LAISHA
Open Laisha

ICAR AIEEA-PG Post-Harvest Engineering of Cereals, Pulses & Oilseeds: practice questions

ICAR AIEEA-PG — Agricultural Engineering & Technology (Major Subject Group 10) · India · National Testing Agency for ICAR

Original practice questions written to the published syllabus · not past papers
10worked here, free
58written to this exam in this subject
15syllabus units

About ICAR AIEEA-PG

ICAR AIEEA-PG — Agricultural Engineering & Technology (Major Subject Group 10) is a postgraduate admission exam run by National Testing Agency for ICAR, for candidates in India. Computer-based, 120 minutes, 120 MCQs, +4 / −1, English only (2026 bulletin). One paper for the whole subject group.

Source: icar.org.in.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Post-Harvest Engineering of Cereals, Pulses & Oilseeds in ICAR AIEEA-PG

Unit VI (biological materials, processing, storage) tests definitions and standard relations: moisture bases, EMC and isotherms, psychrometric properties, dryer types, parboiling methods and effects, rice, wheat, pulse and oil milling flows, cleaning and grading machines, size-reduction laws and conveyors. Questions are single-answer MCQs with negative marking, so precise recall of which machine separates by which property matters.

Moisture, drying, parboiling, milling, cleaning, size reduction and conveying of grains, pulses and oilseeds.

Our 58 ICAR AIEEA-PG questions in this subject: 39 easy, 16 medium, 3 hard, across 15 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to ICAR AIEEA-PG and are not shown on any other exam's page.

Question 1 · easy

A sample of pulses holds 25% moisture on a dry basis. Its wet-basis moisture content is

  1. 20%
  2. 33.3%
  3. 18.8%
  4. 25%
Answer and working

A. 20%

M_wb = M_db/(1 + M_db) = 0.25/1.25 = 0.20, i.e. 20% wb. 33.3% comes from using M_db/(1 − M_db), the wrong direction of conversion. 18.8% multiplies by (1 − M_db) instead of dividing by (1 + M_db); 25% leaves the value unconverted.

Question 2 · easy

A capacitance-type grain moisture meter works mainly because

  1. wet grain has a higher bulk density
  2. water has a much higher dielectric constant than dry grain matter
  3. wet grain absorbs near-infrared light
  4. water conducts electricity far better than dry grain, so resistance falls
Answer and working

B. water has a much higher dielectric constant than dry grain matter

Capacitance meters measure the dielectric constant (permittivity) of the sample; water's permittivity is far higher than that of dry matter. Conduction is the principle of resistance meters, and NIR absorption is a different instrument.

Question 3 · easy

Compared with raw rice from the same paddy, parboiled rice usually gives

  1. higher head rice yield
  2. more brokens but a softer cooked texture
  3. lower head rice yield and more brokens
  4. the same head rice yield but whiter kernels
Answer and working

A. higher head rice yield

Gelatinised starch fills voids and heals cracks, hardening the kernel so it resists breakage in the mill. So parboiled rice gives fewer broken kernels than raw rice.

Question 4 · easy

Wheat is conditioned (tempered) with water before milling chiefly to

  1. reduce the protein content of the endosperm before flour is extracted
  2. gelatinise the starch
  3. kill stored-grain insects
  4. toughen the bran and mellow the endosperm so they separate cleanly
Answer and working

D. toughen the bran and mellow the endosperm so they separate cleanly

Toughened bran stays in large flakes and mellowed endosperm reduces easily with less energy. Conditioning does not gelatinise starch; that is parboiling.

Question 5 · easy

Dhal milling of pulses consists essentially of

  1. parboiling and polishing the whole seed
  2. grinding the seed into flour
  3. extracting oil from the cotyledons
  4. dehulling the seed and splitting it into cotyledons
Answer and working

D. dehulling the seed and splitting it into cotyledons

Dhal is the dehulled, usually split, cotyledon; flour and oil are different products.

Question 6 · easy

Commercial dhal recovery falls short of the theoretical yield mainly because

  1. moisture is lost during pretreatment
  2. the cotyledons are sold as seed
  3. the husk regrows on the cotyledons during storage and must be removed a second time
  4. abrasion removes cotyledon as powder and produces brokens along with the husk
Answer and working

D. abrasion removes cotyledon as powder and produces brokens along with the husk

Abrasive dehullers cannot remove husk without also removing some cotyledon, and splitting creates brokens. Moisture change during pretreatment is balanced out when yields are corrected to the same moisture.

Question 7 · easy

In solvent extraction of oilseeds, 'miscella' is

  1. the solution of oil in solvent leaving the extractor
  2. the solvent-free extracted meal
  3. the pressed cake before extraction
  4. the gums removed in degumming
Answer and working

A. the solution of oil in solvent leaving the extractor

Miscella is distilled to separate oil from solvent, which is condensed and reused. The meal goes to the desolventiser-toaster.

Question 8 · easy

An indented cylinder (trieur) separates particles mainly by

  1. surface colour
  2. specific gravity
  3. surface texture
  4. length
Answer and working

D. length

Short particles lodge in the indents and are lifted into a trough; long ones slide out. Density is exploited by gravity tables and texture by velvet rolls.

Question 9 · easy

A spiral separator separates seeds according to

  1. their length
  2. their colour
  3. their roundness and ability to roll
  4. their terminal velocity
Answer and working

C. their roundness and ability to roll

Round seeds roll fast down the inclined spiral and move outward; flat or angular ones stay on the inner flight.

Question 10 · easy

Which size-reduction law is generally considered most applicable to fine grinding?

  1. Rittinger's law
  2. Bond's law
  3. Stokes' law
  4. Kick's law
Answer and working

A. Rittinger's law

Rittinger relates energy to new surface area, which dominates in fine grinding. Kick fits coarse crushing; Bond lies between; Stokes' law concerns settling.

A study plan for Post-Harvest Engineering of Cereals, Pulses & Oilseeds in ICAR AIEEA-PG

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (48% of the 58 questions): Moisture content: wet and dry basis (7, 12%); Cleaning, grading and screening effectiveness (6, 10%); Paddy and rice milling: husking, whitening, polishing and yields (5, 9%); Parboiling and hydrothermal treatment (5, 9%); Psychrometry and properties of air (5, 9%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Wheat milling (5, 9%); Equilibrium moisture content and sorption isotherms (4, 7%); Drying theory: constant and falling rate periods (3, 5%); Grain dryers: bin, LSU, recirculating, fluidised-bed and solar (3, 5%); Oil expression and solvent extraction (3, 5%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Pulse milling (3, 5%); Seed processing (3, 5%); Size reduction: Rittinger, Kick and Bond laws (3, 5%); Conveying: belt, bucket, screw and pneumatic (2, 3%); Thin-layer drying models (1, 2%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Leave time for the hard ones: Size reduction: Rittinger, Kick and Bond laws (2 hard of 3), Wheat milling (1 hard of 5).

    Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.

  5. Bank the easy marks: Drying theory: constant and falling rate periods (3 easy of 3); Pulse milling (3 easy of 3).

    Do these early in revision so they are fast on the day.

  6. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — ICAR AIEEA-PG Post-Harvest Engineering of Cereals, Pulses & Oilseeds

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.