LAISHA
Open Laisha

ICAR AIEEA-PG Soil & Water Conservation Engineering: practice questions

ICAR AIEEA-PG — Agricultural Engineering & Technology (Major Subject Group 10) · India · National Testing Agency for ICAR

Original practice questions written to the published syllabus · not past papers
10worked here, free
61written to this exam in this subject
13syllabus units

About ICAR AIEEA-PG

ICAR AIEEA-PG — Agricultural Engineering & Technology (Major Subject Group 10) is a postgraduate admission exam run by National Testing Agency for ICAR, for candidates in India. Computer-based, 120 minutes, 120 MCQs, +4 / −1, English only (2026 bulletin). One paper for the whole subject group.

Source: icar.org.in.

Checked against the exam body's published information. Formats and fees change; confirm the current edition there before you book.

Soil & Water Conservation Engineering in ICAR AIEEA-PG

Unit VII single-answer MCQs: definitions (unit plot, EI30, SDR, retardance), which structure suits which site, standard formulas (HI = 100 VI/S, VI = 0.3(S/3 + 2), A = (2/3)TD), and quick calculations under +4/−1 marking.

Estimating erosion and designing the bunds, terraces, waterways, spillways, ponds and dams that control it.

Our 61 ICAR AIEEA-PG questions in this subject: 29 easy, 31 medium, 1 hard, across 13 units.

10 practice questions, worked

Choose an answer, then open the working. Each explanation says why the right answer is right and why the others are not.

These 10 were written to ICAR AIEEA-PG and are not shown on any other exam's page.

Question 1 · medium

Other factors being equal, which soil is usually the most erodible by water?

  1. A well-aggregated loam under permanent pasture
  2. A heavy clay soil with high organic matter and strong, water-stable aggregates
  3. A coarse sand with rapid infiltration
  4. A silty, very-fine-sand soil low in organic matter with weak structure
Answer and working

D. A silty, very-fine-sand soil low in organic matter with weak structure

Silt and very fine sand are easily detached and easily carried. Clays resist detachment through cohesion; coarse sands resist transport and absorb water quickly, so they produce little runoff.

Question 2 · easy

In US usage, a tillage and planting system counts as conservation tillage when, after planting, crop residue covers at least:

  1. 30% of the soil surface
  2. 50% of the soil surface
  3. 10% of the soil surface
  4. 75% of the soil surface
Answer and working

A. 30% of the soil surface

The accepted US definition is at least 30% residue cover after planting. No-till, strip-till, ridge-till and mulch-till usually qualify.

Question 3 · medium

Contour farming becomes less effective as slope steepness and slope length increase mainly because:

  1. rainfall erosivity increases on steep land
  2. runoff overtops the small tillage ridges and breaks through at low points
  3. crops cannot be planted across steep slopes
  4. the soil erodibility factor K rises with both slope steepness and slope length
Answer and working

B. runoff overtops the small tillage ridges and breaks through at low points

Contour ridges store only a little water. On long or steep slopes and in large storms, water overtops them, concentrates at low points and can cause rills. That is why AH 537 limits contouring to a maximum slope length and why the P value rises towards 1 on steep slopes.

Question 4 · easy

Surface mulch reduces water erosion primarily by:

  1. absorbing raindrop impact and slowing overland flow
  2. raising soil temperature to seal the surface
  3. lowering the rainfall erosivity factor R
  4. increasing the soil's clay content
Answer and working

A. absorbing raindrop impact and slowing overland flow

Mulch in contact with the soil protects it from splash detachment and increases hydraulic roughness, so runoff slows and carries less. It acts through C in the USLE; R is a climatic property and does not change.

Question 5 · easy

Graded bunds rather than contour bunds are preferred where:

  1. moisture conservation is the main objective
  2. the land slope is less than 0.5%
  3. rainfall is high or soils are slowly permeable, so impounded water would damage crops
  4. rainfall is low and soils are highly permeable, so that all runoff must be held on the field
Answer and working

C. rainfall is high or soils are slowly permeable, so impounded water would damage crops

Graded bunds drain excess runoff slowly along a small grade to a safe outlet. In low-rainfall areas with permeable soils, contour bunds that hold water for infiltration are preferred because moisture conservation matters most.

Question 6 · easy

Inward-sloping bench terraces are suited to:

  1. high-rainfall areas, where excess water must drain along the inner edge to a safe outlet
  2. slopes of less than 2%
  3. low-rainfall areas with deep permeable soils, where all rainfall must be held on the bench to soak in
  4. paddy fields that must hold standing water
Answer and working

A. high-rainfall areas, where excess water must drain along the inner edge to a safe outlet

Inward slope collects runoff at the toe of the riser above and leads it away, protecting the riser and the outer edge in heavy rain. Outward-sloping benches suit low rainfall; level benches suit paddy and moderate, well-distributed rain.

Question 7 · medium

A broad-base terrace built by moving soil downhill from the upper side only, forming a relatively deep channel, is called a:

  1. Nichols terrace
  2. puertorico terrace
  3. Mangum terrace
  4. conservation bench terrace
Answer and working

A. Nichols terrace

Nichols terraces take all soil from the upslope side. Mangum terraces take soil from both sides of the ridge. The conservation bench terrace is a runoff area plus a level storage bench.

Question 8 · easy

In a zoned earthen dam, the central core of clay serves mainly to:

  1. protect the upstream face from waves
  2. increase the dam's resistance to sliding
  3. drain water out of the downstream shell
  4. reduce seepage through the dam
Answer and working

D. reduce seepage through the dam

The impervious core controls seepage; the pervious shells provide weight and stability; riprap protects the upstream face.

Question 9 · easy

The mode of transport that usually moves the largest share of soil in wind erosion is:

  1. saltation
  2. suspension
  3. surface creep
  4. rolling of clods
Answer and working

A. saltation

Saltation (short hops of particles about 0.1–0.5 mm) usually accounts for roughly 50–75% of movement. Suspension carries fine dust far but is usually a smaller share by mass; creep is driven by saltation impacts.

Question 10 · medium

For the longest effective zone of protection against wind erosion, a windbreak should have:

  1. about 90% porosity
  2. zero porosity (a solid wall)
  3. moderate porosity, roughly 40–50%
  4. porosity only near the ground and a dense crown
Answer and working

C. moderate porosity, roughly 40–50%

A solid barrier gives strong reduction just behind it but produces turbulence and a short sheltered zone. A moderately porous barrier lets some air through, reducing turbulence and extending protection. Gaps near the ground cause jetting under the canopy.

A study plan for Soil & Water Conservation Engineering in ICAR AIEEA-PG

This plan follows where our questions actually fall, so the time goes where the marks are likely to be. It is our reading of the syllabus, not the exam body's weighting.

  1. First, the heavy units (49% of the 61 questions): Mechanics of water erosion (7, 11%); Soil loss estimation: USLE, RUSLE and MUSLE (7, 11%); Earthen dams: seepage and stability (6, 10%); Agronomic and biological conservation measures (5, 8%); Bench and broad-base terraces (5, 8%).

    Read the manual chapters for these first and do every worked question you can find on them.

  2. Then the middle band: Grassed waterways (5, 8%); Sediment yield (5, 8%); Wind erosion control and shelterbelts (5, 8%); Wind erosion mechanics (5, 8%); Contour and graded bunds (3, 5%).

    Aim for one sitting per unit, then mixed questions across them.

  3. Then the lighter units: Drop, drop-inlet and chute spillways (3, 5%); Gully control (3, 5%); Farm ponds (2, 3%).

    Learn the definitions, classifications and standard numbers; these units are more often recalled than worked.

  4. Leave time for the hard ones: Earthen dams: seepage and stability (1 hard of 6).

    Come back to these after a first pass, untimed, and read every explanation, including for the options you rejected.

  5. Bank the easy marks: Agronomic and biological conservation measures (4 easy of 5); Contour and graded bunds (2 easy of 3).

    Do these early in revision so they are fast on the day.

  6. Finish timed. Sit the subject as a timed set without notes, mark it, and send each wrong answer back to its unit above.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Unlock every question — ICAR AIEEA-PG Soil & Water Conservation Engineering

US$10 a month · one price worldwide · cancel any time

  • Every practice question in this subject, with full working
  • Timed exam papers and progress by unit
  • Ask Laisha to explain any answer — up to 1,000 questions a month
Free or Smarter
FreeSmarter
Grow guides, pest pages, articlesRead allRead all
Ask Laisha5 a dayUp to 1,000 a month
Exam practiceThe sample on each pageEvery question, timed papers
Crop calendar and pest alerts—For your own fields
Calculators and tools—All
Uploads and reports—100 a month, real files
10 days free for every new account, no card.