps roots moist for a week
  4. Ebb-and-flow benches, since pots hold all the water a crop needs for weeks
Answer and working

B. Deep-water floating-raft culture, since the large aerated tank buffers water and temperature

A deep tank holds a large volume of solution around the roots, so plants survive a pump failure for much longer. Roots in aeroponics and NFT dry within minutes to hours, which is why those systems need back-up power and alarms.

Question 7 · medium

A 2,000 m² greenhouse has a crop water use of 5 mm/d and a drip application efficiency of 90%. There are 6,000 plants, each on one 1.6 L/h dripper. How long must the system run each day?

  1. 63 min
  2. 69 min
  3. 1.2 min
  4. 694 min
Answer and working

B. 69 min

Volume = 2,000 × 0.005 / 0.9 = 11.11 m³/d. Flow = 6,000 × 1.6 = 9,600 L/h = 9.6 m³/h. Time = 11.11 / 9.6 = 1.157 h = 69 min. 63 min ignores efficiency; 1.2 min is hours mislabelled as minutes; 694 min is a factor-of-ten slip.

Question 8 · easy

How is fruit set in greenhouse tomatoes usually ensured, since there is no wind to shake the flowers?

  1. By spraying the flowers with water at noon to wash pollen onto stigmas
  2. By removing all leaves so that light reaches the flowers and opens them
  3. By planting male tomato plants between the rows as a pollen source
  4. By bumblebee colonies in the house or by vibrating the flower trusses
Answer and working

D. By bumblebee colonies in the house or by vibrating the flower trusses

Tomato flowers self-pollinate when shaken; bumblebees buzz-pollinate them and electric vibrators do the same by hand. Water sprays, leaf removal and 'male plants' (tomato flowers are bisexual) do not achieve this.

Question 9 · medium

In a greenhouse integrated pest management programme, the parasitic wasp Encarsia formosa is released to control

  1. two-spotted spider mite
  2. greenhouse whitefly
  3. western flower thrips
  4. root-knot nematode
Answer and working

B. greenhouse whitefly

Encarsia formosa parasitises whitefly scales and is one of the oldest biological controls in greenhouses. Spider mite is controlled by the predatory mite Phytoseiulus persimilis; thrips and nematodes need other agents.

Question 10 · hard

A square farm pond is 30 m × 30 m at the top, 2.5 m deep, with side slopes of 2:1 (horizontal:vertical). What area of liner covers the bottom and the four sloping faces, before anchor trench and overlaps?

  1. 900 m²
  2. 650 m²
  3. 959 m²
  4. 1,459 m²
Answer and working

C. 959 m²

Bottom side = 30 − 2 × 2 × 2.5 = 20 m. Slant length = 2.5 × √(1 + 2²) = 5.590 m. Each face = (30 + 20)/2 × 5.590 = 139.8 m². Total = 400 + 4 × 139.8 = 959 m². 900 m² is the plan area at the top; 650 m² uses the vertical depth instead of the slant length; 1,459 m² uses the top instead of the bottom area.

A study plan for Protected Cultivation & Greenhouse Engineering in ICAR AICE-JRF/SRF

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (54% of the 71 questions): Hydroponics and aeroponics (9, 13%); Glazing and cladding materials (8, 11%); Plastics in agriculture: mulch and lining (8, 11%); Micro-irrigation and fertigation in greenhouses (7, 10%); CO2 enrichment (6, 8%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Automation of climate control (5, 7%); Greenhouse heat balance (5, 7%); Natural ventilation (5, 7%); Fan-pad and fogging cooling (4, 6%); Greenhouse heating (4, 6%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Shading (4, 6%); Forced ventilation (3, 4%); Greenhouse types and orientation (3, 4%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Leave time for the hard ones: Greenhouse heat balance (4 hard of 5), Natural ventilation (4 hard of 5), Hydroponics and aeroponics (4 hard of 9).

    Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.

  5. Bank the easy marks: Glazing and cladding materials (2 easy of 8); Hydroponics and aeroponics (2 easy of 9).

    Do these early in revision so they are fast on the day.

  6. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — ICAR AICE-JRF/SRF Protected Cultivation & Greenhouse Engineering

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.