ICAR AICE-JRF/SRF (PhD) — Agricultural Engineering subjects 38–43 · India · National Testing Agency for ICAR
Original practice questions written to the published syllabus · not past papersICAR AICE-JRF/SRF (PhD) — Agricultural Engineering subjects 38–43 is a PhD, fellowship and lectureship exam run by National Testing Agency for ICAR, for candidates in India. LAN-based computer test, 2 hours, 120 MCQs: 20 Part A (general knowledge and reasoning), 50 Part B (core group), 50 Part C (specialisation); four options.
Source: icar.org.in.
Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.
PG-depth concepts: leaky and unconfined (delayed-yield) aquifer responses, image-well theory, step-drawdown analysis and well efficiency, equivalence in resistivity sounding, recharge estimation methods and their assumptions, managed aquifer recharge, and groundwater assessment frameworks.
Aquifers, well hydraulics, well design and the pumps that lift the water — asked in some form in every GATE AG paper.
Our 25 ICAR AICE-JRF/SRF questions in this subject: 3 easy, 11 medium, 11 hard, across 12 units.
Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.
These 10 were written to ICAR AICE-JRF/SRF and are not shown on any other exam's page.
The same sand column is tested with water at 10 °C and then at 30 °C. Compared with the first test, the second test gives:
D. Higher hydraulic conductivity, same intrinsic permeability
K = kρg/μ. Warm water has lower viscosity, so K rises; k depends only on pore geometry and is unchanged.
A long pumping test in an unconfined sand aquifer gives a log-log time-drawdown plot that rises, flattens for a period, then rises again. The most appropriate interpretation is:
A. Delayed yield from gravity drainage; use a Neuman-type solution, with Sy from late data
The S-shaped curve is the signature of delayed yield: early elastic release, a flat segment while pores begin draining, then late Theis-like behaviour with storativity equal to Sy. A recharge boundary would flatten permanently, not rise again.
In a leaky confined aquifer pumped at constant rate, the drawdown curve eventually flattens because:
A. Aquitard leakage increasingly balances pumping
Hantush-Jacob theory: head decline induces vertical leakage through the aquitard (controlled by B = √(Tb′/K′)), which can supply all the pumping and give steady state. The flattening can be mistaken for a recharge boundary.
A well is to be completed in a fine, very uniform sand (Cu ≈ 1.5). The most appropriate design approach is:
C. Install an artificial pack of uniform, rounded siliceous grains, with slots retaining most of the pack
Fine uniform sands cannot form a natural graded filter because there is no coarse fraction to retain. An artificial pack, graded by pack-aquifer ratio, with slot retaining most of the pack, stabilises the formation.
Annual rainfall is 800 mm with chloride 2 mg/L (including dry deposition). Groundwater chloride is 40 mg/L and there are no other chloride sources. By chloride mass balance the recharge is:
C. 40 mm/year
R = P × Cl_p/Cl_gw = 800 × 2/40 = 40 mm/year. Inverting the ratio gives 16,000 mm; the method fails if fertiliser, irrigation water or evaporites add chloride. 400 mm/year is a factor-of-ten slip.
A well pump works against a system with a large static lift and little friction. If its speed is reduced by 20% with a variable-frequency drive, the flow will:
B. Fall by far more than 20%, and may stop if shutoff head drops below the static lift
Affinity laws scale the pump curve (head ∝ N², so shutoff head falls 36%), but the operating point is where the scaled curve meets the flat, high system curve, so flow drops disproportionately. Q ∝ N applies only when the system curve passes through the origin.
A well pumps a confined aquifer 150 m from a fully penetrating stream that acts as a constant-head boundary. In image-well analysis, the boundary is replaced by:
D. An injection image well 300 m away, across the stream
A recharge boundary is modelled by an image well of opposite sign, recharging at the same rate, placed at the mirror point: 150 m beyond the stream, so 300 m from the real well. A pumping image well represents an impermeable barrier boundary. Placing the image on the stream line gives the wrong distance and would not hold zero drawdown along the boundary.
In a Wenner resistivity sounding with electrode spacing a = 10 m, the measured resistance V/I is 5 Ω. The apparent resistivity is:
D. 314 Ω·m
For the Wenner array ρa = 2πaR = 2π × 10 × 5 = 314 Ω·m. 50 Ω·m is aR. 157 Ω·m uses πaR. 100 Ω·m is 2aR without π. The geometric factor 2πa is specific to equal electrode spacing.
A centrifugal pump gives 20 m head at 1450 rpm. If the engine drive drops the speed to 1160 rpm, the head at the corresponding duty point becomes:
B. 12.8 m
Head scales with speed squared: 20 × (1160/1450)² = 20 × 0.64 = 12.8 m. 16.0 m scales head linearly, which is the rule for discharge. 10.2 m uses the cube, which is the rule for power. 20.0 m ignores the speed change.
A pump lifts water at 30 °C (vapour pressure head 0.43 m) from a sump 4.5 m below its eye, with 0.8 m of suction friction. With atmospheric head 10.1 m, the available NPSH is:
A. 4.37 m
NPSHa = 10.1 − 4.5 − 0.8 − 0.43 = 4.37 m. 5.17 m leaves out the friction loss. 4.80 m leaves out the vapour pressure. 14.97 m adds the suction lift as if the water were above the pump. If the pump's required NPSH exceeds 4.37 m, it will cavitate.
This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.
Read the manual chapters for these first and do every worked question you can find on them.
Aim for one sitting per unit, then mixed questions across them.
Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.
Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.
Do these early in revision so they are fast on the day.
Last updated · How Laisha writes and checks its pages · Report a mistake
US$10 a month · one price worldwide · cancel any time
| Free | Smarter | |
|---|---|---|
| Grow guides, pest pages, articles | Read all | Read all |
| Ask Laisha | 5 a day | Up to 1,000 a month |
| Exam practice | The sample on each page | Every question, timed papers |
| Crop calendar and pest alerts | — | For your own fields |
| Calculators and tools | — | All |
| Uploads and reports | — | 100 a month, real files |
An AI operating system for agriculture: free guides, manuals and tools written for every country.