LAISHA
Open Laisha

ASRB NET Groundwater, Wells & Pumps: practice questions

ASRB NET — Farm Machinery & Power / Land & Water Management Engineering / Agricultural Structures & Process Engineering · India · Agricultural Scientists Recruitment Board (ICAR)

Original practice questions written to the published syllabus · not past papers
9worked here, free
15written to this exam in this subject
12syllabus units

About ASRB NET

ASRB NET — Farm Machinery & Power / Land & Water Management Engineering / Agricultural Structures & Process Engineering is a specialist certification exam run by Agricultural Scientists Recruitment Board (ICAR), for candidates in India. NET: 150 MCQs, 150 marks, 2 hours, −1/3 per wrong answer, English/Hindi, PG level. Combined NET/ARS/SMS/STO recruitment runs prelims, mains and interview.

Official site: pw.live.

We have not been able to confirm these details against the exam body's own specification, so fees, dates and pass marks are left out on purpose. Check the current format, eligibility, fees and dates on the official site.

Groundwater, Wells & Pumps in ASRB NET

Aquifers, well hydraulics, well design and the pumps that lift the water — asked in some form in every GATE AG paper.

Our 15 ASRB NET questions in this subject: 0 easy, 6 medium, 9 hard, across 12 units.

9 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 9 were written to ASRB NET and are not shown on any other exam's page.

Question 1 · hard

A clay has a porosity of 0.45 while a medium sand has a porosity of 0.32, yet the sand is the far better aquifer. The best explanation is:

  1. Clay has a higher specific yield than sand, but its lower porosity limits how much water it can store
  2. Clay pores are larger than sand pores, so water drains out too quickly to be pumped from a well
  3. Clay holds most pore water against gravity, so its specific yield and conductivity are very low
  4. Porosity in clay is entirely secondary, formed by fractures, and is therefore unconnected to wells
Answer and working

C. Clay holds most pore water against gravity, so its specific yield and conductivity are very low

Fine pores hold water by surface tension and adsorption: specific retention is high and specific yield small, and the tiny pores give very low K. Porosity alone does not measure how much water an aquifer yields.

Question 2 · medium

An unconfined aquifer has an initial saturated thickness of 20 m. Observed drawdown in an observation well is 4.0 m. The Jacob-corrected drawdown for use in confined-aquifer equations is:

  1. 3.6 m
  2. 4.4 m
  3. 3.2 m
  4. 4.0 m
Answer and working

A. 3.6 m

s′ = s − s²/(2b) = 4.0 − 16/40 = 3.6 m. Adding the correction or dividing by b instead of 2b are the common slips.

Question 3 · hard

A step-drawdown test yields s_w = BQ + CQ² with B = 1.2 × 10⁻³ day/m² and C = 2.0 × 10⁻⁷ day²/m⁵. At Q = 2,000 m³/day, the well efficiency is:

  1. 25%
  2. 300%
  3. 75%
  4. 100%
Answer and working

C. 75%

Aquifer loss BQ = 2.4 m, well loss CQ² = 0.8 m, s_w = 3.2 m. Efficiency = BQ/s_w = 2.4/3.2 = 75%. 25% is the well-loss fraction; 300% is the ratio of the two losses.

Question 4 · hard

On a Cooper-Jacob plot for an observation well, the slope of drawdown against log time doubles part way through a test. The most likely cause is:

  1. A recharge boundary (such as a river)
  2. Leakage from an aquitard
  3. Onset of delayed yield from pore drainage
  4. An impermeable (barrier) boundary within the cone of depression
Answer and working

D. An impermeable (barrier) boundary within the cone of depression

When a barrier's influence arrives, an image pumping well adds an equal drawdown rate, doubling the semilog slope. Recharge boundaries and leakage flatten the curve; delayed yield also flattens it temporarily.

Question 5 · hard

In interpreting a VES, a thin conductive layer between two resistive layers can be resolved only in terms of its longitudinal conductance. This ambiguity is known as:

  1. The principle of suppression
  2. Archie's law
  3. The principle of equivalence
  4. The Dupuit assumption
Answer and working

C. The principle of equivalence

Equivalence: different thickness-resistivity pairs with the same h/ρ (conductive layer) or h×ρ (resistive layer) produce the same curve. Suppression refers to an intermediate-resistivity thin layer that does not show at all.

Question 6 · medium

Aquifer storage and recovery (ASR) refers to:

  1. Injecting water through a well in the wet season and recovering it from the same well in the dry season
  2. Recharging through spreading basins in the monsoon and pumping it back from separate, distant wells in summer
  3. Storing water in surface tanks lined with clay and releasing it to wells during the dry season
  4. Pumping groundwater into rivers to maintain flow
Answer and working

A. Injecting water through a well in the wet season and recovering it from the same well in the dry season

ASR uses one well for both injection and recovery; recharge wells without recovery, spreading basins and bank infiltration are other MAR methods.

Question 7 · medium

Geometrically similar pumps operating at corresponding (similar) points have:

  1. The same discharge
  2. The same specific speed
  3. The same shaft power
  4. The same head
Answer and working

B. The same specific speed

Specific speed combines N, Q and H so that it stays constant under similarity scaling; it characterises the impeller shape, not the size.

Question 8 · hard

A pump with Thoma cavitation coefficient σ = 0.12 operates at 40 m head. Atmospheric minus vapour pressure head is 10.1 m and suction losses are 0.5 m. Ignoring any safety margin, the maximum static suction lift is:

  1. 4.8 m
  2. 9.6 m
  3. 5.3 m
  4. 5.8 m
Answer and working

A. 4.8 m

NPSHr = σH = 0.12 × 40 = 4.8 m. Require 10.1 − z − 0.5 ≥ 4.8, so z ≤ 4.8 m. Ignoring NPSHr or the suction losses overstates the lift. 9.6 m ignores NPSHr; 5.3 m ignores the suction losses; 5.8 m adds the losses instead of subtracting them.

Question 9 · hard

Researchers have raised concern that subsidised off-grid solar pumps may accelerate groundwater depletion. The underlying reason is that:

  1. Solar pumps have a higher specific speed than grid-connected electric pumps, so they lift more water per unit
  2. PV panels reduce aquifer recharge by shading fields and cutting infiltration beneath the arrays
  3. Pumping has near-zero marginal cost once installed, so there is little incentive to limit extraction
  4. Solar pumps cannot be switched off
Answer and working

C. Pumping has near-zero marginal cost once installed, so there is little incentive to limit extraction

After capital cost, energy is free; without volumetric limits farmers may pump more. Grid-connected designs that pay for surplus power have been proposed partly to reward pumping less.

A study plan for Groundwater, Wells & Pumps in ASRB NET

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (47% of the 15 questions): Recharge estimation and artificial recharge (2, 13%); Specific speed and affinity laws (2, 13%); Unsteady flow: Theis and Cooper-Jacob (2, 13%); Aquifer types and properties: T, S and Sy (1, 7%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Darcy's law in aquifers (1, 7%); Groundwater exploration: resistivity (1, 7%); NPSH and cavitation (1, 7%); Pumping tests (1, 7%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Solar pumping (1, 7%); Steady flow to wells: Thiem and Dupuit (1, 7%); Well design: screen and gravel pack (1, 7%); Well interference (1, 7%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Leave time for the hard ones: Aquifer types and properties: T, S and Sy (1 hard of 1), Groundwater exploration: resistivity (1 hard of 1), NPSH and cavitation (1 hard of 1).

    Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.

  5. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — ASRB NET Groundwater, Wells & Pumps

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.