LAISHA
Open Laisha

ICAR AIEEA-PG Groundwater, Wells & Pumps: practice questions

ICAR AIEEA-PG — Agricultural Engineering & Technology (Major Subject Group 10) · India · National Testing Agency for ICAR

Original practice questions written to the published syllabus · not past papers
10worked here, free
70written to this exam in this subject
16syllabus units

About ICAR AIEEA-PG

ICAR AIEEA-PG — Agricultural Engineering & Technology (Major Subject Group 10) is a postgraduate admission exam run by National Testing Agency for ICAR, for candidates in India. Computer-based, 120 minutes, 120 MCQs, +4 / −1, English only (2026 bulletin). One paper for the whole subject group.

Source: icar.org.in.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Groundwater, Wells & Pumps in ICAR AIEEA-PG

Short MCQs across the whole subject: aquifer definitions, S and Sy ranges, Darcy validity, well-screen and gravel-pack rules, drilling methods, resistivity arrays, pump classification, NPSH, and simple power or specific-speed calculations.

Aquifers, well hydraulics, well design and the pumps that lift the water — asked in some form in every GATE AG paper.

Our 70 ICAR AIEEA-PG questions in this subject: 21 easy, 38 medium, 11 hard, across 16 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to ICAR AIEEA-PG and are not shown on any other exam's page.

Question 1 · easy

In Darcy's law, the hydraulic conductivity K has the dimensions of:

  1. Velocity (L T⁻¹)
  2. Area (L²)
  3. Dimensionless
  4. Discharge (L³ T⁻¹)
Answer and working

A. Velocity (L T⁻¹)

q = K i, and the gradient i is dimensionless, so K has the same dimensions as the Darcy flux — a velocity such as m/day. Intrinsic permeability k, not K, has dimensions of area.

Question 2 · hard

In an unconfined aquifer (K = 30 m/day), steady saturated thicknesses measured from the impermeable base are 22 m at 20 m from a pumped well and 24 m at 80 m. The discharge is:

  1. 272 m³/day
  2. 6,255 m³/day
  3. 12,509 m³/day
  4. 14,402 m³/day
Answer and working

B. 6,255 m³/day

Dupuit: Q = πK(h₂² − h₁²)/ln(r₂/r₁) = π × 30 × (576 − 484)/ln 4 = π × 30 × 92/1.3863 = 6,255 m³/day. Squaring the difference (2² = 4) gives 272; using 2π doubles the answer; log₁₀ inflates it by 2.303.

Question 3 · easy

The uniformity coefficient of a sand is defined as:

  1. D₁₀ / D₆₀
  2. D₅₀ / D₁₀
  3. D₆₀ / D₁₀
  4. D₉₀ / D₆₀
Answer and working

C. D₆₀ / D₁₀

Cu = D₆₀/D₁₀, where D₆₀ and D₁₀ are the sizes than which 60% and 10% of the sample by weight is finer. D₁₀ is the effective size.

Question 4 · easy

The drilling method most commonly used for water boreholes in hard crystalline rock such as granite is:

  1. Jetting (with a high-pressure water stream) from the surface
  2. Hand augering
  3. Air rotary with a down-the-hole (DTH) hammer
  4. Driven well points hammered into the rock
Answer and working

C. Air rotary with a down-the-hole (DTH) hammer

The DTH hammer delivers percussive blows at the bit, driven by compressed air, which also lifts cuttings; it is fast in hard rock. Jetting and augering only work in soft sediments.

Question 5 · medium

Which of the following is NOT a function of drilling fluid in direct rotary drilling?

  1. Cooling and lubricating the bit
  2. Lifting cuttings to the surface
  3. Stabilising the borehole wall with a filter cake
  4. Raising aquifer permeability
Answer and working

D. Raising aquifer permeability

Drilling fluid cools the bit, carries cuttings, supports the wall and suspends cuttings. Its filter cake actually reduces permeability near the hole, which is why development is needed.

Question 6 · hard

A centrifugal impeller of 300 mm outer diameter runs at 1,450 rpm. The whirl component of absolute velocity at outlet is 18 m/s and flow enters radially. The Euler (theoretical) head is:

  1. 410.0 m
  2. 41.8 m
  3. 20.9 m
  4. 52.9 m
Answer and working

B. 41.8 m

u₂ = πDN/60 = π × 0.3 × 1450/60 = 22.78 m/s. With radial entry H = u₂V_w2/g = 22.78 × 18/9.81 = 41.8 m. Forgetting g, dividing by 2g (or using the radius, which gives the same halving), or using u₂²/g (which assumes V_w2 = u₂) are the common errors.

Question 7 · easy

A pump with a very high specific speed is typically:

  1. A radial-flow (centrifugal) pump for high head and low flow
  2. A reciprocating pump
  3. An axial-flow (propeller) pump for high flow at low head
  4. A multistage borehole pump for deep wells
Answer and working

C. An axial-flow (propeller) pump for high flow at low head

High N_s corresponds to high flow and low head per stage — axial flow. Radial impellers have low N_s.

Question 8 · medium

A solar pump must deliver 50 m³ per day against a total head of 30 m. The daily hydraulic energy is about:

  1. 4.08 kWh
  2. 14.7 kWh
  3. 0.417 kWh
  4. 40.8 kWh
Answer and working

A. 4.08 kWh

E = ρgVH = 1000 × 9.81 × 50 × 30 J = 14.7 MJ = 14.7/3.6 = 4.08 kWh (equivalently V·H/367). Forgetting to divide by 3600 s/h gives 14.7; omitting g gives 0.42; 40.8 is a tenfold decimal slip.

Question 9 · medium

The main function of the maximum power point tracking (MPPT) controller in a solar pump is to:

  1. Store surplus energy in batteries
  2. Keep the pump running at a constant rated speed all day, whatever the sunlight level
  3. Track the sun across the sky by rotating the whole array on a motorised single-axis frame
  4. Continuously adjust voltage and current to draw maximum available power from the array
Answer and working

D. Continuously adjust voltage and current to draw maximum available power from the array

The PV I–V curve has one maximum power point that shifts with irradiance and temperature; MPPT adjusts the load (pump speed) to stay on it. Mechanical sun-tracking is a separate option.

Question 10 · easy

Most solar irrigation pumping systems store energy as:

  1. Electricity in lead-acid batteries
  2. Compressed air
  3. Water in a tank or reservoir rather than electricity in batteries
  4. Hydrogen gas
Answer and working

C. Water in a tank or reservoir rather than electricity in batteries

A tank is cheaper and longer-lived than batteries, and crops need a daily volume; so systems are designed for daily volume, not constant flow.

A study plan for Groundwater, Wells & Pumps in ICAR AIEEA-PG

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (46% of the 70 questions): Aquifer types and properties: T, S and Sy (6, 9%); Centrifugal pump characteristic curves (6, 9%); Darcy's law in aquifers (5, 7%); Pumping tests (5, 7%); Steady flow to wells: Thiem and Dupuit (5, 7%); Unsteady flow: Theis and Cooper-Jacob (5, 7%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Well design: screen and gravel pack (5, 7%); Well drilling and development (5, 7%); Classification of pumps (4, 6%); Groundwater exploration: resistivity (4, 6%); Specific speed and affinity laws (4, 6%); Well interference (4, 6%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: NPSH and cavitation (3, 4%); Pump selection and installation (3, 4%); Recharge estimation and artificial recharge (3, 4%); Solar pumping (3, 4%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Leave time for the hard ones: Steady flow to wells: Thiem and Dupuit (2 hard of 5), Centrifugal pump characteristic curves (2 hard of 6), Pump selection and installation (1 hard of 3).

    Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.

  5. Bank the easy marks: Aquifer types and properties: T, S and Sy (3 easy of 6); Classification of pumps (2 easy of 4).

    Do these early in revision so they are fast on the day.

  6. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — ICAR AIEEA-PG Groundwater, Wells & Pumps

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.