LAISHA
Open Laisha

GATE Soil Science for Engineers: practice questions

GATE — Agricultural Engineering (AG) · India · IITs and IISc on rotation (2027: IIT Madras)

Original practice questions written to the published syllabus · not past papers
10worked here, free
41written to this exam in this subject
7syllabus units

About GATE

GATE — Agricultural Engineering (AG) is a postgraduate admission exam run by IITs and IISc on rotation (2027: IIT Madras), for candidates in India. Computer-based, 3 hours, 100 marks (15 General Aptitude + 85 technical: 25 one-mark and 30 two-mark questions). MCQ, MSQ and NAT; negative marking on MCQ only (−1/3 for one-mark, −2/3 for two-mark); no partial credit on MSQ. On-screen virtual calculator.

Source: gate2027.iitm.ac.in.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Soil Science for Engineers in GATE

Numerical answer items on soil-water-plant relations: gravimetric to volumetric water content, bulk density and porosity, available water and irrigation depth, infiltration equations (Kostiakov, Horton, Philip), Darcy's law and layered-soil conductivity, and SAR or gypsum requirement in the drainage and salinity part. Watch units and the dry-mass basis.

The soil an engineer tills, irrigates, drains and builds on: its physical, water and chemical properties.

Our 41 GATE questions in this subject: 12 easy, 14 medium, 15 hard, across 7 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to GATE and are not shown on any other exam's page.

Question 1 · easy

Under the USDA system, what are the particle-size limits of the silt fraction?

  1. 0.02 to 0.002 mm
  2. 0.075 to 0.002 mm
  3. 2.0 to 0.05 mm
  4. 0.05 to 0.002 mm
Answer and working

D. 0.05 to 0.002 mm

USDA silt is 0.05 to 0.002 mm. The ISSS (Atterberg) scale puts the sand-silt boundary at 0.02 mm, 2.0 to 0.05 mm is USDA sand, and 0.075 mm (the No. 200 sieve) is the boundary used in engineering classification systems.

Question 2 · easy

A cylindrical core 5.0 cm in diameter and 5.0 cm long contains 135 g of oven-dry soil. What is the bulk density?

  1. 0.34 g/cm³
  2. 1.38 g/cm³
  3. 2.65 g/cm³
  4. 1.08 g/cm³
Answer and working

B. 1.38 g/cm³

Volume = π × 2.5² × 5 = 98.2 cm³; ρb = 135/98.2 = 1.375 g/cm³. Using the diameter as the radius gives 0.34; treating the core as a 5 cm cube gives 1.08; 2.65 is the default particle density, not bulk density.

Question 3 · easy

A soil sample has a gravimetric water content of 22% and a bulk density of 1.45 g/cm³. What is its volumetric water content?

  1. 31.9%
  2. 15.2%
  3. 22.0%
  4. 58.3%
Answer and working

A. 31.9%

θ = w × ρb/ρw = 0.22 × 1.45 = 0.319, or 31.9%. Dividing by bulk density gives 15.2%, leaving it unconverted gives 22%, and multiplying by particle density instead of bulk density gives 58.3%.

Question 4 · hard

Water in soil is at a matric suction of 1,500 kPa. What is this suction expressed as pF?

  1. 1.2
  2. 4.2
  3. 3.2
  4. 2.2
Answer and working

B. 4.2

1,500 kPa = 1.5 × 10⁶ Pa ÷ (1,000 × 9.81) = 152.9 m = 15,291 cm of water; pF = log₁₀(cm) = 4.18, usually rounded to 4.2. log₁₀(1500) = 3.2 uses kPa, log₁₀(15) = 1.2 uses bar, and 2.2 uses metres instead of centimetres.

Question 5 · medium

A soil layer 60 cm thick has a volumetric water content of 0.25. What is the equivalent depth of water stored in it?

  1. 25 cm
  2. 15 cm
  3. 240 cm
  4. 2.4 cm
Answer and working

B. 15 cm

Equivalent depth = θ × depth = 0.25 × 60 cm = 15 cm. 25 cm treats the 0.25 as a depth; 2.4 cm divides 60 by 25; 240 cm divides the depth by θ instead of multiplying.

Question 6 · easy

Water flows through a saturated soil with a Darcy flux of 0.5 m/day. The effective porosity is 0.25. What is the average pore-water (seepage) velocity?

  1. 0.125 m/day
  2. 2.0 m/day
  3. 0.5 m/day
  4. 0.67 m/day
Answer and working

B. 2.0 m/day

Seepage velocity = q/ne = 0.5/0.25 = 2.0 m/day; water in the pores moves faster than the flux because it uses only the pore area. Multiplying gives 0.125; equating the two gives 0.5; dividing by 0.75 (the solid fraction) gives 0.67.

Question 7 · easy

Darcy's law is valid for flow in soils as long as the flow is:

  1. Turbulent, at high Reynolds number
  2. Supercritical, with Froude number above one
  3. Unsteady, with a moving free surface
  4. Laminar, at low Reynolds number
Answer and working

D. Laminar, at low Reynolds number

Darcy's law assumes viscous, laminar flow, which holds in nearly all soils (Reynolds number below roughly 1–10). It fails in turbulent flow through very coarse gravels. Froude number and supercritical flow are open-channel concepts.

Question 8 · easy

In Darcy's law, Q = K A (Δh/L). If the hydraulic gradient through a soil column is doubled while everything else stays the same, the discharge:

  1. Stays the same
  2. Doubles
  3. Quadruples
  4. Halves
Answer and working

B. Doubles

Discharge is directly proportional to the hydraulic gradient Δh/L, so doubling the gradient doubles Q. Halving and quadrupling assume inverse or square relations, and K, not Q, is the quantity unaffected by gradient.

Question 9 · medium

A soil's cumulative infiltration follows Kostiakov's equation I = 2.5 t^0.6, with I in cm and t in hours. What is the cumulative infiltration after 2 hours?

  1. 1.14 cm
  2. 3.00 cm
  3. 7.94 cm
  4. 3.79 cm
Answer and working

D. 3.79 cm

I = 2.5 × 2^0.6 = 2.5 × 1.516 = 3.79 cm. 3.00 multiplies instead of raising to a power; 1.14 is the infiltration rate (cm/h) at 2 h, a b t^(b−1); 7.94 uses 1/b as the exponent.

Question 10 · hard

Horton's equation for a soil has f0 = 8 cm/h, fc = 1 cm/h and k = 2 h⁻¹. What is the cumulative infiltration in the first hour?

  1. 4.03 cm
  2. 7.05 cm
  3. 4.50 cm
  4. 1.95 cm
Answer and working

A. 4.03 cm

F = fc t + ((f0 − fc)/k)(1 − e^(−kt)) = 1 + (7/2)(1 − 0.1353) = 4.03 cm. 1.95 is the rate at 1 hour; 7.05 forgets to divide by k; 4.50 averages the initial and final rates, which overestimates because the rate falls exponentially.

A study plan for Soil Science for Engineers in GATE

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (56% of the 41 questions): Infiltration (8, 20%); Soil water: field capacity, wilting point and available water (8, 20%); Hydraulic conductivity and Darcy's law (7, 17%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Bulk density, particle density and porosity (6, 15%); Soil texture and structure (6, 15%); Sodicity: SAR and ESP (4, 10%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Problem soils: saline, sodic and acid (2, 5%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Leave time for the hard ones: Problem soils: saline, sodic and acid (2 hard of 2), Infiltration (4 hard of 8), Sodicity: SAR and ESP (2 hard of 4).

    Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.

  5. Bank the easy marks: Bulk density, particle density and porosity (3 easy of 6); Sodicity: SAR and ESP (2 easy of 4).

    Do these early in revision so they are fast on the day.

  6. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — GATE Soil Science for Engineers

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.